Question about KTM 450 SX-F Motorcycles

1 Answer


Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 148 Answers

Make sure your air filter is clean,sounds like your carb needs a clean and adjustment

Posted on Mar 21, 2011


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Runs ruff and stalls then restarts hard with gas pedal all the way to floor 2005 chevy 2500 hd

Hi Check your idle air control motor, remove a vacume hose from the back side of the throtle body, the motor should run and not stall. good luck

Feb 02, 2014 | Chevrolet Cars & Trucks

1 Answer

What is carburetor setting on a2.3 chainsaw

There is no fixed carburetor setting on these engines, just two screws to adjust low-end and high-end operation. Special tool may be required, there are about a half-dozen screw head standards. Check eBay for tool. Get the engine to run and idle fast (idle adjust) so it doesn't stall, adjust low-end screw so that engine doesn't hesitate or sputter when accelerated. Adjust high-end screw to run fast and smooth on full throtle. Readjust idle to normal.

Oct 28, 2013 | Husqvarna Craftsman 36cc, 16 In. Gas Chain...

1 Answer

97 pathfinder shutoff when u step on the brakes hard, now when I start it

The first thing is to make sure the truck is running good. A misfiring truck would cause a low idle and stall.
If the truck runs good then look at the throtle body, a dirty throtle plate will cause a stall and lower than normal idle. If its dirty use a tooth brush and some throtle body cleaner to clean plate. make sure to open the throtle plate by stepping on gas pedal or by hand where the gas pedal cable connects to throle body.

I would check the throtle plate first, also make sure air filter is good.

If all is clean, (plate) and engine is running smooth and no check engine light is on then i would check the idle air control valve.


Mar 03, 2012 | Car Audio & Video

2 Answers

Why dose the car stall out when it starts an to keep it runing i have to keep on the gas?

sounds like a possible exhaust system blockage. if the engine cant breath it wont want to run

Jul 26, 2011 | 1999 Oldsmobile Intrigue

1 Answer

Tac doesnt follow the rpms of the motor all the time just when on

replace the fuel filter on the firewall passenger side

Apr 07, 2010 | 1992 Honda Accord

1 Answer

Pontiac G6 2005 - starts then stalls immediately

Chage the throtle possition senser.

Jul 03, 2009 | 2005 Pontiac G6

1 Answer

TPS Sensor bad? Car idle jerks when A/C on only

it seem our idle air control is dirty when compressor kick in idle air race up get stuck and all of a sudden come off and and on again that why you fell the idle goes up and down remove plastic cover on top of throttle body buy a can off air intake cleaner start the engine and stray the air intake cleaner inside the throttle body give gas at the same time because engine will whant to stall spra inside untill very clean try it out if engine stall dont worry go inside floor the gas pedal and it will start again it gonna shake its normal hope it5 help you fixya our post thanks pierre if any question dont hesitate

Jul 18, 2008 | 1995 Honda Civic

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

242 people viewed this question

Ask a Question

Usually answered in minutes!

Top KTM Experts


Level 3 Expert

80417 Answers


Level 2 Expert

342 Answers

Steve Banks

Level 2 Expert

232 Answers

Are you a KTM Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides