Question about 2000 Yamaha DT 125 R

1 Answer

Hi ive got a 2000 dtr 125 the brake lights and indicators work fine when the ignition is on but non of the other lights ie headlight or tail lights work niether does the horn ive checked the switch gear it all seems ok any ideas

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 1,591 Answers

Sounds like a fuse to me!
Check the fuses by pulling them and using an ohm meter, they all should read dead short.

Posted on Mar 15, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Tail lights stop working ive change fuse, bulbs, check relay it all check fine turn, brake, hazzards lights all work just the tail & inside cluster lights are not working please help.


The tail lights and dash lights are on two different circuits. The main link would be the headlight switch. I would check for voltage there first.

Jul 24, 2012 | 2007 Toyota Matrix XR

1 Answer

2000 Kawasaki KMX 125 headlight surging


Hi, Loy2008 if your headlight is not working, intermittent, only one beam works, keeps burning out, blinking, dim or surges from bright to dim to bright the first thing you need to check is the headlight bulb for damaged filaments then check your light circuit fuse, then check your head light bulb socket ground wire for a clean tight connection, that being said the usual suspects are:
1. Faulty ground or power supply wire to headlight bulb socket.
2. Worn down solder contacts or loose fit of the bulb base in the socket due to vibration.
3. Worn, chafed, or broken wires in the light circuit.
4. Corroded, broken, or loose pins/sockets in wire connectors.
5. Faulty hi/low beam switch.
6. Faulty ignition switch.
7. Fuse is good but no continuity on both sides.
8. Faulty headlight relay.
9. Faulty wiring between battery positive and headlight bulb socket.
10. Weak charging alternator/generator/lighting coil
11. Faulty voltage regulator/rectifier ground or overcharging.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
KMX 125 ELCTRICAL FAULT
How to fix Flickering Headlights
Kawasaki KMX 125 1986 2002 Service Repair Workshop Manual 1987 1988 1989... $22
OEM Parts for Kawasaki
http://mybikemanuals.com/kawasaki

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e


Feb 08, 2012 | 2000 kawasaki KMX 125

1 Answer

Hi, The brake light on my Kymco Hipster 125 (03) is not coming on with the brakes, however when I turn the headlight on to any setting the brake light activates. Have checked the switch at the front brake...


strange but true I had a similar thing after going into my front area, what I had done is put the correctly wired wrong bulb in the indicator and vice versa into the side headlight, not an easy thing to do considering the two are physically separated but that's me, so then my side light was acting as indicator and my indicator was on constantly, in some way could you have done the same thing?

Jul 06, 2017 | 2003 Kymco Hipster 125

1 Answer

My tail light bulb keeps blowing. The brake light bit works but not the normal light. Ive been through 3 bulbs in two weeks. I commute 45 miles a day with the lights always on. Ive been using 12v 21/5w. I...


Try running the 'long life' or 'extended life' bulbs, They can withstand a little more in the rough service department. Also check to make sure your fender, bulb socket and tail light housing aren't loose, cracked etc. causing a higher than normal amount of vibration. A third thing to check is if your socket or the wires leading to it have a short, your tail light might be energizing alonw with the brake light anf causing the bulb to burn out.

Jun 28, 2011 | 2002 Suzuki GZ 125 Marauder

1 Answer

Fuses panel described in English


Hope this helps your out. I know the diagram and locator is a bit blurry but hopefully it gets what you need.
Drivers kick panel:
Front wiper 20A - Front wiper system Cigar 15A- Cigarette lighter Audio 10A- Audio, remote control mirror Air Bag 10A -Air bag diagnostics Stop lights- 15A -Rear brake light, high mounted stop light ECU B+ 10A - Shift lock actuator, transaxle controle module, radio, engine control module Room 10A - Interior light, clock, ignition key reminder, rear cargo area light switch ABS 10A- Anti lock brake system control unit ECU IG1 10A - Transaxle control module, shift lock actuator, ABS control unit, DRL unit Meter 10A - Instrument panel, back-up switch, electronics time control module, inhibit switch Turn signal 10A- Hazard switch ,front and rear turn lights, turn indicator IGN1 20A - Ignition switch ABS 30A- ABS pump motor TNS 30A- Tail light, license plate light COOL/FAN 30A- Cooling fan Cond/Fan 20A- A/C condenser fan Starter 15A- Start signal , Fuel pump Blower 25A- Blower Motor SR/ACC 10A - Ignition switch Hazard 15A - Hazard and turn signal light D/Lock 25A- Door locks ABS 30A - Anti lock brake system control P/W RH 20A- Power window motor right hand P/W LH 20A- Power window motor left hand IGN2 25A- Ignition Switch
Engine compartment :
Head 25A- headlights IG 2 30A- Ignition switch IG coil 15A -Ignition coil, condenser,generator IC regulator, diagnostic connector. O2 down 10A- Rear O2 sensor O2 up 10A- Front O2 sensor Fuel pump 10A -Fuel pump unit Injector 10A -Fuel injector ,camshaft positioning sensor, purge solenoid valve, EVAP, IAC actuator, Mass Airflow sensor, EGR stepper motor. fuel pump relay coil, vehicle speed sensor. A/Con 10A - A/C compressor controls, cooling fan BTN 30A- Brake light , high mounted stop light. Tail light LH 10A- License plate light, tail light , rear combo light, instrument panel illumination Tail light RH 10A-License plate light, tail light , rear combo light, instrument panel illumination Head low 15A- Headlight Head Hi 15A-Headlight Horn 15A- Horn jlmacman.png jlmacman_0.png

Inside kick panel jlmacman_1.png

Mar 07, 2011 | 1995 Kia Sephia

1 Answer

1992 Honda NSR 125 headlight flashes with turn signals


Hi, Jackr13 the answer to this question is way above my pay grade for this situation, I would call or visit my local dealer or reputable shop's service/parts department and inquire about any possible quick fix, answers, or parts inquiry.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
Nsr125 Headlights Flash With Indicators
Where is indicator flash relay in Honda NSR 125
https://www.scribd.com/doc/236789039/Honda-NSR-125-Service-Manual
https://www.partsfish.com/page/oem-parts-for-honda
http://campaigns.hondampe.com.au/Motorcycles/manuals/NSR150SP.02.pdf

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Feb 17, 2010 | 2000 Honda NSR 125

1 Answer

Car wont start


could be the problem check ur wires on the starter as well from battery,to alt

Aug 25, 2009 | 1994 Dodge Intrepid

Not finding what you are looking for?
2000 Yamaha DT 125 R Logo

276 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

Tom

Level 2 Expert

314 Answers

vince

Level 3 Expert

1216 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1165 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...