Question about Harley Davidson FLSTF - FLSTFI Fat Boy Motorcycles

1 Answer

I have a 1994 Fatboy that the right turn signals front and rear stay on all the time. The left one works fine, but the right one stays on without blinking. The signals are factory with no after market lights anywhere.

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 195 Answers

Probably a bad Turn Signal Module located under your dash speedo...remove your dash and speedo then you will access to the module.....

Posted on May 14, 2011

  • gavin jones
    gavin jones May 26, 2014

    try some new bulbs in the right side, make sure wattage is the same as original or as gilles says its the turm module



1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Why would my turn signals stay on my 08 Street glide

You may have some bulbs with burned out filaments, Or the bulbs may not be in correctly. Pry off the lens cover with a dime and inspect the bulbs. Make sure they have two filaments. If one filament is broken, replace it with a new bulb. Bulb #1157

May 07, 2014 | Suzuki GSX-R 600 Motorcycles

1 Answer


try moving the wires around the socket or could be the flasher

Apr 24, 2014 | 1994 Chevrolet C1500

1 Answer

1994 fatboy brake light staying on

Hi Anonymous, your front brake lite switch button is probably not getting pushed back into the off position. Remove your right handelbar switch housing and push the plastic button in and out with your finger to see if the light goes off and on. If not disconnect the wires to your rear brake lite switch and check the front switch button again. If the button works then reinstall the switch housing and push it towards the master cylinder hard and hold it with one hand and retighten the screws with the other. If you hook up rear brake lite switch wires and the brake lite comes on replace the switch. For a wiring diagram for your turn signals go to: Good luck

Apr 13, 2014 | 1993 Harley Davidson FLSTF Fat boy

1 Answer

V star 1100 turn signals not flashing

not jarred just crossed check wiring diagram again

Jul 11, 2013 | Motorcycles

1 Answer

Rear turn signal does not work

If the indicators on the dash are staying lit all the time, it is because you likely have a bad ground to one of your running lights, causing the running lights to ground through the turn signal circuits. This is often caused by either a bad socket assembly at one of the bulbs or an incorrect bulb is installed in one of the sockets. You need to check FRONT and REAR lights to see which one is not working correctly. Also check the running lights and marker lights on BOTH sides of the vehicle. There will be SOMETHING that will not look the same from one side to the other if the left side is working correctly and the right side is not. Please keep in mind that you cannot use the right REAR turn signal without also using the right FRONT turn signal. The problem could be at EITHER end.

Dec 26, 2011 | 2001 Chevrolet Venture

1 Answer

Left turn signals don't work. It will only stay on, but it won't flash when I activate the left turn signal, yet the right side works just fine. I'm guessing it may be the relay, but where is the relay?

You need to replace one of the left side bulbs,front or rear.Without both bulbs working the circuit is not pulling enough amperage to make the flasher work.

Apr 26, 2010 | 1992 Chrysler Lebaron

1 Answer

Back right turn signal not working on 1994 buick century

I had the same problem. When I would remove the rear turn signal bulb from the housing it might work for a while, then stay on without blinking. Drove myself nuts trying to troubleshoot. Finally, the simple solution was changing the bulb.Apparently, the filament had a small breach and would work sometimes, but not all the time

Jun 27, 2009 | 1994 Buick LeSabre

1 Answer

Turn signal wont work

It's most likely the bulb that is burnt out.It could be front or rear on the same side.

Apr 03, 2009 | 1994 Lincoln Town Car

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

403 people viewed this question

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers


Level 3 Expert

4340 Answers


Level 3 Expert

76848 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides