Question about Hyosung GT 250 Motorcycles

1 Answer

Were can i fined a manuel for this bike or who is the maker of this bike to help me fix or fined stuff for it its a 2007 hyosung gt250r croch rocket

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Champion:

    An expert who has answered 200 questions.

  • Hyosung Expert
  • 473 Answers

Hyosung.com

Posted on Oct 21, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2712 Answers

SOURCE: Oil type

there usually is not a break in period anymore but when you get your first oil change refer to your owners manual. you did not say where you live but a 10w30 5w30 is recommended most. Always use a Multi viscosity oil like 10w30 the 10 is the viscosity at start up so your engine starts better. The 30 is the viscosity at operating temp. the w means that you can use it in winter. The API that you see on the oil can means American petroleum institute. SAE on the can means society of automotive engineers Viscosity means flow rate and you need to keep oil flowing at all times

Posted on Nov 10, 2008

  • 3567 Answers

SOURCE: Gearbox oil change

There should be a drain plug either on the bottom of the gearbox or on the side of the gearbox at the bottom. Put in fresh 10w40 motor oil. There will be an oil fill screw either on the left or right side of the gearbox case.

Posted on Apr 28, 2009

czaa
  • 4514 Answers

SOURCE: 2007 Hyosung GT250R stalling in 1st

clutch needs ajust cable wise or internal-they r similar to ***-chec library sec 629 if no manual is sold

Posted on Aug 17, 2009

Audioaholic
  • 376 Answers

SOURCE: my 2008 hyosung gt250r doesnt start, all light and

does it crank over?....if so check spark...fuel...etc...try to narrow it down to a actual problem such as carbs clogged, or injector not working, other than wont start, not able to tell much from that.

Posted on Sep 11, 2009

Benimur
  • 6966 Answers

SOURCE: i just got a hyosung gt250r and the hose goin off

Hi and welcome to FixYa,

Almost always, fuel overflow is a float/ fuel inlet valve problem. This would require a carb pulldown for cleaning and soaking in carb cleaner non-rubber parts. In sone instances, dirt, sand or foreign matter would wedge itself on the inlet port and the valve could not close it full hence the overflow. In others, it would be a float adjustment issue.

It would only happen when the engine is running because the fuel cut-off valve (petc0ck) is vacuum activate. Vacuum is only present when the engine is running.

Good luck and thank you for asking FixYa.

Posted on Nov 10, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2012 Hyosung GT250 EFI lurches when going off throttle and then back on throttle. How to eliminate problem?


Hi, David my gut tells me it's a sensor issue (TPS or MAP) for this situation I would call my local dealer or reputable shop's service/parts department and inquire about any possible quick fix, answers, or parts inquiry. For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
2007 Hyosung GT250R Starving for fuel maybe
Uneven running
HYOSUNG GT250 FI Owner Manual
http://www.alpha-sports.com/hyosung_parts.htm
HYOSUNG COMET 125 Service Manual

Mar 14, 2017 | 2012 Hyosung GT 250

1 Answer

Can I replace hyosung gt250 parts with other indian bikes? If yes which one do you prefer?


Hi, Anonymous for this situation I would call my local dealer or reputable shop's service/parts department and inquire about any possible quick fix, answers, or parts inquiry. For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
http://files.hyosungmotorsusa.com/GT125_250_Service_Manual.pdf
http://www.hyosung.com.au/downloads/manuals/GT250.pdf
https://www.alpha-sports.com/Parts/H_GT250R.htm
Hyosung GT 250 06 07
Hyosung GT250R EFI

Aug 11, 2016 | Hyosung Motorcycles

1 Answer

Think same problem with my bike the fuel does not flow fr the tank to the hose and to the carburator i got hyosung gt250r its been a month before i start the bike thne sudden ly fuel not flow


Sounds like the gas tank may have some crud in the bottom that is prevent the fuel from flowing through the petcock.. OR the petcock itself is stopped up. Make sure the petcock is not stopped up first.. then make sure the tank is clean. My personal ATV went through this very thing...the TANK and the PETCOCK were stopped up.
You are going to have to remove the gas tank to do this,
BE CAREFUL!!!!

May 12, 2014 | 2008 Hyosung GT250R

1 Answer

08 hyosung gt250r starting issue


Hi, Ron and the usual suspects are:
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Discharged battery, needs to be 12.5 volts or better and be able to pass a "LOAD" test if necessary.
4. Check the battery terminals for damage or corrosion check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
5. Tip over sensor needs a reset.
6. Faulty ignition switch.
7. Faulty starter button.
8. Faulty kickstand or clutch pull in switch/sensor.
9. Starter control circuit, relay, or solenoid faulty.
10. Main fuse or circuit breaker may be blown or faulty.
11. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
https://www.perthstreetbikes.com/forum/showthread.php?t=140128
Hyosung GT250R not starting
HYOSUNG COMET 125 Service Manual
http://www.alpha-sports.com/hyosung_parts.htm
http://www.hyosung.com.au/downloads/manuals/GT250.pdf

Mar 15, 2017 | 2008 Hyosung GT250R

1 Answer

Hoses on 2008 Hyosung GT250R


-this is probably some kind of overflow for unspent fuel - or oil vapours - one line will lead in - the other is probably a drain or overflow - which usually drops excess fluids on the ground - without a picture its hard to tell

Jan 06, 2013 | 2008 Hyosung GT250R

1 Answer

Hyosung GT250R Tacho not working


These bikes are never senen with many miles on them when for sale, invariably they have issues uncommon to a newer bike, this sis due to the workmanship and metalurgical issues etc, they are clones but thats where the similaritys end, they nevr last from all I ever saw of these bikes.
If you mean loses power on hills due to clutch slippage, the springs i know get weak fast and lose tension sufficient to engage fully thus allowing plates to slip and losing power to the rear wheel, if you mean otherwise nobody can tell you this way correctly.

Feb 25, 2012 | 2007 Hyosung GT250R

1 Answer

2011 Hyosung GT250R instruments keep resetting


Hi, Kingsley for this scenario you will need your service/owners manual if you can't find the first and best tool you ever bought for your Yamaha, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
Hyosung GT250R clock repair
HYOSUNG COMET 125 Service Manual
HYOSUNG GT 250 Service Manual
https://www.alpha-sports.com/Parts/H_GT250R.htm
HYOSUNG GT 125 Manual

May 12, 2017 | 2011 Hyosung GT250R

1 Answer

I haven't started my bike in almost 1 year. The starter does not even turn engine. I replaced battery and lights work. No noise at all when I press starter.


i have a 2007 gt250r and had a similar problem, on the right side beside the battery between the fairing and the frame is the starter solenoid, you can test it with a test light by putting the clamp of the test light on one side then the light on the other side, hit the starter button if the light doesnt come on it is the solenoid, about $50 off ebay

Aug 10, 2011 | 2008 Hyosung GT250R

1 Answer

2007 Hyosung GT250R stalling in 1st


clutch needs ajust cable wise or internal-they r similar to ***-chec library sec 629 if no manual is sold

Jul 04, 2009 | 2005 Hyosung GT 250

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

246 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyosung Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you a Hyosung Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...