Question about MV Agusta F4 1000 S 1-1 Motorcycles

1 Answer

I have a 2006 F4 1000+1. I removed the fuel tank to replace the battery. Now after repairing several items do to my lack of knowledge concerning this make and model I have reinstalled the fuel tank. When I turn the key on you can hear the fuel pump cycle but I am not getting any fuel to the injectors. When I had the fuel tank off I had set it upside down, did I cause another problem in doing this. Thank you, Russ

Posted by on

  • nathan goodings Aug 03, 2013

    did you solve your problem?



1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 105 Answers

You might have to clean filter on fuel pump inside tank or even water in fuel clean tank MOPAR KENNY

Posted on May 22, 2011


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

Find loc. of inline fuel filter

It is in the fuel tank with the pump. Requires tank removal to replace (about 4 hours!). Not a normal required item for this unit unless you have contaminated tank and fuel which would be bad news.

Feb 28, 2015 | 2006 Pontiac Torrent


How to Replace a Fuel Pump and Fuel Filter in a Cadillac

The Cadillac has an electric fuel pump, and you should check its fuses and relays and ensure you have fuel before inspecting the pump. If your vehicle still has difficulty getting fuel, you can clean or replace the fuel pump.

Things You'll Need:
Fuel pump kit
Fuel tank sending unit wrench
Torque wrench Replace the fuel pump is challenge.
1.Determine which fuel pump your Cadillac Escalade will need. This depends not only on the make and model, but also the engine size. Models built from 1998 to 2000 have a 5.7 L engine, 2002 to 2006 models may have a 5.3 L or 6.0 L engine and models built after 2006 have a 6.2 L engine.
2.Prepare your vehicle for fuel pump servicing. Disconnect the negative battery cable. Relieve the fuel system pressure, drain and disconnect the fuel tank.
3.Disconnect the fuel and evaporative emission lines from the fuel tank. Remove the fuel sender assembly and the seal with a fuel tank sending unit wrench, and pull the strainer off the fuel sender. Remove the fuel pump's electrical connector and its retaining clip from the fuel level sensor. Remove the fuel sensor's electrical connector from the fuel sensor in addition to its retaining clip.
4.Remove the fuel level sensor by squeezing the locking tangs and remove the fuel pressure sensor. Discard the old fuel tank seal and fuel strainer.
5.Install the new fuel pump using the items included in the kit and be to replace the fuel strainer and seal. Use a torque wrench to tighten the attaching bolts for the fuel tank strap to 30 ft. lbs.
The following is the instructions of replacing fuel filter:
The symptoms of a bad fuel filter include a loss in horse power, very sluggish acceleration and, in some cases, difficulty starting. Replacing the fuel filter is always the best policy because you can't reliably unclog a filter. In the Cadillac Escalade, 2002-2006, they replace easily. The 5.3L engine filter replaces in a different way. Manufacturers suggest replacement of fuel filter every 60,000 miles.
Replace the fuel filter is easy.
1.Locate the fuel filter. Normally this is on the passenger side wheel well or just inside the engine compartment. In the Cadillac Escalade, it mounts on the fuel tank and is integral with the fuel pump assembly. Before removal of the filter, disconnect the negative battery cable and relieve the pressure in the fuel system.
2.Lift the vehicle to gain access to the fuel pump assembly. Remove the threaded fittings from the filter and cap the fuel pipes to prevent contamination. Inspect the o-rings on the fuel pipes and replace if deteriorated.
3.Change the filter and reattach the fittings immediately. Tighten the fittings to 18 foot pounds. Remount to the clip and lower the vehicle. Reconnect the negative battery cable and start the ignition. To fill the filter and get gas to the ignition system, turn the ignition on for two seconds and then off for ten seconds. The vehicle should start after this.
4.Replace the fuel filter at the first opportunity. Filters are not serviceable items, they are disposable. Never rely on a clogged fuel filter for any length of time

on Sep 21, 2011 | 2004 Cadillac Escalade

1 Answer

Fuel pump replacement

For the 2000 Grand Am, the fuel pump is replaced by draining the fuel tank or having it as empty as possible....then (while on jacks) lower the fuel tank. Remove the harness and the tubes to the top of the sending unit. Remove the lock collar ring that holds the pump in place (sending unit is mounted to the side of the fuel pump) and lift out the pump assembly...tilting it slightly (it has fuel in it so watch for it to spill out) and slowly so as not to damage the float internally.
Installation is in reverse. Sounds easy but there is more to it because of the lack of space between the tank and the underside of the car...trying to disconnect these items.

