Question about 2005 Hyosung GT 650

Open Question

My bike is 2010 model i just washed it and now it wont start wtf

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Whats wrong


Yes. This could be the fuel pump but I would check the fuel relay first.

Mar 15, 2015 | Cars & Trucks

1 Answer

Harley troubleshooting


It would not cause, but may b while change cover some wire is disconnected or something lik dat

Aug 24, 2014 | Harley Davidson Motorcycles

1 Answer

Orange light blinking in 2010 crf 250 efi


Hi, Tyrone it should be noted that the reasons your check engine light or CEL stays on constantly or flashes and your bike will or will not start and may turn over or not, these conditions will vary from bike to bike depending on the year, make, and model and you should always refer to your owners/service manual for proper diagnostic procedures. It should also be noted that any type of prior work done to the bike or an abnormal event occurrence IE: adding accessories, electrical curiosity or adventures, laying the bike down or crashes, rain storms or bike washings just before CEL light issues started can be significant hints or aids into tracking down the gremlin, also for 2003 and older models carry the appropriate jumper wire to access fault codes and reduce the risk of being stranded or towed also keep in mind that your CEL comes to life if anything, and I do mean anything isn't 100% with the ECM like parameter spikes. This means that you could be staring at a major repair, or your speedometer sensor is contaminated and needs to be cleaned.
And the usual suspects are:
1. Severely discharged or a damaged battery check the terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary, you should have 12.5 volts or more and be able to pass a proper "LOAD" test if necessary, you may have a preliminary reading of 12.5 volts or more but little or zero amperage the battery is faulty and must be replaced, AGM batteries fail in this scenario more so than lead acid batteries.
2. Faulty charging system.
3. Faulty system sensor some models have up to 40 sensors
4. Faulty safety switches: run/off, ignition, clutch lever, neutral, side stand, tip over, fuel, and or their connections.
5. The engine got wet where it didn't like to get wet.
6. Faulty ignition circuit spark plugs, coils, cables etc.
7. Broken wire or worn insulation exposing wire to a ground situation especially inside wire harness at tight bends around fairing brackets, under dash panels, under fuel tanks over cylinder heads etc. Many harnesses are open on the ends that will allow water to enter and accumulate at v-bends.
Dielectric grease and contact cleaner are your best friends for wire/cable/harness connectors, look for corroded, broken, or loose pins/sockets. Run speedometer diagnostics and check for generated fault codes.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
2010 kill switch flashing
Need Help with my 2010 CRF250R
Honda 2010 CRF250R Service Manual
http://www.partsfish.com/page/oem-parts-for-honda
Honda CRF250X 2009 Owner Manual Competition Handbook

May 10, 2014 | 2010 Honda CRF250R

1 Answer

Motorcycle will push start but not ignition switch start


Does it turn over when trying to start? If no then it could be the starter, switch, or battery. Sounds like the starter, especially if you tried another switch.

Apr 14, 2014 | 2008 kawasaki Ninja 250R

1 Answer

Bike has spark, feul leaks from carb when laid on its side, bike ran fine , now wont start


bikes are not meant to lay on their side they have a float which shuts off fuel in normal up right position

Dec 14, 2013 | 2010 KTM 250 SX

1 Answer

2010 street glide, security signals are always on. key (Icon) always flashing on the dash. Bike wont start.


Hi Cstewart179, you may need an alarm reset, for more information about your question please visit the website below. Good luck and have nice day.
Set Change Override Transport Harley Security Alarm PIN Code No Key Fob...

May 21, 2012 | 2010 Harley Davidson FLHX Street Glide

2 Answers

Looking at purchasing a new motorcycle from yamaha. They advised me that it is a 2010 model however on the compliance plate it states Oct 09. Who should I believe, the dealer of the product selling the...


The bike was manufactured in October '09 to be sold as the 2010 model year. Auto dealers do the same. You can buy a 2011 Ford Mustang in September of this year, 2010.

Feb 20, 2010 | 2008 Yamaha XT 660 Z Tenere

1 Answer

GE Profile washing machine model 66515754000. 9


Try a cleaning detergent/descaler. some liquids do cause problems. Softner is 1, it tends to gel in the pressure chambers in machines. This in turn causes many problems.

Feb 11, 2010 | Washing Machines

1 Answer

I washed the bike and it wont start now. the


have you checked for a spark at the plugs. You may well have got water in the coils.The cure for this is natural drying. if this is the case the coils will need to be sealed. and the leads silicone sprayed

Jun 04, 2009 | 1999 Suzuki GSX 600 F (Katana)

Not finding what you are looking for?
2005 Hyosung GT 650 Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyosung Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4521 Answers

yadayada
yadayada

Level 3 Expert

76051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Hyosung Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...