Question about 1984 Honda CBX 750 F

1 Answer

Hi cbx 750 cc 1984 running but left side of carbs top petrol comes out? of rubber pipe its ok on right side do u kn ow problem bike has been stod for year?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 3,567 Answers

Remove the float bowls on the left carbs then clean the carbs with spray carb cleaner. Pay special attention to the float needle. A bit of rust, gasket or other contaminant is preventing the float needle from shutting off the petrol. Please rate my answer.
hi cbx  750 cc - tombones49_136.gif

Posted on May 23, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Honda 750 cbx fe rattle from alternator


Probably a cam chain. There are two adjustments on some of those bikes. Not a simple task and needs to be done right. Get a manual.

Mar 22, 2014 | 1984 Honda CBX 750 F

1 Answer

Can you tell me if the generator pulse coils on my


they are generally a dry casing
may be a engine seal has gone

Oct 18, 2013 | 1984 Honda CBX 750 F

1 Answer

Problem with starting my bike


Sticking floats or worn float valve needles or incorrect float height, tap float bowls to see it overflow stops (sticky float), remove and clean float bowls and fuel inlet passage with carb cleaner and compressed air, check float valve for wear to the rubber tip. Reset float height by slightly bending the metal tab on the float to adjust the closing height of the valve measure from the carb bowl mating surface to the top of the float when fitted then re adjust 1mm at a time higher untill fuel doesnt over flow.

Jan 25, 2012 | 1989 Yamaha FZX 750

2 Answers

I need an repair manual for my honda cbx 750F 1984


Hi, you can get the repair manual to your 1984 Honda CBX 750 from Haynes manual, call Haynes Customer Service at 1-800-242-4637 (US Customers).

May 13, 2011 | 1984 Honda CBX 750 F

2 Answers

Where do i find the carbs ona 1994 ninja zx7r


The Carburetors (4 of them) are located at the rear of theengione cylinder barrels, in order to access/see them you must remove the bikes fairings.

Apr 24, 2011 | 1994 kawasaki ZXR 750

1 Answer

Can not locate oil pressure switch on 1984 honda cbx750f


on left side of engine, remove cover and the oil pressure switch is located under it on left side, you will also find the neutral switch just to the right of it

May 20, 2010 | 1989 Honda CBX 750 F

1 Answer

I have gsx 750. i have cleaned the carbs as they were leaking gas. After cleaning they are fine but at high revs the bike backfires. I have also installed Sankei mufflers for Honda vf 750. The engine runs...


you have two fults then,,,the poping back and running hot is because the engine is running on a very week fule to air mix due to the wrong pipes being fitted
this will burn a hole in the tops of your pistons in time so it would be wise to fix this fast, open up the mixture screws till its running right,,
the battery going flat is down to it not getting a charge, that could be a number of things,, fuse,,,rectifier,, generator,,or broken wires

Jan 18, 2010 | 1984 Suzuki GSX 750 ES

1 Answer

Engine will not start,carbs cleaned, but will not fire, no petrol


Check the carb diaphrams for any tears/pinholes? (They are on the top of the carbs) Have you reconnected the breather from the tank? Is fuel getting past fuel tap? Sometimes the vent in the fuel cap can get blocked with crud and create a vacuum which stops fuel flowing.

Mar 15, 2009 | 1993 kawasaki GT 750

1 Answer

The guy i bought this bike from was an idiot the hoses and vacume lines are messed up i need help with any diagrams help the lost.THANKS


Small bore pipe from inlet side of no 2 carb goes to the small bore pipe on the petrol tap (this is the vacume swich pipe)
Large bore reinforced pipe goes from the large pipe on the petrol tap to the (hidden and bugger to get at) connector that points up (on the airbox side) between no's 2 & 3 carbs on the airbox
A large bore pipe goes from the rear facing connector on top of the centre cover on top of the cam cover (located under the frame beneath the petrol tank) to the connectot on the air box (this is the breather pipe)
Ensure that all pipes are hole/split free, secured with clips and that each inlet mainfold rubber (between the carb and cylinder block) has it's vacume plug fitted (located at the bottom of each rubber)

Mar 11, 2009 | 1983 Suzuki Gs 550 L

Not finding what you are looking for?
1984 Honda CBX 750 F Logo

Related Topics:

244 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

74945 Answers

Gino Cussen
Gino Cussen

Level 2 Expert

216 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...