Wont start has spark and fule - Neon Dodge Cars & Trucks

Compression, fuel, timing and spark and a sufficient cranking speed are all required for an engine to start. Each should be checked through systematically but check the immobiliser first.

Check for spark. Remove a spark plug and attach the wire back on, then hold the plug against the engine block and have someone crank the engine. Watch for a spark.

well the mechanic should be asking questions here because the first motor might have not been the problem if a new used one dosent start 1st check for fule is fule getting to the fule rail 2nd is there spark at the spark plugs with plug removed but pluged in turn over and look at spark plugs to see if they are even sparking when attempting to turnover

inside the distributor is a pickup coil and if it goes you will get no spark.
best bet is to get a rebuilt distributor it is far easier than taking one apart

check your spark plugs, usually you need change it every 30,000 miles...





How to change?


http://www.ehow.com/video_110_replace-spark-plugs.html





Hope this helps

Do you have spark?

look in your manual for a fuel pump reset button. Usually in the rear of the vehicle.

the fact that there are many things that can go wrong and it's tough to test some componetarnts without special equipment.

This is just recommendations did you check if you have spark first

You have to troubleshoot first check your electronic system

Disrupter cup wiring everything

You say you have spark, and fuel, but you also have to check for compression....Get a pressure guage and check each cylinder, or atleast 3 of them..It is very possible that your timing belt has popped..

check the fule pump to see if it is working. if no fule it wont start so let me know if u after u see if u have fule and we will go from there