Question about 1991 kawasaki ZXR 750

1 Answer

Hi I have a 1991 j1 750 but having a running problem, I had it stored for a couple of years and have now got it running again, but it won't run past 7500 rpm. it just stays there spluttering. I have changed plugs,coils,leads,(coils and leads were from a breakers) and had the carbs ultrasonic cleaned with no difference to the running. also change fuel relay as advised on another forum, I have noticed that when I rev up slowly it doesn't run smooth throught the revs. I have run out of ideas as to what it could be as before I stored it it was running fine. thanks Philip

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 747 Answers

Ultrasonic cleaning is only as good as the cleaner it's in, it might loosed the dirt, varnish or sediment but it's still there floating in the solution. Not only that if the solution has been used repeatedly then you will possibly get dirt from someone else problem deposited in yours. Ultrasonic cleaning may be a good thing but the carb still needs to be washed and rinsed in clean fluids.

Another thing did they strip the carb down to do this if not then they dislodged the partial but it's still trapped in the float chamber.

Further by not running smoothly through the rev's it sounds as if you have a fuel starve through out the range which could be improperly adjusted float heights.

I use to hate chasing these problems but solving the problem before it starts is the best way and that can be done with fuel stabilizer in the tank run the engine for a while and then run it dry of gas.

Best of luck with it

Posted on Apr 06, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1991 GMC jimmy. Run fine until I pulled


sounds like the fuel pump is bad. check the fuel pressure with a gage is should be 35lbs. if it still won`t start now have someone try to start it while you hit the fuel tank bottom with something if it starts the pump is no good.

Sep 09, 2014 | 1991 GMC S-15 Jimmy

1 Answer

My explorer won't start, It was dead, I charged the battery. got a clicking noise. the battery died again, charged it and let it sit for a couple hours, went to try again, didn't even have to...


if the batter has a drain the starter may be at fault the starter can drain a battery with out running i would unhook the battery cables then charge the battery then i would have the starter tested.

Sep 05, 2011 | 1991 Ford Explorer

1 Answer

Hi .....i recently bought a honda accord 1991 ex r .............it was running fine but all sundden one day its havd problems ........it would start up fine ........and driven for say 20 minutes then it...


These cars had two very common problems. #1 The pgmfi (main) relay has solder joints that go bad, I would repair or replace this first as they are not very expensive. It is likely your problem, if not, it will be one day so do it for maintenance if nothing else. # 2 is distributors. There are several components inside the distributor that can go bad, the easiest and cheapest solution in the long run is to just replace the whole thing with a new one (not rebuilt). Most aftermarket parts stores sell these fairly reasonably now.

Replace the relay. If that does not help, do the distributor. The ignition switches had problems as well, but they usually prevents starting...be ready for that one day as well.

Dec 16, 2010 | 1991 Honda Accord

1 Answer

1991 honda ACCORD WONT REV PAST 3500 RPM NO MATTER IF YOUR IN PARK OR DRIVE OR NEUTRAL BUT IF YOU SHUT IF OFF AND ON AGAIN IT RUNS FINE, i CHANGED FUEL FILTER, PLUGS AND AIR FILTER, AND i'M JUST CONFUSED...


the ignition control module may be going bad. call your local honda dealer with your vin # they had a recall on the control module for 91-93. they will tell you if yours was replaced already if not you can pick one up for $60 at autoparts store and it is located inside distributor

Jul 29, 2010 | 1991 Honda Accord

2 Answers

My 1991 ford f150 dies after 20 minutes and wont start again for another 20


Could be a bad coil. Sometimes when a 'bad' coil heats up it will fail to work properly. When it fails and shuts the vehicle off, this gives it time to cool back down and resume proper operation. Does it run at normal highway speed during that 20 minutes? If not then it could be a clogged fuel filter. A clogged fuel filter will let the vehicle run at idle but will starve the engine at higher rpm's.

Oct 09, 2009 | 1991 Ford F150

1 Answer

Pump turns on and off every couple of minute, need pump to run non-stop


contacts are bad if you can fis it you will have to go to either a granger store or ele motor store to get them,, make sure they are in in the right direction or it might be easier to change the pump to a new one

May 12, 2009 | Little Giant 5-ASP, 1/6 HP, 1200 GPH -...

1 Answer

Dies and wont restart. 1991 bmw 750il


You have a cam or crank sensor that has gone out.

May 01, 2009 | 1991 BMW 7 Series

1 Answer

1991 Skylark wont stay running


had one of those a couple years ago it turned out to be the crank position sensor its a 9 dollar part and is kinda difficult to get to and get off the engine without breaking it

Sep 21, 2008 | 1991 Buick Skylark

Not finding what you are looking for?
1991 kawasaki ZXR 750 Logo

277 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...