How do I change the license plate light? - 2003 Toyota Corolla

Remove the wheels if possible.
Remove the two clips from each side (by pulling up the center).
Move the fender liner away to access and remove the 7 mm bolt that is near the corner.
Unscrew the four cargo anchors from the floor of the trunk.
Move the trim panel and remove the 4 10mm bolts.

To get to the license plate lights assembly, you can follow these steps:

Open the rear compartment lid and locate the license plate light assembly inside the trunk lid.
Above the license plate, locate four Philips head screws holding the license plate light assembly inside the trunk lid.
Remove the screws (caution: in winter, plastic is extremely fragile and can break easily).
Once the screws are off, your license light assembly is loose inside the trunk lid.

rear bumper cover removal?? ' Cadillac Owners Forum (cadillacforums.com)

2002 escalade changing liscense plate lights ' Cadillac Owners Forum (cadillacforums.com)

The license plate lamps are designed to illuminate the plate and registration tags on your vehicle and make it easily visible to law enforcement. In many states, a burnt out license plate bulb can get you a ticket.
Step 1: Locate the license plate light. The license plate light is located right above the plate.
Step 2: Determine which bulb has failed. Park your vehicle and set the emergency brake. Turn the ignition to the Accessory position and turn on the driving lights. Walk around the vehicle to determine which license plate bulb has failed.
Step 3: Remove the license plate light cover. Remove the license plate light cover retaining screws using a screwdriver.
Remove the license plate light cover.

• Note: You may need to use a small screwdriver to pry the cover off.

Step 4: Remove the bulb. Remove the bulb from its retainer.
Part 2 of 2: Install the bulb Materials Needed

• Protective gloves
• Replacement license plate light bulb
• Safety glasses
• Screwdriver

Step 1: Install the new bulb. Install the new bulb in its retainer and ensure it is in place.

• Tip: Refer to your car's user manual to determine the correct type of light bulb to get for your specific vehicle.

Step 2: Complete the installation. Put back the license plate light cover and hold it in place.
Install the license plate light cover retaining screws and tighten them using a screwdriver.
Step 3: Check the lights. Turn on your car to check if your license plate lights are fully functional.

can you rich from trunk,maybe has clips.

Here is an article on switching over to the LED bulbs, but it shows you what must be done to access the lic plate bulbs as well.

YOU HAVE TO OPEN THE TRUNK LID REMOVE THE BLACK PLASTIC COVER FOR THE TRUNK LID LATCH.REMOVE THE LICENSE PLATE LIGHT HOUSING FROM THE TRUNK LID.REMOVE THE BULB SOCKET FROM THE LICENSE PLATE LIGHT HOUSING.TO REMOVE BULB FROM THE SOCKET SIMPLY PULL IT STRAIGHT OUT OF THE SOCKET.

License Plate Lights Removal & Installation License plate lamp retainer clips

To Remove:
Remove or disconnect the following:

1. License plate
2. Pin-type retainers and the luggage compartment lid trim panel
3. License plate lamp electrical connector
4. Lamp socket from the license plate lamp
5. Using a suitable tool, through the access hole, release the clips and remove the license plate lamp

To Install:

1. Install or connect the following:
2. License plate lamp
3. Lamp socket to the license plate lamp
4. Electrical connector
5. Luggage compartment lid trim panel
6. License plate

You need to change the bulb there.

need to change the incenses plate lights . how do i get to the lights.

The license plate lights are in the ledge above the license plate. 2 screws keep the lens cover in place. Remove the screws, and the cover comes off. Just pull the lamp out (wedge base) and replace.

Does the fuse have power in and out when a test light is used? This test would be run with the light switch on.