Question about 2003 Honda CBR 600 RR

1 Answer

The engine was to much compreshin when you try to crank the starter makes a funny sound and does not kick over but when you take off the the cover to thers no compreshen it spins

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert who has written 50 answers of more than 400 characters.


    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 185 Answers

There cannot be to much compression only weak battery charge battery or replace battery see what happens I not hundred percent but I would assume your cams have Auto de compression fitted to them so compression should never be the issue

Posted on May 22, 2011


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

When I turn the key the stater spins, but i does not turn the engine over.

Maybe problem with starter motor? It does two things, it kicks out the starter drive gear and spins. The flywheel usually has cover, remove the cover, try to see if starter drive gear engages the flywheel teeth, with key in the crank position.
Some of the national brand auto stores will test the starter for you. Sometimes, I take the starter off, lay it on the ground, hook up jumper cables properly from battery to starter motor. It should kick out the drive gear and spin, granted that is no load test. Intermittent issues can be a pain.
I just want to add, when working under a vehicle, safety is always your responsibility.

I just wanted to add, make sure battery has a full charge and battery connections all good.

Apr 21, 2016 | 2000 Chevrolet S-10

1 Answer

I ran over a rock with my craftman 650 lawn mower and it now makes a funny cranking noise when I try to start it I changed the fly wheel key and it still doesn't start.

When you try to start the engine pulling on the rope, is it easier or harder to pull to turn over the engine? If easier there is internal damage as below, if harder there is internal damage as below. That cranking or grinding sound could be the rope starter or the clutch of the rope start. So when you have the cover off of the flywheel pull on the rope and see if it makes the sound you are hearing and check the clutch that threaded onto the the crank holding the flywheel in place see that it turns in freely in the opposite direction of the engine running.

You may have bent the crank, take the spark plug out, put the mower on it's side with the carburetor on the up side and turn the mower blade by hand and see if you can tell if there is a wobble. While you have the spark plug out, look in the plug hole while turning over the engine to see of the piston is moving up and down. Another possible problem the cam gear could be broken and the valves not opening and closing in time with the crank.

Jan 16, 2015 | Garden

1 Answer

Have 2001 toyota camry 2.2 , stood without batery fr 2 months now it doent crank think immobeliser problem

First make sure the shifter is in park check if O.K. check the battery voltage Sounds like not enough voltage charge battery or change if too low , if O.K. check all wires from battery to starter.If O.K. try voltage at the starter if that reads o.k. check the starter solenoid if it cranks when jumping the solenoid change the solenoid if still nothing listen for a click if it clicks the starter is stuck. Tap & try again if still N/G & you have voltage change the starter.
Mr. Red

Dec 16, 2013 | Worldwide 2001 Toyota Camry 2.2L...

1 Answer

Engine stopped while driving will not start again, starter sounds funny

open ur driverside door and check ur fuses reel good. even check if the fuses have a grayish color coat on the prongs. these cars and the grand am had a problem with the windshield leekinf right by the fuse box and causing fuses not to work right even if they look good

Oct 06, 2012 | 2002 Chevrolet Cavalier

2 Answers

Car stopped and wont hit i can hear the fuel pump kicking in

How does the car sound when you crank the starter? Does it sound normal like you are getting compression, or does it sound very fast and quiet? Have someone crank the starter and check Is there any back-pressure coming out the exhaust tailpipe. If the engine cranks very quiet and it feels like nothing comes out the tailpipe, there is a good possibility the timing belt has broken. You can verify this by removing either the valve cover or the timing belt cover.

If this is not the case, you will have to move down the checklist of check for spark, check the distributor and ignition coil, make sure the distributor connections are secure, check that fuel is actually making it into the cylinders (remove a spark plug and crank, sniff for fuel smell in cylinder), check the vacuum system lines, and so on.

Good luck and let me know what you find.

Mar 24, 2010 | 1996 Nissan Altima

2 Answers

My drz 110 makes a ratcheting sound and wont turn over

the main shaft has broken and possibly the first gear and right engine case. Common problem.

Jan 06, 2010 | 2005 kawasaki KLX 110

1 Answer

Just bought my son a 1996 jeep cherokee. Today it

If the starter is getting proper voltage at main lead and trigger wire (with the key in "start") pull the starter. If it was making strange sounds likely there is something wrong with it. Check flywheel as well and make sure you can turn the engine by hand. If you aren't getting the proper voltage, check the battery, connections and starter relay (in power distribution center)

Dec 01, 2009 | 1996 Jeep Grand Cherokee

1 Answer

Cant start my 2004 80 ws raptor

buddy sounds like your piston rings have wore or broken strip the barrel off and replace rings making sure you put oil on them when you install

Sep 08, 2009 | 2004 Yamaha YZ 250 F

1 Answer

Cant start my 2004 80 ws raptor

Most likely, the head gasket is blown.
Check the compression on all cylinders that you can reach.
Compare results. If 2 adjacent cylinders have low compression, then that's the head with the blown gasket.

Hope this helps!

Sep 08, 2009 | 2004 Dodge Ram 1500

2 Answers

1999 Chevy Blazer 4WD wont start

Sounds like the bendix is stuck in the starter. When this happens, the starter energizes and turns, but the gear does not kick out to make contact with the flywheel. Have someone tap on the starter while cranking the engine.

Dec 25, 2008 | 1999 Chevrolet Blazer

Not finding what you are looking for?
2003 Honda CBR 600 RR Logo

128 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4821 Answers


Level 3 Expert

78936 Answers


Level 2 Expert

342 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides