WHERE CAN I GET A BELT PUT ON A HOOVER WIND TUNNEL IN sOUTH aTLANTA?

Question edited for clarity.
Question moved from Cars and Trucks.

Described as a 'fixable design flaw'.

https://www.google.com/search?q=Hoover+Wind+Tunnel+2+brush+roll+on%2Foff+pedal+not+working

..

There are some disassembly videos here, but basically you undo screws until you get to it. Lay everything out in the order it came apart and take pictures.

https://www.google.com/search?q=How+do+I+replace+a+Hoover+wind+tunnel+height+lever

..

Its usually located underneath the body of the unit, turn it upside down and you should see the beater brush. You need to open the bottom cover to get at the brush and drive belt.

It depends largely on the model. Do you know the model number? you can get any hoover replacement belt here:

Replacement Hoover Vacuum Belts

If you turn the vacuum over there will be (4) screws that hold on the base cover for the roller brush. Remove the screws and the cover and you can get to the belt(s). You can get replacement belts here:

Hoover Windtunnel Belts

Below I have listed a link to the manual which has instructions and a link to the V belt you need.

Windtunnel Manual

Windtunnel Replacement Belts

your belt number is correct ending in 035. I have had luck with belt number ending in 033 also.

Take off the bottom plate covering the brush roll, 4 screws. There are 2 belts, if you replace both, put the V belt on 1st, then stretch the flat belt over the motor shaft, then over the bigger pulley along side the V belt.

Take the brush belt and slip it over the pull into the groove. Then take the flat belt and hook onto the motor shaft and then pull belt over pull and push it around the entire pulley. It can be difficult but after the first time it is easy. You have to push the belt up with your thumbs so the belt will wrap all the way around

If this is new, you have a years warranty on it, take it for repair. Did you get the right belts, the numbers are 38528035 for the flat belt and 38528034 for the V belt. Also if you are catching something like a towel or area rug in the brush roll, it will knock of the belt. Is the brush roll turning freely. If not then it needs to be replaced, does it motor sound ok? If not then there is a problem with it.