Question about 2008 Harley Davidson FLHX Street Glide

1 Answer

2008 Ultra Glide Classic ABS light is flashing. Will the cause a function that prevents the bike from starting untill corrected.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    One Above All:

    The expert with highest point at the last day of the past 12 weeks.

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

  • Harley Davidson Master
  • 48,679 Answers

Hi Gordon, for more information about your question please visit the website below. Good luck and have nice day.
Changed brake pads ABS light flashing Harley Davidson Forums
ABS light flashing Harley Davidson Forums HDTalking com
HarleyTechTalk

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Posted on Jun 11, 2015

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: cant find the battery

Under the tour pak on the rear fender is a screw which you have to remove then you can lift the seat out from the rear end. When replacing the battery wrap a thin strap of leather or canvas around the battery and this will allow you to lift the battery out a lot easier the next time.

Posted on Mar 06, 2009

  • 13 Answers

SOURCE: where are the fuses located on a 2005 ultra

Under the left side cover right below the seat.

Posted on Mar 22, 2009

  • 33 Answers

SOURCE: bike won`t start.

Your Crank Position Sensor, or Cam Position Sensor is likely to be the problem. If there is no signal from crank position sensor, bike will not fire the coil. ECM has no referance to position of motor. Making timing imposible.

Posted on May 30, 2009

  • 52 Answers

SOURCE: Where is the oil pan plug located on a 1999 Harley

No oil pan plug, it is a sump system. Just find the oil tank, drain it, change the filter.

Posted on Jun 09, 2009

  • 69 Answers

SOURCE: How do I change the front and rear brakes on a

Not too hard - Undo the two bolts on the caliper and then seperate the caliper and pull the old ones out. Insert the new ones and put the bolts back in to hold the caliper back together and then install them back on the bike with the two retaining bolts. Use a bit of lock tight (Blue) on the threads. Warning do not let anyone apply pressure on the brakes while you have them off the bike or you will have a mess and/or a problem.

Posted on Jun 21, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2013 Harley Davidson Trike Tri Glide Ultra Classic loss of throttle power


Hi, Patrick you might have an ETC sensor going south, for this scenario you will need your service manual that has all fastener torque specs and a wiring diagram on the back pages, parts fiche, and owners manual if you can not find the best tool you ever bought for your Harley, despair not, for a mere $15 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below and for more specific information or questions at no charge please feel free to contact me at xlch@mail.com. Good luck and have a wonderful day.
http://ridermagazine.com/2009/02/12/2008-h-d-electronic-throttle-control
Harley Davidson FLHTCUTG TRIKE Tri Glide Ultra Classic 2013 Download... $15
http://partsfinder.onlinemicrofiche.com/ronnies/showmodel.asp?make=hdmc
2013 Harley Davidson Tri Glide Ultra Classic Owner Manual
Instant Tech Relief To speak to me personally absolutely free

Mar 25, 2018 | 2013 Harley Davidson Trike Tri Glide Ultra...

1 Answer

Bike won't start. No voltage to fuel pump fuse on 2008 Ultra Classic Electra Glide. Have power on all other fuses. Any suggestions?


Get some good electrical cleaner spray displays that connection scrubber with alcohol, make sure the fuses good and try again pulled a plug-in out, even though you charge the battery make sure the battery has 12.67 V of starting juice. How was your battery may be needed. New battery

Sep 29, 2012 | 2008 Harley Davidson FLHTCU Ultra Classic...

1 Answer

Have a 2000 electric glide classic, no spark at the plugs after washing bike


The bike threw a code. My guess is a misfire code. I would check to make sure you didn't get water in the kill switch at the right handlebar control. Water in the run/off switch could short out the switch and cause the problem you are having.

Jun 16, 2012 | 2002 Harley Davidson FLHTCUI Electra Glide...

1 Answer

2008 harley ultra classic brake lights, turn signals and cruise control all stopped working


Hi Tufgwm4, 1992 and later Touring Models, fuel pump fuses and relays will be behind the right side panel, starter and ignition relays will be under the seat behind the battery, everything else will be behind the left side panel to access fuses pull back on the front two locking tabs and slide the cover up. Good luck and have nice day.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Apr 29, 2012 | 2008 Harley Davidson FLHTCU Ultra Classic...

1 Answer

2009 H-D Flhtc Electra alarm lights flash bike wont start


Hi Anonymous, you may need an alarm reset, for more information about your question please visit the websites below. Good luck and have nice day.
Set Change Override Transport Harley Security Alarm PIN Code No Key Fob...

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e


Apr 20, 2012 | 2009 Harley Davidson FLHTCU Ultra Classic...

1 Answer

2009 ultra classic ABS code reset


Hi Anonymous, for more information about your question please visit the websites below. Good luck and have nice day.
ABS light Twin Forum Harley Davidson Forums
ABS light Harley Davidson Forums
ABS light flashing Harley Davidson Forums HDTalking com

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Mar 07, 2012 | 2000 Harley Davidson FLHTCUI Electra Glide...

3 Answers

2005 ultra classic efi. Back fire thru throtle body during cold start up. Engine light comes on for about 1 sec. After bike gets warmed up runs fine.


This is caused by a lean run. Did you change pipes or the air filter to a hight flow filter? If so you would need to have the bikes ECM flashed to richen the air fuel ratio or instal a unit to do this yourself. A power commander is somethink most of the riders I know use. If none of these apply to you then you will need to check the bike for an intke leak as this can also cause a lean running engine

Jul 09, 2009 | 2000 Harley Davidson FLHTCUI Electra Glide...

Not finding what you are looking for?
2008 Harley Davidson FLHX Street Glide Logo

337 people viewed this question

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4995 Answers

Mike

Level 3 Expert

4350 Answers

yadayada
yadayada

Level 3 Expert

80637 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...