Question about 2007 Honda CBF 500

Open Question

Hi have just bought a 2008 cbf500a6 5536 miles on clock when driving there is a rough noise from gearbox engine area ,noise only when moving plenty oil in engine ,engine not noisy tried spinning wheels no noise from them ?

Posted by on

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
jwassilyn
  • 17 Answers

SOURCE: 2008 Honda CB250 engine ticking when after it ran out of oil

new engines burn oil until the rings wear in, if you were riding it hard and never noticed oil gone , possible damage. i would top up oil and keep and eye. if its still under warranty i would suggest dealer look at it

Posted on Sep 09, 2009

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Whine in 6th gear at 60mph which increase in pitch as speed rises


Yes I would be worried that a dealer would blame a gearbox ratio whine on the engine
What you could do is check the model forums to see if anyone else has the same problem also visit a couple of independent mechanics to ask them what they think
What sort of warranty do you have with that dealer as he may be trying to run the clock down on the terms covering the gearbox

Jan 16, 2016 | Cars & Trucks

1 Answer

Engine runs rough


I drive a 2008 VE SSV 6LT Commodore Sports Wagon
I have current issue with Engine runs rough, Engine light ON. Traction Control Off
I have checked, plugs and leads which were replace September 2013 and swapped them also with identical car to no resolve

Jan 08, 2014 | 1999 Mercedes-Benz M-Class

1 Answer

Front Suspension noise


From your description,I suspect worn tie rod ends.The tie rods connect the steering gear to the wheels.grasp the tire rod while you or an asistant shakes the wheel from 3 o'clock to 9 o'clock to pin point where it's loose. could be inner or outer ends or both.

Jan 24, 2013 | 2008 Honda Civic 1.8

2 Answers

Toyota Celica ST202 (M) 1996. gearbox/clutch problem


It is the release bearing, you should get it replaced quickly otherwise it might damage the plate.

Apr 12, 2010 | 1994 Toyota Celica

1 Answer

Gearbox crunching in Drive and car will nnot drive


EITHER THE TAIL SHAFT IS FALLING OF OR THE TRANS IS STUFFED

Aug 31, 2009 | 2002 Land Rover Range Rover

1 Answer

At highway speeds, however, the engine is noisy.


Very dificult to diagnose from your info. Could be numerous problems i.e drive belts, pulleys, alternator, power steerng pump, excessive valve clearance, gearbox whine or the most likely culprit, TYRE NOISE. I suggest take the vehicle to a respectable repair shop just for a diagnose. Get a second or third opinion, although it is no charge most of the time if it only requires a test drive (in South Africa) and take it from there!
Regards
Phillip

Jan 28, 2009 | 2008 Suzuki SX4

8 Answers

Gearbox fault of Jaguar S Type


hi,change the gear box solonied c.should b ok than ali g autos birmingham 07971335303

Jan 08, 2009 | 2000 Jaguar S-Type

Not finding what you are looking for?
2007 Honda CBF 500 Logo

Related Topics:

39 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4521 Answers

yadayada
yadayada

Level 3 Expert

76109 Answers

Mike

Level 3 Expert

4340 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...