Turn signal fuses? My front turn signals are not working, the rear ones are flashing quickly. The bulbs are good in the front, which makes me think it might be a fuse issue. I cannot locate which fuse it is.

Make sure that all the bulbs are the correct ones and have a good ground.

If the front and rear bulbs flash fast also, replace the hazard switch or you could live with it. As they are working. If one doesn't work, check grounds. I just run a new ground, much easier than cutting open the harness to find the break.

replace the right rear bulb. the quick flashing indicates a bad bulb. it could be a wiring problem to the rear for the signal light that you will have to check out starting at the socket and working forward.

Depending on the make model and year, I would say you are talking about the front turn signal lamp. Thats why the signal flashes fast.
I would check the socket for power and ground next.

where did you get the flasher from? autozone? try to get another one from a good parts supplier. if not, check the bulbs themselves. if they are supposed to be a dual filiment bulb, and only a single filiment bulb is in there, it may not flash. try using the turn signals with the parking lights on. does this make a difference?

IF LEFT FRONT BLINKER NOT WORKING FRONT TURN SIGNAL BULB BURNED OUT.

The rear left turn signal bulb must be replaced immediatly before it melts the light socket, if it has'nt yet. Also please verify that the correct light bulb is being installed. because even though many bulbs look the same they are not identical. Installing the wrong bulb can be the begining of many, many problems in the particular circuit

I believe this car has a rear bulb that has two fillaments, one for side lights the other shared for braking and flash. sounds like a blown bulb or a bad ground connection. Check the bulb and the bulb holder and ground connection.
Turn signal blinking quickly generally indicates a blown bulb front or rear or bad connection.

make sure the bulb is grounded good . usually if the front one is lit and the signal is fast the rear bulb might be bad . turn on the side that is not working properly and take off the lense and wiggle the bulb. also you might have to gt under it and check for the ground for the bulb .. holler if ou need more Jerry

Are you sure you have a good ground at those bulbs ? Spray sockets good with cleaner or penetrating fluid, (WD-40 or similar) clean contacts at bottom and try to squeeze or pry outside of socket inward to help get better contact with side of bulbs and see if that helps. If 12 Volt test light confirms power to contact in socket, then I'd be looking for a bad ground. Careful not to touch side while checking contact at bottom of socket or you'll blow a fuse real quick.