Aug 19, 2013 | 2000 Pontiac Grand Am GT

1 Answer

How to remove bad gas from 2001 impala

Bad gas can cause several concerns depending on what's in it. If it's only a liquid type bad gas then it can be purged. If it has debris it's another story. With a liquid only concern, a scan tool can be used to turn on the fuel pump and pump out the fuel by removing the fuel line at the injector rail or fuel filter. The fuel is under pressure so please use safety glasses and relieve the pressure. If the fuel had debris in it, the tank should be removed and completely cleaned, the lines should be purged, the filter replaced and an injector flush performed which requires a special tool. Fill the tank with fresh gas after repairs and monitor engine performance. The fuel injectors have tiny orifices that spray the fuel and are subject to clogging. If there's any reason you can't give four thumbs up, please request more information. Thanks and good luck!

Apr 10, 2011 | 2001 Chevrolet Impala

1 Answer

How to replace fuel pump on 2006 kawasaki z750

Order the parts diagram/ book from ebay on CD, print out the pages. (repair manual). My friend says all you have to do is remove the gas tank and there it is. You unscrew a few parts. take i out. You have to Drain the gas into a bucket using a piece of silicon tubing (think of draining an aquarium as a kid).

Unplug/ remove the battery.

then you remove the fuel tank. There'll be residual fuel in the connecting lines, drain those too.

Unscrew the fuel pump.

Put the new one in.

I have to do the same thing, but am procrastinating.

wish there's someone else to do it for me. lol.

Mar 15, 2011 | 2006 kawasaki Z 750

1 Answer

I just replaced the battery. Car cranks but does not start. I dont think its the starter. what can it be?

Lotta things - first things to check are tune-up items: spark plugs, spark plug wires, air filter,
rebreather filter, oil filter, fuel filter, in-tank fuel strainer, ignition control module/distributor cap/rotor,
PCV valve

Most probable cause: lack of spark from the ignition system
2nd most probable cause: engine starved for fuel due to fuel system problem: fuel filter, fuel pump,
in-tank fuel pump or clogged in-tank fuel strainer.

Jan 16, 2011 | 1997 Mercury Villager

1 Answer

How do you get access to battery on 2006 kawasaki zx14

You heed to remove the front seat and fuel tank cover. The access cover for the battery is on the right side of the bike just beneath the fuel tank cover. There are 5 - 8mm bolts that must be removed to access the battery. Some people leave the top 8 mm bolt out when re-assembling so your dont have to remove the fuel tank cover next time.

Jan 02, 2011 | 2006 kawasaki ZX-14

2 Answers

2006 Chevy Trailblazer fuel level sensor

You have to drive your car up on metal ramps. Chock your wheel's, have your pressure relived, remove your negative battery terminal, have your fuel pumped out using drill powered pump or drive your vehicle to the reserve point. Loose your tank straps, and lower the tank. Unplug your electrical connectors and pull your tank out under vehicle so you can remove locking flange on top of the tank to remove fuel pump and sending unit out.Replace fuel level sending unit and reinstall it back.

Dec 30, 2009 | 2006 Chevrolet Trailblazer

2 Answers

How to change the fuel filter in fuel tank 2006 Buick Rendezvous 3.5L AWD Vin L?

3.4L & 3.5L Engines
  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Relieve fuel system pressure.
  3. Remove or disconnect the following:
    • Negative battery cable
    • Quick connect fittings at the inlet/outlet sides of the in-pipe fuel filter
    • Fuel filter mounting bracket nut
    • Fuel filter and drain any remaining fuel

The fuel filter is located on the frame rail near the tank—with 3.4L and 3.5L Engines

To install:
  1. Install or connect the following:
    • Fuel filter to the bracket
    • Fuel filter assembly to the side rail near the fuel tank. Torque the nut to 89 inch lbs. (10 Nm).
    • Inlet/outlet quick connectors to the fuel filter
    • Negative battery cable
  2. Start the vehicle and checks for leaks, repair if necessary.

Oct 11, 2009 | 2006 Buick Rendezvous

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

301 people viewed this question

Ask a Question

Usually answered in minutes!

Top MV Agusta Experts

phil cuzins
phil cuzins

Level 2 Expert

80 Answers


Level 1 Expert

12 Answers

adam bikedoc

Level 3 Expert

661 Answers

Are you a MV Agusta Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides