Question about 2002 Yamaha YZ 426 F

1 Answer

My 426 Yahama lost 4th and 5th gears. Got any ideas?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 2,926 Answers

It is most likely the shift mode fork for these two gears. It is most likely bent, therefor not allowing the gears to engage the final drive gears on the shaft. With that being said, the case will need to be split and inspected. Best case scenario would be the previously mentioned, worst case would be a defective shaft gear or gears.

Posted on May 17, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a zafira club 1.6 and I have no 5th gear I can enter 5th whilst driving without clutch and it still revs. If I run the car at 3500 revs in 4th im only doing 55 to 60 and I dont like the idea of it...


Possibly gear linkage slipped out of sync under car can.you get all other gears if not maybe more serious like the fifth gear synchromesh is broken in gearbox?

May 02, 2014 | Cars & Trucks

1 Answer

Lost 5th gear


sounds like you have a problem with your shift linkage check to insure you re installed linkage right make

Dec 05, 2013 | Nissan Cars & Trucks

1 Answer

Yamaha yzf 426 fifth gear miss fire


Hi, Buzaa and the usual suspects are:
1. Severely discharged or a damaged battery, should have 12.5 volts or better and be able to pass a load test if necessary.
2. Check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
3. Spark plugs in bad condition or partially fouled.
4. Spark plug cables in bad condition and leaking.
5. Spark plug gap too close or too wide.
6. Faulty ignition coil, module, and or sensor.
7. Loose, dirty, or corroded ignition module connector at crankcase.
8. Faulty CKP or CMP, MAP, ETS, ATS, TPS, O2 sensor.
9. Intake air leak.
10. Water, dirt, or rust in the fuel system, carburetor and/or filter.
11. Fuel tank vent system plugged or carburetor vent line closed off.
12. Vacuum line from intake manifold to fuel valve is broken, cracked, pinched, or missing.
13. Carburetor controls misadjusted.
14. Damaged carburetor.
15. Incorrect valve timing.
16. Weak or broken valve springs.
17. Damaged intake or exhaust valve.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have nice a day.
My 2001 Yz426 wont run right please help YZ 400 426 450
few questions about my new YZF 426 YZ 400 426 450
Yamaha YZ426F Owner Service Manual
OEM parts for Yamaha
Yamaha YZ450F Owner Manual Page 3

Sep 11, 2012 | 2002 Yamaha YZ 426 F

1 Answer

Yamaha yzf 426 fifth gear miss fire


Hi, Buzaa and the usual suspects are:
1. Severely discharged or a damaged battery, should have 12.5 volts or better and be able to pass a load test if necessary.
2. Check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
3. Spark plugs in bad condition or partially fouled.
4. Spark plug cables in bad condition and leaking.
5. Spark plug gap too close or too wide.
6. Faulty ignition coil, module, and or sensor.
7. Loose, dirty, or corroded ignition module connector at crankcase.
8. Faulty CKP or CMP, MAP, ETS, ATS, TPS, O2 sensor.
9. Intake air leak.
10. Water, dirt, or rust in the fuel system, carburetor and/or filter.
11. Fuel tank vent system plugged or carburetor vent line closed off.
12. Vacuum line from intake manifold to fuel valve is broken, cracked, pinched, or missing.
13. Carburetor controls misadjusted.
14. Damaged carburetor.
15. Incorrect valve timing.
16. Weak or broken valve springs.
17. Damaged intake or exhaust valve.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have nice a day.
Yamaha YZ450F Owner Manual Page 3
OEM parts for Yamaha
Yamaha YZ426F Owner Service Manual
few questions about my new YZF 426 YZ 400 426 450
My 2001 Yz426 wont run right please help YZ 400 426 450

Sep 11, 2012 | 2002 Yamaha YZ 426 F

1 Answer

2003 chevrolet cavalier, manual transmission lost 2nd, 4th and reverse but still has 1st, 3rd and 5th gears.


Sounds like one of the levers inside the transmission is either broken or otherwise disengaged. Remove the shifter to see if you can see any obvious reason.

Aug 25, 2012 | 2003 Chevrolet Cavalier

1 Answer

YAMAHA BLASTER-Only have gears 4th, 5th and neutral?


sounds like your going to have to split the casses to fix trany to me. sorry the same thing hapened to my 2001 blaster.

Jun 07, 2010 | 2003 Yamaha YZ 250

2 Answers

Why does my wr426 slip in 4th and fifth gear


maybe the gear in 4th is slide or it not function properly

May 14, 2010 | 2001 Yamaha WR 426 F

1 Answer

Truck has no fifth gear


not unless fifth seases to the baring's. but then it won't even go in to 4th or 5th. it's probably your sincro's that r bad between 4th and 5th.

Feb 04, 2010 | 1992 Chevrolet C1500

1 Answer

Only 3rd and 4th gears available - 1998 jetta


im not telling you what to do because it could be a bad transmission and an easy fix but I cant tell without looking at it , but if its a hard fix just go to a reliable junkyard and get another

Aug 11, 2009 | 1997 Volkswagen Jetta

Not finding what you are looking for?
2002 Yamaha YZ 426 F Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

dhnguyen

Level 2 Expert

281 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1144 Answers

Tony

Level 3 Expert

2600 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...