Question about 1996 Honda Hornet 250

2 Answers

Hi my honda hornet 250 has a problem i start riding after like 3/4 minutes it just dies then i leave it and its fine then does it again

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

What does the rpm meter show?it should be abt 0.2 rpm..if it isnt..under the carburator you will something like a screw/tap ..you have to rotate it to adjust the slow.that means the longer the engine should keep running on neutral or smething..hope it helps :)

Posted on Jul 29, 2012

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 133 Answers

Check to see if the gas is flowing good no blockages

Posted on Mar 26, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2009 Honda hornet runs for ten minutes then speed +rev counter, odometer and fuel gauge goes blank.


Hi, Alan if some or all of your instrument cluster goes dark/blank immediately upon startup or a few minutes later riding down the road the usual suspects are:
1. Blown instrument fuse.
2. A bad ground in the instrument circuit.
3. Faulty wiring before or after the fuse.
4. Faulty wiring or connector between the fuse and the instrument cluster.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
Cb600f 2003 2006 Service Repair Manual Download Manuals Technical
http://www.partsfish.com/page/oem-parts-for-honda
Honda CB600F Owner Manual
Honda CB600F Hornet 2009
Honda CB600F Wikipedia

Mar 07, 2017 | Honda CB 600 Hornet F Motorcycles

1 Answer

Honda Hornet keep blowing dash fuses


Check for a short in the wiring. Sounds like after bumping along on a ride an exposed wire grounds and blows the fuses.

Apr 13, 2015 | 2001 Honda CB 600 Hornet S

1 Answer

My Honda hornet starts fine but after Riding it for say 5 mins then it will die. Then it will start after 10 mins and run fine for another 5 an repeat. :(


theres a few things you can check

1. check the fuel filter
2. check the fuel lines ( no blockages )
3. clean the carb

Mar 26, 2011 | Honda Hornet 250 Motorcycles

1 Answer

2000 Hornet 250: what is the ideal tyre pressure in hornet 250...


NEVER the same pressure on both tyres !!
Usually, rear tyre is larger and/or carries more weight (you), therefore needs a much higher PSI. On a Hornet 250, 600 or 900cc it should be 36psi FRONT and 42psi REAR. - check the manuals.

May 16, 2010 | 2000 Honda Hornet 250

1 Answer

Can you restrict a honda hornet 250 enough to use it on a provisional license?its restricted to 33bhp at the minute.


To ride a bike on a provisional licence the bike must be a Max 125cc 11 kW (14.6 Bhp) You are NOT permitted to restrict an higher cc bike.

Feb 15, 2010 | 1999 Honda Hornet 250

1 Answer

Rough running 1988yahama 1300


Carburation is certainly faulty......., check teh plugs / wires and high tention coil while you are at the carbs.

Aug 26, 2009 | 1999 Honda Hornet 250

1 Answer

HondaCBR 250RR runs for 3 miutes fine then cuts out whilst riding


sounds like the float in the carb might be sticking stopping any more fuel getting through to the engine

Jun 23, 2009 | 1997 Honda CBR 250 RR

1 Answer

Engine timing, hornet 250


there is normally marks on the flywheel. sometimes 3 sometimes less. find the mark that makes the left piston sit at top dead centre on the compression strocke and it should be lined up correct. make sure that u are happy before u try starting otherwise it could end up very expensive.

Dec 09, 2008 | 2000 Honda Hornet 250

Not finding what you are looking for?
1996 Honda Hornet 250 Logo

Related Topics:

236 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75807 Answers

Mike

Level 3 Expert

4336 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...