Question about Harley Davidson FXDX Dyna Super Glide Sport Motorcycles

1 Answer

Will a gas tank from a 2005 1200 xlc fit onto a 2005 dyna? I know the mount will require some engineering, but will the tunnel fit over the dyna backbone?

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 4,565 Answers

I doubt it seriously as the Dyna frame has a square backbone. But, you'll never know for sure until you try.


Posted on Mar 28, 2011


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a dyna glo RMC 40 NGT vent less wall heater that I would like to convert to propane, I need to know which conversion kit to buy, and where. Thank you.

dyna glo natural gas heater Questions & Answers - Fixya > Forum > Tags
dyna glo ventless rmc50 ngt can this heater be changed from natural gas to propaneuse, ... Dyna Glo Natural Gas conversion to LP Gas I have a Dyna-Glo natural gas space ... Question about D-E36 Infra-Red Wall Mounted Panel Heater ... dyna glo heater model #RMC-40GT I believe on your particular model , that you ...

Parts for Dyna Glo, Thermoheat and Dyna Glo Pro Heaters
Shop Dyna Glo, Thermoheat, Dura Heat, Workhorse LP and oil fired htrs ... Circuit Board 2201181 Dyna Glo & Thermoheat 150k Nat Gas Htr RMC-FA150NGDGD ... This spark plug (ignitor) is used on Dyna Glo and Thermoheat 40K btu LP.

Propane Wall Heaters - > ... > Heaters

WalmartDyna-Glo IR18NMDG-1 18,000 BTU Natural Gas - Infrared Vent Free Wall Heater. $170. ... Dyna-Glo 40K Liquid Propane 360-Degree Tank Top Heater. $88.00 ... Dyna-Glo Deluxe RMC-FA125DGD Portable Gas Powered Forced Air Heater.

1352062 Dyna Glo Natural Gas conversion to LP Gas

Jan 12, 2016 | Heating & Cooling

1 Answer

Will a gas tank dyna wide glide 2003 fit to gas tank softail fat boy 2003

Hi Andrias, not without some type of mounting tab modification, the frames are different. For more information about your issue, please visit the websites below, and for specific information or questions, please feel free to contact me at Good luck and have a nice day.

Sep 09, 2015 | 2003 Harley Davidson FXDWG Dyna Wide Glide

1 Answer

How do I drain the gas from the tank of a 1998 Dyna Wide Glide?

disconnect hose at tanks petcock, replace with a longer hose to drain gas into gas can, turn petcock on & let it drain until empty

Jun 07, 2014 | 2000 Harley Davidson FXDWG Dyna Wide Glide

1 Answer

Where is the fuse for the air brakes in a toyota dyna 1995

Hi Ashwin, We have worked on several Dyna's but none with air brakes? If you're asking something about the servo assisted braking system, the only fuse I know of is for the brake lights. The braking system of the Dyna usually has vacuum operated servo assistance brakes. the vacuum pump is mounted onto the alternator, sometimes in front and sometimes behind, depending upon the year of manufacture and the engine in use. There is a pressure warning switch fitted to a reservoir tank to warn if there is a leakage and low pressure is not maintained. Operation sounds a buzzer inside the cabin. If this info is of no use please send a much more detailed question and the reason for searching the fuse? Regards John

Jun 07, 2014 | 2005 Chevrolet Malibu

1 Answer


Hi Robert, 4 out of 5 Harley Gods give this one a thumbs up, but just to be on the safe side contact your local dealers parts department for confirmation. Good luck

Jun 23, 2012 | Harley Davidson FXDWG Dyna Wide Glide...

1 Answer

Location of fuel pump& fuel filter

  1. Disconnect the negative battery cable. Relieve the fuel system pressure.
  2. Remove the push connect fittings at both ends of the fuel filter. This is accomplished by removing the hairpin clips from the fittings. Remove the hairpin clips by first bending and then breaking the shipping tabs on the clips. Then spread the 2 clip legs approximately 1?8 in. (3mm) to disengage the body and push the legs into the fitting. Pull on the triangular end of the clip and work it clear of the fitting.
  3. Remove the filter from the mounting bracket by loosening the worm gear mounting clamp enough to allow the filter to pass through. To install:
  4. Install the filter in the mounting bracket, ensuring that the flow direction arrow is pointing forward. Locate the fuel filter against the tab at the lower end of the bracket.
  5. Insert a new hairpin clip into any 2 adjacent openings on each push connect fitting, with the triangular portion of the clip pointing away from the fitting opening. Install the clip to fully engage the body of the fitting. This is indicated by the legs of the hairpin clip being locked on the outside of the fitting body. Apply a light coat of engine oil to the ends of the fuel filter and then push the fittings onto the ends of the fuel filter. When the fittings are engaged, a definite click will be heard. Pull on the fittings to ensure that they are fully engaged.
  6. Tighten the worm gear mounting clamp to 15-25 inch lbs. (1.7-2.8 Nm).
  7. Start the engine and check for leaks.
Fuel Pump requires dropping the gas tank to access.

Oct 09, 2010 | 1987 Mercury Sable

1 Answer

Will the gas tank and wheels and fenders off a 2004 fxd dyna glide fit a 2002 fxd dyna super glide.

I believe they could. Possibly not the fenders, but the tank, that's a probability. Check the mounts, and take some measurements of tank length on the bottom.

Oct 20, 2009 | 2004 Harley Davidson FXD - FXDI Dyna Super...

3 Answers

Gas leaking from tank

This sounds like you have a leak at the fuel pump and sender unit, either in the unit mount or in a fuel line. Check under your back seat for an access panel if you have one then remove it and look at the pump and sender mount to see what is leaking, you may have to start the engine to get it to leak as it may only leak under pressure, hope this helps, let me know

Sep 12, 2009 | 1993 Ford Escort 4 Door

1 Answer

Will a HARLEY DAVIDSON FXSTD tank fit a 883c

Cool idea, that's a great looking tank. I am not positively sure but I don't think this is going to be a bolt on part with no mods to the tank. The easy part may be the mounting brackets. You can have them relocated by an experienced welder using your existing tank as a guide. The big problem may be in the fitting. It may be too long to fit between your steering head and your seat and/or it may sit too low and rest on your rocker covers (the tunnel looks pretty high). I'd bet it's going to be impossible for you to put your hands on a tank to see if it will fit but you may be able to measure one. Get the length from front to back, from frame to top (at the front) and from the top of the tunnel to the bottom of the tank. If it will fit on your frame all you may need to do is a little welding.

Dec 10, 2008 | 2005 Harley Davidson XL 1200 C Sportster...

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

111 people viewed this question

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4898 Answers


Level 3 Expert

4349 Answers


Level 3 Expert

79851 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides