Question about 2002 Honda CR 250 R

1 Answer

Engine misfires at high rpm (2008 Honda crf) - 2002 Honda CR 250 R

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 8,909 Answers

Depending on how high the revs are, it is either valve bounce or an ignition fault. Check the plug type and gaps and check the engine mapping.

Posted on Jan 03, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2003 Honda CRF 450 R misfires


Hi, Anonymous and the usual suspects are:
1. Severely discharged or a damaged battery should have 12.5 volts or more and be able to pass a proper "LOAD" test if necessary, you may have a cursory reading of 12.5 volts or more but little or zero amperage the battery is faulty and must be replaced, AGM batteries fail in this scenario more so than lead-acid batteries.
2. Check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
3. Spark plugs in bad condition or partially fouled.
4. Spark plug cables in bad condition and leaking check for spark leakage in the dark
5. Spark plug gap too close or too wide.
6. Faulty ignition coil, module, and or sensor.
7. Loose, dirty, or corroded ignition module connector at crankcase.
8. Faulty CKP or CMP, MAP, ETS, ATS, TPS, O2 sensor.
9. Dirty air filter.
10. Intake air leak.
11. Water, dirt, or rust in the fuel system.
12. Carburetor contaminated, sticky float, plugged jets.
13. Carburetor vacuum diaphragm torn, cracked, not seated or installed improperly.
14. Multiple carburetors out of sync.
15. Fuel filter clogged.
16. Old or contaminated fuel.
17. Fuel tank vent system plugged or carb vent line closed off.
18. Gas cap diaphragm valve faulty.
19. Vacuum line from intake manifold to fuel valve is broken, cracked, pinched, or missing.
20. Carburetor controls misadjusted.
21. Incorrect valve timing.
22. Valve springs floating, weak, or broken.
23. Damaged intake or exhaust valve.
24. Incompatible performance parts.
25. Control module may be in "LIMP" mode
26. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
crf450r Misfire totally stumped
https://crfsonly.com/forum/viewtopic.php?t=23140
Honda CRF450X 2005 Service Manual
http://www.partsfish.com/page/oem-parts-for-honda
Honda CRF450R Owner Manual

May 06, 2013 | 2003 Honda CRF 450 R

1 Answer

I have a 2008 mercury Milan with nearly 60k miles on it. When I come to a stop the rpm drops by 1000 then recovers quickly. What should I do to fix the problem? Any suggestions will be greatly appreciated.


Check out related help links to troubleshoot these problem:----Click the link below:---Idles Fine but RPM jumps in drive mode? http://technoanswers.blogspot.in/2012/07/idles-fine-but-rpm-jumps-in-drive-mode.html
---------Mitsubishi Lancer rpm needle bounces? http://technoanswers.blogspot.in/2012/02/mitsubishi-lancer-rpm-needle-bounces.html
--------How to adjust rpm on 2009 dodge charger SRT8?


http://schematicsdiagram.blogspot.com/2011/12/how-to-adjust-rpm-on-2009-dodge-charger.html
---------
Engine cuts out at 3000 RPM? http://schematicsdiagram.blogspot.com/2011/12/engine-cuts-out-at-3000-rpm.html

---------

Cold start problem and vehicle shudder around 2500 to 3500 rpms
http://repairhelpcenter.blogspot.com/2012/10/cold-start-problem-and-vehicle-shudder.html

---------
High rpm in neutral? Inconsistant high RPM in neutral? http://technoanswers.blogspot.in/2012/02/high-rpm-in-neutral-inconsistant-high.html

-----------
Jetski Sputters and Low RPM? http://whatisbyme.blogspot.in/2012/07/jetski-sputters-and-low-rpm.html

--------
Fuel Injection Problem And RPM suddenly increases http://whatisbyme.blogspot.in/2012/07/fuel-injection-problem-and-rpm-suddenly.html

----------
2005 Toyota Highlander: Engine runs hard RPM below 3000? http://whatisbyme.blogspot.in/2012/05/2005-toyota-highlander-engine-runs-hard.html

---------
1987 Toyota Camry: RPM Drops going Up hills? http://whatisbyme.blogspot.in/2012/05/1987-toyota-camry-rpm-drops-going-up.html

-----------
Cruise Control stops working, Excessive cranks to start the engine and RPM goes max 2500 http://whoisbyme.blogspot.in/2012/07/cruise-control-stops-workingexcessive.html

----------
1990 Toyota 4Runner: Engine cuts off when reaches 2000 RPM?


http://whatisbyme.blogspot.in/2012/05/1990-toyota-4runner-engine-cuts-off.html

------------
1999 Toyota Camry: Erratic stalling and high engine RPM at idle?


http://whatisbyme.blogspot.in/2012/05/1999-toyota-camry-erratic-stalling-and.html

---------
1995 Toyota LS: Misfire at idle or low RPM http://whatisbyme.blogspot.in/2012/04/1995-toyota-ls-misfire-at-idle-or-low.html

-----------
Lexus RX: Tapping noise under Valve Cover At Low RPM? http://technoanswers.blogspot.in/2012/04/lexus-rx-tapping-noise-under-valve.html

----------
These will help.
Thanks.

