Question about 2008 Triumph Sprint ST

Open Question

Set the clock sprint st 1050 - 2008 Triumph Sprint ST

Posted by on

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
bobthebulldo
  • 67 Answers

SOURCE: Are the triumph 2001 sprint st 955 and 1050 rear shocks

yes as far as i know they are all interchangable as long as they are the same year

Posted on Oct 24, 2009

Ad
  • 440 Answers

SOURCE: I have a 2008 Triumph Sprint ST 1050. How do you

There are 2 nuts on the bar from footrest to gear-change, 1 has a right-hand thread & the other has a left-hand thread.
Undo them both then turn the bar to alter its length thereby raising & lowering the gear-change height

Ride safe
Bike-Doc
Please mark this as very helpful (if it has been!!)

Posted on May 03, 2010

darkwing7
  • 3 Answers

SOURCE: Can you help i have a triumph sprint 2007 mod st

check the starter relay next to the battery

Posted on Oct 02, 2010

darkwing7
  • 3 Answers

SOURCE: How to replace rear brake pads. Triumph St 1050

remove wheel, remove brake, use a screwdriver to spread the gap between the pads( to make room for the new pads to fit on the disk...do not do this with the new pads you will mess them up) remove the 2 allen screw pins that hold the pads in place . if you are worried take out your phone and snap a pic of everything before you go to the next step. when the pins come out there is a spring plate in the top. dont forget it when you put the new pads in. installation is just a reverse of what you just did. be sure to squeeze the lever a few times when you are done re installing the calliper on the disk and check your brake fluid level under the seat--next to the battery on the right side- yeah under the starter relay---that thing with the red wir attached and the plug and clear cover.

Posted on Oct 02, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Replacing the rear footpegs on a 2010 Sprint ST


Hi, Michael for this scenario you will need your service/owners manual if you can't find the best tool you ever bought for your Triumph, despair not, for a mere zero $0 you can download another one. For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
Sprint footpegs Where do find them
MFW Vario Footpeg Mounts for Triumph Sprint ST 1050 05 13 Sprint GT 10 12...
Triumph Sprint ST Service Manual
Hermys Tire Cycle Inc 2006 Triumph Sprint Genuine Motorcycle Parts in Port...
Triumph Sprint ST Owner Handbook Manual

Jun 13, 2017 | Triumph Sprint ST Motorcycles

1 Answer

Are there any specific handlebar riser's on the market for a 2008 Sprint ST 1050 which are worth buying?


Hi, Glenn the answer to this question is way above my pay grade and for this situation, I would call my local dealer or reputable shop's service/parts department and inquire about any possible quick fix, answers, or parts inquiry.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
Handlebar risers Triumph Sprint ST 955 01 04 Sprint ST 1050 05 Sprint RS...
Bar Riser Install on 2005 Sprint ST 1050
Triumph Sprint ST Service Manual
http://www.triumphestore.com/
Triumph Sprint ST Owner Handbook Manual

Apr 28, 2017 | 2008 Triumph Sprint ST

1 Answer

My 2011 Triumph Sprint GT wouldn't attempt to start yesterday.There is no reaction to start button and lights don't come on. ABS light flashes slowly.Battery has been charged and ridden weekly.


Hi, Tony and the usual suspects are:
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Discharged battery, needs to be 12.5 volts or better and be able to pass a load test if necessary.
4. Check the battery terminals for damage or corrosion check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
5. Tip over sensor needs a reset.
6. Faulty ignition switch.
7. Faulty starter button.
8. Faulty kickstand or clutch pull in switch/sensor.
9. Starter control circuit, relay, or solenoid faulty.
10. Main fuse or circuit breaker may be blown or faulty.
11. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have nice a day.
Sprint ST 1050 Cold Weather Starting Probs
https://www.reddit.com/r/Triumph/comments/4i5zdb/psa_dont_use_the_kill_switch_on_your_newer
http://www.triumphestore.com/Triumph_2013_SprintGT.html
Triumph Sprint ST Service Manual
Triumph Sprint ST Owner Handbook Manual

Jan 02, 2017 | 2012 Triumph Sprint GT

1 Answer

How do you remove the plastics from a 2012 triumph Sprint gt 1050cc


Hi, Darell for this scenario you will need your service, parts fiche, and owners manual if you can't find the best tool you ever bought for your Triumph, despair not, for a mere zero $0 you can download another one. For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
Sprint GT Fairing Removal
Triumph Sprint St 1050 nose cone removal
Triumph Sprint ST Service Manual
https://www.triumphestore.com/Triumph_2013_Sprint-GT.html
Triumph Sprint ST Owner Handbook Manual

May 07, 2015 | 2012 Triumph Sprint GT

1 Answer

I have a 2008 Triumph Sprint ST 1050. How do you adjust the foot gear change selector ?


There are 2 nuts on the bar from footrest to gear-change, 1 has a right-hand thread & the other has a left-hand thread.
Undo them both then turn the bar to alter its length thereby raising & lowering the gear-change height

Ride safe
Bike-Doc
Please mark this as very helpful (if it has been!!)

May 03, 2010 | 2008 Triumph Sprint ST

2 Answers

Are the triumph 2001 sprint st 955 and 1050 rear shocks interchangable? Thanks


yes as far as i know they are all interchangable as long as they are the same year

Oct 17, 2009 | 2001 Triumph Sprint ST

1 Answer

I need cam timing marks for my 2006 1050 st crank at T1 where does the arrows on the cams point?


we have no tech manuals as of yet for this bike, please check back in a few montrhs.

Oct 07, 2009 | 2000 Triumph Sprint ST

1 Answer

What oil and amount of oil suits the 1050 forks


its not that simple !
you need special tools & specific oil & measurements
Just get it done at the workshop as the damge you could do is BIG $$$$$

Jul 18, 2009 | 2007 Triumph Sprint ST

Not finding what you are looking for?
2008 Triumph Sprint ST Logo

Related Topics:

227 people viewed this question

Ask a Question

Usually answered in minutes!

Top Triumph Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a Triumph Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...