Question about 2001 kawasaki ZX-6R Ninja

1 Answer

Would not idle will only run with the choke set

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 69 Answers

Check your carburetor..remove it and dismantle it and remove the main jet and the air jets and clean and air preasure it. assembly it back. and try..

Posted on Mar 30, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Only runs with choke on


Hi, Jeff and the usual suspects are:
1. Fuel cap or fuel tank is not venting properly.
2. Fuel filter clogged.
3. Fuel line pinched or kinked.
4. Float needle and seat sticking.
5. Float level too low.
6. Carburetor bowl vent line clogged/blocked/pinched.
7. Idle adjusting ***** set too low.
8. Air/fuel mixture ***** set too lean.
9. Idle port, transfer ports, slow air jet clogged.
10. Slow fuel jet clogged.
For more information about your issue and valuable "Free" downloads that you will need please Click on the links below. Good luck and have a nice day.
What could be wrong if bike will only run on choke
Only Runs When Choke is On
Bike only runs with choke on Intake Jetting Fuel Injection
Oakys Garage Carb clean Pilot Jet clogged Won run without Choke Carbs 101

Apr 05, 2016 | Red Motorcycles

1 Answer

Idles with 1/2 choke. If open choke, or throttle - engine dies without any RPM spike. Carb was cleaned, jet is clean. When idles, there is gas in the primer bulb.


Hi, Andrew and the usual suspects are:

1. Fuel cap or fuel tank is not venting properly.

2. Fuel filter clogged.

3. Fuel line pinched or kinked.

4. Float needle and seat sticking.

5. Float level too low.

6. Carburetor bowl vent line clogged/blocked/pinched.

7. Idle adjusting screw set too low.

8. Air/fuel mixture screw set too lean.

9. Idle port, transfer ports, slow air jet clogged.

10. Slow fuel jet clogged.

For more information about your issue and valuable free downloads that you will need please visit the websites below. Good luck and have a nice day.

Bike won Run without Choke

Dirt Rider Magazine

Bike starts up idles on choke dies with choke off our when warm XS650 Forum

What could be wrong if bike will only run on choke

Mar 10, 2016 | GAS Motorcycles

1 Answer

Will not stay running after choke closed


Hi, Anonymous and the usual suspects are:
1. Fuel cap or fuel tank is not venting properly.
2. Fuel filter clogged.
3. Fuel line pinched or kinked.
4. Float needle and seat sticking.
5. Float level too low.
6. Carburetor bowl vent line clogged/blocked/pinched.
7. Idle adjusting ***** set too low.
8. Air/fuel mixture ***** set too lean.
9. Idle port, transfer ports, slow air jet clogged.
10. Slow fuel jet clogged.
For more information about your issue and valuable "Free" downloads that you will need please Click on the links below Good luck and have a nice day.
Re Bike will not idle with out choke Road Star Forum Yamaha Road Star
Oakys Garage Carb clean Pilot Jet clogged Won run without Choke Carbs 101
http://www.yamahaventure.nl/pdf/servicemanualxvz13tf.pdf
OEM parts for Yamaha
http://www.yamahaventure.nl/pdf/ownersmanualxvz13tf.pdf

Apr 22, 2014 | 2007 Yamaha Royal Star Venture

1 Answer

When choke is off wont idle


Hi, Anonymous and the usual suspects are:
1. Fuel cap or fuel tank is not venting properly.
2. Fuel filter clogged.
3. Fuel line pinched or kinked.
4. Float needle and seat sticking.
5. Float level too low.
6. Carburetor bowl vent line clogged/blocked/pinched.
7. Idle adjusting screw set too low.
8. Air/fuel mixture screw set too lean.
9. Idle port, transfer ports, slow air jet clogged.
10. Slow fuel jet clogged.
11. Faulty fuel pump.
For more information about your issue and valuable "Free" downloads that you will need please Click on the links below. Good luck and have a nice day.
YZ426 won idle without choke Intake Jetting Fuel Injection
YZ426F Won Run Choke 4Strokes com
Yamaha YZ426F Owner Service Manual
OEM parts for Yamaha
Yamaha YZ450F Owner Manual Page 3

Jan 15, 2013 | 2001 Yamaha YZ 426 F

1 Answer

Motorcycle starts on full choke but will not run even given more fuel even if the choke is turned off after warm up


Hi, Edward and the usual suspects are:
1. Fuel cap or fuel tank is not venting properly.
2. Fuel filter clogged.
3. Fuel line pinched or kinked.
4. Float needle and seat sticking.
5. Float level too low.
6. Carburetor bowl vent line clogged/blocked/pinched.
7. Idle adjusting screw set too low.
8. Air/fuel mixture screw set too lean.
9. Idle port, transfer ports, slow air jet clogged.
10. Slow fuel jet clogged.
11. Faulty fuel pump.
For more information about your issue and valuable "Free" downloads that you will need please Click on the links below. Good luck and have a nice day.
Bike won Run without Choke
Yamaha XV535 runs only on idle choke
Yamaha XV 535 DX Virago Service Manual
OEM parts for Yamaha
http://www.starmotorcycles.com/assets/service/manuals/2005/LIT-11626-18-21_1000.pdf

Nov 13, 2011 | 1994 Yamaha XV 535 Virago DX

1 Answer

2006 Yamaha Road Star Silverado only runs with choke on


Hi, Bpioker and the usual suspects are:
1. Fuel cap or fuel tank is not venting properly.
2. Fuel filter clogged.
3. Fuel line pinched or kinked.
4. Vacuum line from the petcock to intake manifold cracked.
5. Float needle and seat sticking.
6. Float level too low.
7. Carburetor bowl vent line clogged/blocked/pinched.
8. Idle adjusting screw set too low.
9. Air/fuel mixture screw set too lean.
10. Idle port, transfer ports, slow air jet clogged.
11. Slow fuel jet clogged.
12. Faulty fuel pump.
For more information about your issue and valuable "Free" downloads that you will need please Click on the blue links below. Good luck and have a wonderful day.
Re Runs with choke out only Road Star Forum Yamaha Road Star
2004 Vstar idle only on full choke problem
Yamaha XV16AL Service Manual
OEM parts for Yamaha
YAMAHA XV1600A Owner Manual

Apr 20, 2011 | 2006 Yamaha Road Star Silverado

1 Answer

1980 Yamaha xt250 won't idle without the choke being on


Hi, Earthquakeau and the usual suspects are:
1. Fuel cap or fuel tank is not venting properly.
2. Fuel filter clogged.
3. Fuel line pinched or kinked.
4. Vacuum line from the petcock to intake manifold cracked.
5. Float needle and seat sticking.
6. Float level too low.
7. Carburetor bowl vent line clogged/blocked/pinched.
8. Idle adjusting screw set too low.
9. Air/fuel mixture screw set too lean.
10. Idle port, transfer ports, slow air jet clogged.
11. Slow fuel jet clogged.
12. Faulty fuel pump.
For more information about your issue and valuable "Free" downloads that you will need please Click on the blue links below. Good luck and have a wonderful day.
Older XT250 Won Run Some Choke
Bike won Run without Choke
Yamaha XT250X Service Manual
OEM parts for Yamaha
Yamaha XT250 Owner Manual

Feb 14, 2011 | 2008 Yamaha XT250

1 Answer

May mac 110 starts then it stops. I choke it it fires then i unchoke it and it starts and stops running.


Try backing the choke off about 1/2 way after it pops, and allow it to run for a few moments on that setting. Once the engine warms up, you can back the choke off completely. My Mac mini has no primer bulb, which means using the choke in a similar manner. Don't forget to set the 'fast idle' button on the throttle before starting (blipping the throttle will release the fast idle button). Hope this helps!

Sep 09, 2010 | McCulloch 16 Inch Gas Chain Saw MCC1635AK

1 Answer

Kawasaki Ninja 250 running problem


This could be due to timing screw being incorrectly set
Locate gold timing screw on the carbrettta turn it clockwise only slightly till bike idles without choke on, Then when choke it on it should idle a touch higher.

Jun 21, 2010 | 2008 kawasaki Ninja 250R

Not finding what you are looking for?
2001 kawasaki ZX-6R Ninja Logo

Related Topics:

87 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4535 Answers

yadayada
yadayada

Level 3 Expert

76649 Answers

bazzz7071
bazzz7071

Level 2 Expert

342 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...