Hi Please can you confirm what fuel the Ryobi rg6700k generator takes?

Hi,

Please work with an electrician to ensure that your house is setup properly to use the type of generator that you've listed. Thank you.

No exact model given so we take best guess.

Hi!
You need to adjust your valve lash clearances to: Intake: 0.015" (0.381mm) Exhaust: 0.015-0.020" (0.4-0.5mm) (Try smallest setting first.

Videos as well

https://www.google.com/search?q=Valve+clearance+on+ryobi+3600+generator

..

hi Gerrie.
this is all i could find.see if this link helps you out.
Ryobi Generator RG 2700 MANUAL DOWNLOAD Google Search

Hi Paul:
I'd start by pulling the spark plug, attaching it to the lead, then spin it over and check for spark.
This will probably be a 2 cycle motor (Check to confirm) so make sure your fuel is mixed correctly.

have had the same problem with a Ryobi 1000w invertor generator. The problem that you are experiencing is the low level oil switch. To confirm if this is the problem disconnet the low level oil switch (Yellow or Orange wire). Try and start the generator now, it should start with the first little tug on the recoiler. Once it is running, reconect the low level oil switch and see what happens then. Either it will cut out, then you know it is the oil level switch or it will continue running and the problem will go away. Please ensure you manually check the oil level first before starting.

Hi afs3...
Yes use the 50:1 oil to gas ration. 1 pint of 2 cycle oil to 6 gallons of gasoline.
Please take time to rate me

Hi f4vahr...

The larger fuel line will have the fuel filter attached to it, normally it is located in the fuel tank on trimmers...
Please take time to rate me

Hi, Make sure your fuel /oil mix is correct, then, take a capfull of fuel and pour a few drops down the cylinder. After replacing the plug, give the starter a try. With fuel in the chamber and a confirmed spark, the engine has no choice but to fire. From here, you can determine if the idle adjustment needs to be changed. Hope this helps.

It's best to run all electronics through a UPS and surge protector. Small generators like the RG-950 are really for small power tools and lighting. The Ryobi RG-950 is only rated 650 watts which really means about 450 watts (70%) for continuous use. In general, a basic desktop or a laptop should be OK. A TV up to 25 inches and a 100w lamp, should be OK. If you try doing both at the same time, expect smoke followed by lights out. A UPS and Surge Protector are a must on small generators due to their poor voltage and frequency regulation. The UPS should be a good quality one that deals with Brownout, Overvoltage, and frequency deviation. ALWAYS USE A SURGE PROTECTOR!