It runs on 6 v batt. how will i convert it 12 v

Make sure front panel is properly seated. Try press and hold power button for 10 seconds to effect a reset.

battery failing

u have boiled your battery dry either replace batt or pop top cover off there is 6 or 12 little rubber caps remove cap add distilled water till even with hole replace cap charge viola!

stabilitrac is from balljoints prob on tire rods of sway bar and altonator runs at 14v and batt runs 12. for it to be dropping to 12 you need to run to auto zone n they can check your alt. or while its runnind take your batt post off batt n if it keeps running your alt is good and if it dies out rite away alt has to be changed

Replace the battery.

i would double check all the grounds mice can reak havock on wires & jags need good grounds to run right kinda like a ford. try running an extra ground wire from batt to engine.

One way to solve the problem is to convert all the fractions so that they have the same common denominator, then just add them up.

12 1/6 = 73 / 6 = 292 / 24

2 3/8 = 19 / 8 = 57 / 24

7 2/3 = 23 / 3 = 184 / 24

19 3/4 = 79 / 4 = 474 / 24


Therefore:

(292 / 24) - (57 / 24) - (184 / 24) + (474 / 24) = 525 / 24 = 21 21/24 = 21 7/8

Therefore:

12 1/6 - 2 3/8 -7 2/3 + 19 3/4 = 21 7/8


Good luck, I hope that helps.

well code 12 is what it shows up first telling you it's running the test that is normal. if it reads code 12 and nothing else then that means everything is fine. well catalytic converters are expensive to buy i price checked one for you at auto zone its $147.99 with a 5yr warranty. good luck hope i helped

As batts get older they take longer to reach full charge.

There may be a problem with a cell or maybe or a bloc

Batts are made up of sets of cells which make up a bloc.

eg 6 cells = 12 V bloc

Most UPS units have more than 1 bloc inside.

Standard batts can last about 3- 5years, it all depends on use, temp, cost of ups, and type of batt.

Some ups units allow you to check the batts with sofware, 1 other thing you can do is... with the ups powered up and running,do a test by connecting a lamp to the ups and failing the supply, for a short time say 3mins this will test the batts can work on load.

Before you do this make sure your critical load is not powered up.

Hope this helps , let me know by voting, thanks for using FixYa.

Hi,
Remove the battery and then press the power button for 45 sec then refix the battery and check that the machine is turning on or not?
If the laptop is not working on AC alone then this is the issue with the converter which is there on the motherboard.