Question about 1991 Honda CBR 600 F(2)M

1 Answer

I have a 1991 honda cbr 600, she'll start fine with the choke fully on. As she warms I let the choke off slightly and keep her at about 1,500rpm. Then she'll start steadily cutting out. It doesn't matter what I do after that. She just won't start again. Ive tried catching it with the throttle, choke and mixture gauge on the side but 9/10 times she just dies quicker. Please could you help?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Carbarator needs adjustments m or bad air filter

Posted on Mar 11, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Cbr 600 f sport harder to start when weather gets cold


check choke working fully , check plug cap resistances not too much and condition and gap on plugs !

Jan 12, 2014 | 2002 Honda CBR 600 F(4)i

1 Answer

Hello im having a problem with my 1991 radian 600, it starts fine with choke full, then i let it warm up, turn choke down and it dies


Your carb jets are dirty and/or you have a vacuum leak creating a lean condition. Clean and sync the carbs.

Aug 07, 2011 | 1991 Yamaha YX 600 Radian

1 Answer

I have a 1991 honda cbr 600, she'll start fine with the choke fully on. As she warms I let the choke off slightly and keep her at about 1,500rpm. Then she'll start steadily cutting out. It doesn't matter...


You didn't say whether the bike has been sitting (without being run) for any amount of time. If it has, I'd say that either your pilot jets are plugged, or you float needle is blocked/restricted; thus not allowing it to refill the carb bowls as fast as the fuel is being drawn from them by the engine. The later though usually only effects 1 maybe 2 carbs. Not usually all 4. the plugged pilots jets are more likely.
So how long has the bike sat without running? (And "It was running before I parked it" doesn't apply here) :-)
Good luck

Mar 11, 2011 | Honda CBR 600 F(1)H Motorcycles

1 Answer

My cbr 600 f2 1993 had been sitting for a long time


Sounds like the carbs were not properly cleaned or set up. Choke should cause the cold start rpms to be higher than what you are experiencing. Application of choke to a warmed up engine will usually cause the engine to stall.

Jun 28, 2010 | 1994 Honda CBR 600 F(2)R

1 Answer

My honda cbr 125 wont start. Battery okay


i think youneed to start the bike with a fully charged battery and the choke open with no throttle and keep turning it over till it stars failing that check the fuel hoses and vacum hoses to the carb

Jan 25, 2010 | 2004 Honda CBR 125 R

1 Answer

1994 cbr 1000f starts and runs fine . then wont fire .


If you find a problem let me know ...i"ve had a little luck in messing with the Claifornia emisions systems after i d=change the purge control valve it got a little better...then i had found a hose that had slide off the #4 clyinder that was causing a vaccum leak ...its not running 100% but i"'ll settle for 98%...its got to be in the emissions systems some kind of leak.

Sep 02, 2009 | 1991 Honda CBR 1000 F

2 Answers

96 honda cbr 600 f3


hi would be good idear to also check spark and and timing also if you just got bike give it a good service this includes fuel filter

hope this helps

Jun 17, 2009 | 1998 Honda CBR 600 F(3)W

1 Answer

( 93 cbr600f2 was crashed and rebuilt seems to have hot spark but wont start smells like its flooding Made just a couple gurgle sounds out of the pipe then a small backfire where do i start fire carbs...


sound like it's flooded over. i have one of these bikes for a stunt bike and had a similar problem before. use a fully charged jump box. connected it to your battery and hold the start button. don't use choke or give it any gas either. it mike take about 5-15 minutes to start, but it will.

Jun 13, 2009 | 1991 Honda CBR 600 F(2)M

1 Answer

Cbr 600 stalls afeter warming up


Sounds like a good tune up is needed. Also check the fuel system to be sure everything is clean and operating properly.

Mar 07, 2009 | 2005 Honda CBR 600 RR

1 Answer

Knocking or clicking in the top end of my 1994 cbr 600


you could have a loose valve that will cause it too click like that..

Dec 05, 2008 | 1994 Honda CBR 600 F(2)R

Not finding what you are looking for?
1991 Honda CBR 600 F(2)M Logo

Related Topics:

250 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75051 Answers

Gino Cussen
Gino Cussen

Level 2 Expert

216 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...