Question about Suzuki Rg 400 Motorcycles

Open Question

I have a suzuki eiger 400.it will idle but you can't throttle it.it just dies.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
emissionwiz
  • 76109 Answers

SOURCE: what engine oil do you recommend for 2006 suzuki

this bike uses any major brand 10W40W

Posted on Dec 07, 2009

Ad
  • 2 Answers

SOURCE: 2006 Suzuki Eiger 400 ATV. Engine starts and

try cleaning the main jets,,its very easy to do and 99% of the time it will solve it

Posted on Sep 14, 2010

  • 19 Answers

SOURCE: i have a suzuki 400 atv eiger 2003 i would like to

actually the write up from ollie reese is not correct and is demontrated on a kawasaki. Though kaw is manufactured by suzuki, the motor shown is not the same. its is all correct however your oil filter is located and sticking out of the front side of your engine, just like a car oil filter. You cannot miss it. so drain oil from drain plud below, remove the oil filter(please note this will have oil in it and most likely spill so be prepared) and replace. now fill the oil where you find the black dipstick to factory set levels and ride away. good luck

Posted on Dec 14, 2010

19ken55
  • 426 Answers

SOURCE: Just had the motor rebuilt

Adjust the idle to correct RPM say 900 or so.

Posted on Jan 27, 2011

derickxrm
  • 88 Answers

SOURCE: 2003 Eiger 400 runs great

check and clean the carburator... doble check the fuel line in the carb....

Posted on Aug 19, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 97 Suzuki king quad start up an idled good but it goes dead as soon as you hit the gas


Hi, Aaron the following applies to carbureted also fuel injected models and the usual suspects are:
1. Severely discharged or a damaged battery, should have 12.5 volts or better and be able to pass a load test if necessary.
2. Failed alternator/generator and or voltage regulator.
3. Loose or corroded battery terminals and or cables especially the "NEGATIVE" cable, look for loose, corroded, or broken connectors inside the cable harness at "BOTH" ends.
4. Failed main circuit breaker or ignition switch, check for loose connections and continuity.
5. Failed system and or ignition relay, check for continuity.
6. Failed ignition coil, ignition/electronic module.
7. Failed CKP, CPS, CMP, MAP, TPS, or BAS sensor, corroded, loose or broken wire connector pins/sockets.
8. Throttle cables and or idle speed improperly adjusted hot idle speed should be 950 RPM to 1000 RPM.
9. Air/fuel mixture ***** improperly adjusted.
10. Water or dirt in the fuel system, carburetor or filter.
11. Restricted, blocked or kinked fuel line.
12. Fuel tank empty.
13. The gas cap is not venting properly or fuel tank venting system blocked.
14. A failed fuel pump, pressure regulator and or fuel injectors.
15. Vacuum line from intake manifold to petcock broken, cracked, or not attached, carburetor vent line plugged.
16. Needle and seat stuck closed in the float bowl.
For more information about your issue and valuable "FREE" downloads that you need please click on the links below. Good luck and have a nice day.
eiger 400 will idle but when push the throttle it dies
ATV Connection
honda idles but dies
https://www.tradebit.com/filedetail.php/262744474-suzuki-quadrunner-250-kingquad-280-service

Apr 17, 2016 | Suzuki Motorcycles

1 Answer

I've got a 2006 Suzuki eiger 400 4wd. I've been rideing it all day, and now it will not start. Even pull start.what could be the issue?


Repair and Maintenance [Archive] - Page 4 - Suzuki ATV Forum

www.suzukiatvforums.com/forums/archive/index.php/f-23-p-4.html
1992 King Quad High Idle Issue · kill switch · quad master 500 wont run · Spark ...2006 suzuki vinson fuel gauge shows empty · 87 LT-4WD L.H cover removal: ... 07 Kingquad 700 Starting and electrical issues · 2002 Eiger 400 won't go into ...

Nov 23, 2015 | Suzuki Motorcycles

1 Answer

How to change the oil on Suzuki ATV Eiger 400


here is a link showing oil change proceedure https://www.youtube.com/watch?v=WbvPG0ow3aw

Oct 09, 2014 | Suzuki 2006 Eiger Automatic 400 4X4...

1 Answer

Where do the vaccum lines on atv 400 eiger suzuki gooff the carb.


The vacuum line goes to the smaller of the two fittings on the fuel petcock. Suzuki used a vacuum controlled auto shut off mechanism in many of their fuel petcocks.

Oct 06, 2014 | Suzuki 2006 Eiger Automatic 400 4X4...

1 Answer

Suzuki eiger 400


you may have jumped timing and bent a valve

Aug 02, 2014 | Suzuki 2004 Eiger Automatic 400 4X4...

1 Answer

Suzuki eiger 400


could be the pickup coil, the cdi or any of the wiring in between.

May 03, 2013 | Suzuki 2006 Eiger Automatic 400 4X4...

1 Answer

2005 suzuki 400 eiger starts and idles well, but no power when throttle is pushed


CHECK THE EXAUST THEY BECOME CLOGED WITH CARBON HAD MANY ISSUES WITH THEM SCREENS

Jul 31, 2012 | Suzuki Motorcycles

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

186 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4521 Answers

Richard
Richard

Level 2 Expert

83 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...