Nov 22, 2012 | Cars & Trucks

1 Answer

Driving on the road the RPM goes higher wituout speedind


Check out related help links to troubleshoot these problem:----Click the link below:---Idles Fine but RPM jumps in drive mode?http://technoanswers.blogspot.in/2012/07/idles-fine-but-rpm-jumps-in-drive-mode.html
---------Mitsubishi Lancer rpm needle bounces?http://technoanswers.blogspot.in/2012/02/mitsubishi-lancer-rpm-needle-bounces.html
--------How to adjust rpm on 2009 dodge charger SRT8?


http://schematicsdiagram.blogspot.com/2011/12/how-to-adjust-rpm-on-2009-dodge-charger.html
---------
Engine cuts out at 3000 RPM?http://schematicsdiagram.blogspot.com/2011/12/engine-cuts-out-at-3000-rpm.html

---------

Cold start problem and vehicle shudder around 2500 to 3500 rpms
http://repairhelpcenter.blogspot.com/2012/10/cold-start-problem-and-vehicle-shudder.html

---------
High rpm in neutral? Inconsistant high RPM in neutral?http://technoanswers.blogspot.in/2012/02/high-rpm-in-neutral-inconsistant-high.html

-----------
Jetski Sputters and Low RPM? http://whatisbyme.blogspot.in/2012/07/jetski-sputters-and-low-rpm.html

--------
Fuel Injection Problem And RPM suddenly increaseshttp://whatisbyme.blogspot.in/2012/07/fuel-injection-problem-and-rpm-suddenly.html

----------
2005 Toyota Highlander: Engine runs hard RPM below 3000?http://whatisbyme.blogspot.in/2012/05/2005-toyota-highlander-engine-runs-hard.html

---------
1987 Toyota Camry: RPM Drops going Up hills?http://whatisbyme.blogspot.in/2012/05/1987-toyota-camry-rpm-drops-going-up.html

-----------
Cruise Control stops working, Excessive cranks to start the engine and RPM goes max 2500 http://whoisbyme.blogspot.in/2012/07/cruise-control-stops-workingexcessive.html

----------
1990 Toyota 4Runner: Engine cuts off when reaches 2000 RPM?


http://whatisbyme.blogspot.in/2012/05/1990-toyota-4runner-engine-cuts-off.html

------------
1999 Toyota Camry: Erratic stalling and high engine RPM at idle?


http://whatisbyme.blogspot.in/2012/05/1999-toyota-camry-erratic-stalling-and.html

---------
1995 Toyota LS: Misfire at idle or low RPMhttp://whatisbyme.blogspot.in/2012/04/1995-toyota-ls-misfire-at-idle-or-low.html

-----------
Lexus RX: Tapping noise under Valve Cover At Low RPM?http://technoanswers.blogspot.in/2012/04/lexus-rx-tapping-noise-under-valve.html

----------
These will help.
Thanks.

Nov 22, 2012 | 2008 Toyota Avalon

1 Answer

2008 Honda CRF 250 R blows oil out of the breather hose


Hi, Devenbandazi and the usual suspects are:
1. Oil tank/system overfilled.
2. Faulty breather valve.
3. Engine breather hose bent, pinched, kinked etc.
4. Air filter has too much "pre-oil".
5. Crankshaft seal failure allowing transmission fluid to migrate.
6. Blow by drain tube cracked/split or filled to capacity.
For more information about your question and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
Losing oil from crankcase breather hose 06 crf 250r
HELP NEEDED CRF250 Putting Lots of Oil Out Valve Cover Breather
Honda 2004 CRF250R Service Manual
http://www.partsfish.com/page/oem-parts-for-honda
HONDA CRF250R 2006 Owner Manual

Jul 18, 2011 | 2008 Honda CRF 250 R

1 Answer

Honda CRF 230 RPM does not drop to idea all the time when grip released. It is not a mechanical issue hanging up as it is against adjustment idle adjustment screw, but engine stays at high idle unless you...


If all the mechanicals are okay, I would check for an air leak between the carb and the cylinder. Loose mount clamps/screws and/or cracked rubber fittings can cause the problem you describe.

Mar 11, 2011 | 2005 Honda CRF 230 F

2 Answers

Honda CRF 100 F, 2008 - no driver manual


here you go

http://powersports.honda.com/2009/crf100f.aspx

http://www.cyclepedia.com/honda-crf80-crf100-online-service-manual/

http://www.themotorbookstore.com/hocrcronsema.html

Dec 24, 2009 | 2005 Honda CRF 100 F

1 Answer

I have a CRF100 and it has excessive vibration


Make sure all of the engine mounting bolts are tightened properly. One loose engine mount bolt can cause exactly what you are describing. While you're doing that, perform a visual inspection of the attachment points on the frame, making sure there are no visible cracks.
Aside from that, just stick a wrench on every bolt and nut on the bike that you can see - and make sure everything is tight.
The only other possible thing I can think of would be a loose flywheel on the crankshaft. Unlikely, but check just to be sure.

Nov 30, 2009 | 2005 Honda CRF 100 F

1 Answer

Misfiring 2007 Honda VFR 800


try new plugs also maybe a different plug also check air filter is clean

Sep 22, 2009 | 2005 Honda VFR 800

Not finding what you are looking for?
2002 Honda CR 250 R Logo

Related Topics:

456 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers

yadayada
yadayada

Level 3 Expert

76649 Answers

bazzz7071
bazzz7071

Level 2 Expert

342 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...