Question about 1995 Yamaha FZR 600

1 Answer

Cleaning the carbs on a '96 fzr 600 that hasn't run in two years. Any advice? I'm no stranger to motorcycles or maintaining them but this is the first times i've tackled these carbs. I have removed them from the bike already.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An user who is expert in 3 categories / brands.

  • Yamaha Master
  • 1,508 Answers

Write note on where the air screws are adjusted before pulling them out.
If you see something you may confuse later take a photo, like vacumn hoses, overflow hoses, fuel hose.
The slides may look a little worn, this is usually not a problem, apart for obvious cracks, then its replace all four
dont touch the adjustable syncronizing screws, that lift all the slides together.
dont mix parts between carbs.
When putting them back on
Check the inlet rubbers and install them tight
Make certain the throttle snaps all the way back before starting the bike.
And of course work in a clean area, and remember its fuel and will burn when it can, so no ignition sources.

Posted on Mar 23, 2011

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

93 fzr 600 r

poor spark , low compression , carbs clogged up fuel tap not operating correctly.

Mar 18, 2014 | 1993 Yamaha FZR 600

1 Answer

94 yamaha fzr 1000 was running fine, went to start it an it would start run on choke but cut out as soon as the choke was closed, definetly getting petrol as far as the carbs an getting spark, wud the...

Hi, Anonymous and the usual suspects are:
1. Fuel cap or fuel tank is not venting properly.
2. Fuel filter clogged.
3. Fuel line pinched or kinked.
4. Float needle and seat sticking.
5. Float level too low.
6. Carburetor bowl vent line clogged/blocked/pinched.
7. Idle adjusting ***** set too low.
8. Air/fuel mixture ***** set too lean.
9. Idle port, transfer ports, slow air jet clogged.
10. Slow fuel jet clogged.
For more information about your issue and valuable free downloads that you will need please visit the websites below. Good luck and have a nice day.
FZR 600 post storage idle stall issue The FZR Forum
View topic FZR 600 carbs only runs with choke on Help
Exup1000 co uk Tech FZR1000R
OEM parts for Yamaha

Feb 26, 2013 | 1991 Yamaha FZR 600

1 Answer

1991 Yamaha FZR 600 carb

Hi, Anonymous for this situation I would call my local dealer or reputable shop's service/parts department and inquire about any possible quick fix, answers, or parts inquiry. If necessary, transport your bike to the dealer or shop and have a professional technician take it for a test drive, if it is in running condition, and give you a written estimate of repairs and answer any specific questions you may have about your problem. For more information about your issue and valuable "FREE" downloads that you will need please visit the websites below. Good luck and have a nice day.
carb cleaning The FZR Forum
step by step fzr600 carburetor rebuild
OEM parts for Yamaha

Feb 11, 2013 | 1992 Yamaha FZR 600

1 Answer

I have a 95 Yamaha fzr 600 where would I be able to find a power commander for the model of my bike

Power commanders are only for injected bikes...
1995 FZR 600 has 4 cvk34 carbs...therefore what you would need is a dynajet kit.

Apr 10, 2012 | 1995 Yamaha FZR 600

1 Answer

'96 fzr 600. Bile has not been started in two years. I have removed the carbs but before i clean them, any advice? I've removed the tank, and cleaned it already, now the carbs. I've been maintaining...

do one at a time use proper carb cleaner, lay the bits out carefull on a clean bench or table then you can rebuild it from the ones you have left together.

Mar 21, 2011 | 1995 Yamaha FZR 600

1 Answer


Hi, Jd sorry you can't find the first and best tool you ever bought for your Yamaha despair, not for a mere $10 you can download another one. For more information about your issue and valuable "FREE" downloads that you will need please click on the websites below. Good luck and have a nice day.
View topic cleaning and synchronize of carbs
Carb Sync Yamaha R6 Quick Look At How It Done
OEM parts for Yamaha

Mar 08, 2011 | 1992 Yamaha FZR 600

1 Answer

1991 fzr 600. bike sat for 3 years and i got it runnung but it will only run on choke. as soon as i try to take the choke off it dies. everything was cleaned out but still having a problem

As the bike was not used for years, the jets in the carb may be clogged or rusted. Please replace the jets. These jets can only be forced by choke to let fuel go and not otherwise. Changing them will rectify the problem.

Sep 09, 2010 | 1991 Yamaha FZR 600

2 Answers

Bike sat for awhile, runs but doesnt idle very good. cuts out

I would remove and clean the sparkplugs - sounds like one may be fouled.

Aug 18, 2009 | 1994 Yamaha FZR 600

Not finding what you are looking for?
1995 Yamaha FZR 600 Logo

216 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts


Level 2 Expert

281 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1144 Answers


Level 3 Expert

2600 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides