Question about 2006 Honda Xr 250

1 Answer

I have a 06 honda trx250ex put new gas and oil in it and plug and battery and iit turns over but wont start but when i put started fluid in where the plug goes it starts for like a second or so and quits can u helpe also i was woundering iv had the same fuse in it for years and have never changed it i mite tri that but dont know where it is located add?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,565 Answers

Your problem is a clogged carb. clean float valve, main jet and idle circuit with a can of spray carb cleaner.

disconnect fuel hose at carb and see if gas flows.

reconnect hose and open float bowl drain valve. If no gas tap on side of float bowl with plastic end of screwdirver to free up float.

still no gas? remove float bowl and try to shoot carb cleaner into the fitting for the gas line from tank.

if gas flows now then put it all back together and it should run

if not then remove carb and clean carb passages, main jet, idle circuit.

Posted on Mar 21, 2011

Testimonial: "ill do this tomorrow thanks sos so much for your help and time ill let you know how it goes k thanks again guy LATER!!!!!"

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Poured oil in the gas tank by mistake of Honda water pressure model GCV160. Drained the gas tank, changed spark plug, drained carburetor still will not start


Sounds like you have oil in the gas galleries of the carb. Fill it with gas turn gas valve on and try starting it a few times with starting fluid to help rince/thin them out so gas can flow through them again. It may smoke more than usual for a while. Dont keep it running on the starting fluid though as it has no lubrication for the cylinder/rings and could scar the cylinder walls. If that doesnt work you can remove it and try to do it manually with a can of carb cleaner or get a new carb. They're on ebay for about $20 or a small engine supllier near you will have one for about the same or a little higher.

Dec 24, 2013 | Honda GCV160 5.5HP 2300PSI GAS-POWERED...

2 Answers

I put 2 cycle gas in my 4 cycle Honda gcv190 pressure washer


did you pull the spark plug out and clean it ? if you did , did you also put the starter cord and turn the motor over without the plug installed to get rid of the 2-cycle oil out of the cylinder ? if not do so.

Jul 19, 2013 | Honda GCV190-N5AP 187cc GCV190 Series OHC...

1 Answer

Child put at lest one cup 4-stroke oil directly into gastank of 2001 Honda *** 49 cc scooter. Origianally started and emitted greyish exhaust; now does not start. Battery charged. Gas tank full. Advised...


You might get lucky with new spark plug(s) and I assume you mean 2-stroke oil. Otherwise, drain tank and replace any fuel filter in system, then re-try with fresh gas and new plug (s)

Aug 01, 2011 | Honda Dio Motorcycles

1 Answer

I have a 1991 Honda accord ex..it has been sitting for years now it wont start where should I start I was told that the gas turns to funk after sitting for a long time.


if it is posible for you to drain the the old gasoline out and refill the tank with fresh gasoline that would be great, but if you only have a1/4 tank and draining the tank is not posible fill your tank up with supreme gas not regular the better grade gas with the high octane will dilute the old gas and help burn off the gas when the car starts.if you have more then 1/2 a tank try to pump out the gas with a driil pump, you can buy these a your local hardware store insert hose in filler neck of the tank.you should also remove the spark plugs and with and oil can add 8 good pumps of the can of motor oil in the cylinders do not replace plugs **** with a freshly charged battery turn the engine over few time in 2 or 3 second intervals this will kleen any rust that would have built up on the cylinder walls and also lube up the cylinder wall so that at start up the cylinder wont be dry ,add a few more sqirts of oil between turnovers.Replace spark plug if old ones look bad put spark plug in and start her up its going to smoke a bit at firts **** it will stop after the oil that was put in the cylinders burns off,let the engine idle for 10-15 minutes before putting any strain on motor give it a chance to clean out cylinders burn a few tanks of gas and change gas filter it should be fine.

Apr 04, 2011 | 1991 Honda Accord

1 Answer

I can't start my honda lawnmower, checked the oil, put new gas use choke,it gives litle sound but not enough to start


Try a touch of starting fluid right into the carburator by taking the air filter off. If it then starts but wont run or stay running, the reservoir below the carb should be removed to clean at and the pinhole in the intake tube above the bowl nut. This is the most common problem with lawnmower start problems, the pinhole can be unplugged with one wire from a wire brush. Be careful with the gas, at least pinch off the gas hose with a vise grips while removing the carb bowl.. Never use a droplight around gasoline. most lawnmowers have no mixture adjustments, so it is a matter of cleaning the carb, tank, gas lines. Some oils in gas mix systems settle and clog after less than one season. Spark can be tested by sight, remove the plug and use a clip-on ground wire from spark plug body to metal on the engine with the plug wire connected.

Jun 10, 2010 | Honda Gxv160 55hp 55 Hp 25mm Dia Lawn...

2 Answers

2005 sportrax trx250ex wont start new battery getting gas and spark new plug 30 degree weather


do a compression check on it a motor has to have atleast 90 psi (law of physics) to even run might need rings or possible hole in the piston

Feb 06, 2010 | 2005 Honda CRF 250 R

1 Answer

Brand new Husqvarna R53SV 53cm Petrol Mower wont start. We put petrol and oil in it. Connected the spark plug put the choke to on, Pulled the starter string. Nothing happend. After trying a few times you...


Buy some starting fluid and spray some in the carb or air cleaner intake port, if the machine is flooding do not choke while using the starting fluid, make sure you do not have too much oil in the mowwer.

Jul 15, 2009 | Husqvarna 160 CC Honda OHC Engine 21 in

4 Answers

78 corvette that has not been started in 3


1.) put aside about $50 that you are ging to spend... period
2.) drain the oil and remove the old oil filter
3.) install a new oil filter, add new 30W oil
4.) remove all 8 spark plug wire from the 8 spark plugs
5.) remove the 8 spark plugs
6.) spray about 5 seconds of WD40 into each of 8 spark plug holes
7.) spray the remainder of the can into each of the 2 valve covers thru the EGR holes (pull out the EGR valve first)
8.) making certain that you have a full battery charge, turn the starter switch to START for about 5 seconds... if your engine turns then your internals are not frozen... that's good
9.) open another can of WD40 and spray equal amounts into ecah of 8 spark plug holes a second time
10.) turn the start switch on for another 5 seconds and listen for strange sounds... by the way without the spark plugs the engine will rotate more quickly than you normally expect... not a problem because as it turns it is lubricating your internal parts
11.) wait a minute and then turn it on for for about 10-20 seconds while listening for scraping or knocking sounds... if none heard then you are all lubed up and ready to reinstall the spark plugs.
Install new plugs or sandpaper the old with the correct gap ( I believe .035")
12.) if you didn't mark the plug wires not a problem... Google '78 Chevy Distributor Firing Order to find terminal #1 on the distributor cap... usually about the 1 o'clock position
13.) install #1 wire to #1 sparkplug... the driver's side front closest to the radiator
14.) the distributor rotates like a clock (clockwise) and the numbers on the clock starting at #1 is 1-8-4-3-6-5-7-2.... this is the firing order in a clockwise direction
15.) take the next plug wire #8 and connect it to #8 spark plug
Note: the spark plug numbers are cast into the top of the intake manifold for easier identification
16.) conect the remaining wires to their respective plugs
17.) make certain that you have a full battery charge, some gas in the tank (gas evaporates over 3 years) and a full radiator.
18.) Turn the starter switch and listen for the engine to start
19.) If it doesn't start the first time, try again and wait for the gas to reach the carburetor.... try again
20.) if it still doesn't start spray some engine strating fluid into the carbuetor throat and try again... it should start
21.) if it starts but doesn't keep running then repeat step 20. unitl the gas reaches the carburetor and continues to run on its own...!

Jun 23, 2009 | 1994 Chevrolet Corvette

2 Answers

Car wont cank over


check for spark at spark plugs, spray some carburator cleaner in the air filter housing then try to start the engine and watch oil pressure

Jan 03, 2009 | 1996 Ford Thunderbird LX

Not finding what you are looking for?
2006 Honda Xr 250 Logo

539 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75822 Answers

Mike

Level 3 Expert

4336 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...