Question about Triumph Street triple Motorcycles

1 Answer

I HAVE A problem with no ignition , street triple R 2009, won,t start , just went dead at a petrol station, the key barrel was replaced in october on warranty , have no lights , battery is new , alarm works ,always perfectly maintained , turn key and Nothing ...advice /?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,654 Answers

At this stage and the info I have. I would check my fuses and breakers for the lights and ignition. You can also try to turn the key on and push start to see if it will fire. If this fails then you may have a bad ignition, or the guts to the switch have came loose and not resting in the correct positions for the barrel to do its job. Unfortunatly to me it sounds more like the key switch is not working correctly. time to call the people who fixed it the forst time and get a refund or have them fix this.

Posted on Apr 01, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Does the 1999 Echo have a body control module? Are the BCMs and ECUs the same unit or two separate units?


- Connect the pins 4 (CG) and 13 (TC) with a paper clip or automotive wire, keep open the driver's door and leave the ignition switch ON for 30 minutes.
- After 30 minutes, switch OFF the ignition, remove the jumper wire and start the engine.

Dec 01, 2012 | Toyota ECHO Cars & Trucks

1 Answer

2009 street glide won't crank


Hi Carl, you may need an alarm reset, and the usual suspects are:
1.Ignition/Light Key Switch not in IGNITION position.
2.Engine Stop switch in the OFF position.
3.Discharged battery, loose or corroded connections check negative cable at both ends. (solenoid chatters).
4. Bank Angle Sensor tripped and Ignition/Light Key Switch not cycled to Off and then back to on.
5. Starter control circuit, relay or solenoid faulty.
6. Electric starter shaft pinion gear not engaging or over-running clutch slipping.
7. Security alarm not disarming
For a prime suspect please visit website below and good Luck.
Set Change Override Transport Harley Security Alarm PIN Code No Key Fob...

Sep 12, 2012 | 2009 Harley Davidson FLHX Street Glide

1 Answer

2009 ford focus won't start


Your battery is most likely dead if your lights go out. Charge or change your battery, but your altenater maybe be bad. It recharges your battery, if it don't work your battery will die..

Aug 24, 2012 | 2009 Ford Focus

1 Answer

I need help! My battery went dead last week as my td5 has been parked up for a while, I removed the battery and charged it up then refitted it now I have issues with arm and starting process?.. When press...


Try disconnecting the battery, both terminals, then hold both terminals together to re-boot all ECU / central locking control units. If everything goes back to normal, great, if not the C/L control box is in the roof lining by the sunroof, VERY common to get water ingress. You can try cleaning up using IPA170 Isoprpanol Alcohol spray or replacing unit.
As for the ignition it sounds like the barrel is on it's way out.

Feb 19, 2012 | 2002 Land Rover Discovery Series II

1 Answer

Hi, I have a suzuki swift 2000 model, the key has snapped in the ignition, i have a used replacement ignition barrel and key. When fitted the engine turns over but won't start. I'm guessing th


This car has a chip key, you can't just put any old key in it it must be programmed to not turn on the security system and disable starting, which is what you have now, the system has locked you out.

Feb 10, 2012 | Suzuki Swift Cars & Trucks

3 Answers

2009 HHR won't start. Battery is good.


Is the security light on or blinking?If not then do you have power to the starter.You can check this with a test light.You should have power when you turn the key to start.The test light should light up.Should be the small wire.I believe it is purple in color.If the security light is on then you will have to get the codes to see what is causing the no start.Hope this helps.Good luck.

Dec 07, 2011 | 2009 Chevrolet HHR

1 Answer

2008 Triumph Street Triple won't start


Hi, Cbitt331 before testing any electrical component in the Starting System it is "IMPERATIVE" that you have a fully charged battery of 12.5 volts or more and be able to pass a proper "LOAD" test if necessary, you may have a preliminary reading of 12.5 volts or more but little or zero amperage, the battery is faulty and must be replaced. AGM type batteries fall into this scenario more so than lead acid batteries.
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Check the battery terminals for damage or corrosion check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter.
4. Bank angle sensor needs a reset or is faulty.
5. FOB battery low or dead.
6. Faulty ignition switch.
7. Faulty starter button.
8. Faulty kickstand, clutch, neutral safety switch.
9. Security alarm needs a reset.
10. Starter relay, solenoid, starter have failed or circuit wiring faulty.
11. Starter armature or field coils have failed.
12. Main fuse or circuit breaker may be blown or faulty.
13. The electric starter is working but starter clutch has failed.
14. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
ST3R won start HELP
What to do When Your Motorcycle Won Start
Triumph DAYTONA 675 Service Manual
http://www.triumphestore.com/
Triumph Daytona 675 Owner Handbook Manual

Jun 16, 2017 | 2008 Triumph Street triple

1 Answer

2007 triumph speed triple won't start. a while before it wouldnt start, it would periodically seem to drag while turning over. usually i could release the starter and push again and it was fine. that...


Hi, Suntaster66 and the usual suspects are:
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Discharged battery, needs to be 12.5 volts or better and be able to pass a "LOAD" test, your battery may show 12.5 volts but has little or zero amps and must be replaced.
4. Check the battery terminals for damage or corrosion check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter.
5. Bank angle sensor needs a reset or is faulty.
6. FOB battery low or dead.
7. Faulty ignition switch.
8. Faulty starter button.
9. Faulty kickstand or clutch pull in switch/sensor.
10. Security alarm needs a reset.
11. Starter relay, solenoid or wiring faulty.
12. Starter armature or field coils have failed.
13. Main fuse or circuit breaker may be blown or faulty.
14. The electric starter is working but starter clutch has failed.
15. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
http://www.triumphrat.net/speed-triple-forum/158495-2007-speed-triple-wont-start-seems-like-electrical-issue.html
What to do When Your Motorcycle Won Start
Triumph Speed Triple Service Manual
http://www.triumphestore.com/
Triumph Speed Triple User Manual

Mar 24, 2017 | 2007 Triumph Speed triple

2 Answers

How to get key out that is stuck in ignition


Remove steering column shroud(cover)and tap ignition barrel with small hammer while twisting key backwards and forwards,also turn steering wheel backwards and forwards sometimes this is enough to release key as the locking pins in barrel and the steering lock pin do sometimes jam.You will have to remove steering column shroud to replace ignition barrel if tapping/hitting it doesnt work anyway so its not a wasted effort.Good luck,let me know how it works out

Nov 12, 2008 | 2003 Oldsmobile Bravada

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

501 people viewed this question

Ask a Question

Usually answered in minutes!

Top Triumph Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you a Triumph Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...