Question about 2005 Suzuki Boulevard S83

Open Question

How do i remove the rear wheel on a 2005 s83 - 2005 Suzuki Boulevard S83

Posted by on

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

yvwi
  • 75 Answers

SOURCE: 2005 Suzuki Boulevard C50 rear wheel removal.

Jack the rear of the bike as high as you can safely get away with. The rear fender makes you require a lot of clearance to get the wheel clear of the bike.
Make note of the protrusion of the rear brake actuator rod and remove it from the actuator arm. Remove the bolt from the rear brake plate anchor arm.
Remove the plastic cover from the left side of the axle.
Remove the cotter pin from the axle end, then remove the nut by holding it with a wrench while turning the left end of the axle with a socket. You may need to tap the right end of the axle to start it moving out, and this is a tight area because of the pipes, but it should not take too much coercion. Once it begins to budge, you should be able to work it out from the left side. Remove the axle spacer.
While supporting the wheel ( I use my auto jack for this), wiggle the wheel until the drive unit splines disengage. You are now ready to work the wheel out from under the fender. There is a sleeve inside the drive end of the wheel, try not to let it pop out and get dirty. Don't forget to grease those drive splines when reinstalling, and to restore the brake rod to its former setting, unless you are adjusting it at the same time.

Posted on Nov 02, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I adjust the idle on my 2005 Suzuki vs1400


Thumb wheel type screw located in front of r/h frame cover. If carbs are in good working order screwing in should speed idle up.

Sep 25, 2014 | 2005 Suzuki Boulevard S83

1 Answer

Replace battery Suzuki S83 Boulevardt's your problem?


For what it's worth, the generator/stator went bad on my 2005 Suzuki Boulevard S83 and it is located under the left hand case cover. You can test it under the seat there is a plug with 3 yellow wires. Unplug it, start the bike, using a voltmeter, you should get at least 80 AC volts from the plug. That comes from the generator/stator, then it goes on to the regulator/rectifier which converts it to DC to charge the battery and run the bike.

Oct 16, 2012 | 2005 Suzuki Boulevard S83

1 Answer

How to adjust rear suspension


On the bottom of the rear shocks is an adjuster with 5 positions. 1 is the softest and 5 is the stiffest. Factory set is supposed to be 2. All you have to do is turn them.

May 27, 2012 | 2005 Suzuki Boulevard S83

1 Answer

What type of oil is recommended for a 2005 BLVRD S83


From my Owners Manual

Suzuki recommends the use of SUZUKI PERFORMANCE 4 MOTOR OIL or an oil which is rated SF or SG under the API service classification. The recommended viscosity is SAE 10W-40.

May 26, 2011 | 2005 Suzuki Boulevard S83

1 Answer

Should I open up the whole rear brake system to change the pads?


NO remove the caliper, remove the pad pin fit a screw driver in to the pads where the disk would sit and lever the piston back in...

Jun 29, 2010 | 2005 Suzuki Boulevard S83

1 Answer

How often should i change my rear gear oil inmy s83 motorcycle


it only needs to be changed if the unit is torn down for repair.

Jan 29, 2010 | 2005 Suzuki Boulevard S83

1 Answer

How do you remove and install a new fork lock?


YOU WILL NEED TO REMOVE THE TRIPLE TREE FROM THE FRAME TO ACCESS THE LOCK. ONCE YOU GET THE STEERING SHAFT REMOVED FROM THE FRAME YOU WILL SEE HOW TO REMOVE IT.

Oct 20, 2009 | 2005 Suzuki Boulevard S83

1 Answer

2005 suzuki bouevard s83 1400


try looking for the idle screw in the following place...
standing facing the side of the bike that has the clutch on it.
look in the area between the front cylinder and the rear cylinder, close to the tank.
the screw is black and can be difficult to see.
hope this helps.

Apr 04, 2009 | 2005 Suzuki Boulevard S83

Not finding what you are looking for?
2005 Suzuki Boulevard S83 Logo

Related Topics:

132 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Ed Nelson
Ed Nelson

Level 2 Expert

149 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...