Question about 2005 Suzuki GSX-R 600

1 Answer

05gsxr600 want start fuel pump not getting power red light is on and it says check what do i check

Posted by Anonymous on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 53 Answers

Have you checked the fuel pump fuse? it is located with the other fuses. check the specific location of the fuses in your owners manual. the fuel pump should power up as soon as the ignition is all on. It will only power on for about 5 seconds. If the fuse is ok you should check for 12 volts at the connector to the fuel pump when you turn the key on. again, the power will only show for about 5 seconds. If the fuse is good and the fuel pump is getting poer the fuel pump is bad. this is very rare.
contact me if you have other questions.
Steve

Posted on Jan 02, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Gas gauge quit working, now car won't start


Sounds like you dont have any power going to your fuel pump. You will have to drop your tank and with a light tester check the red wire for power. If you cant tell with one is the red wire it will be the secound wire going into the plug. If you dont have any power there then make sure your fuses are good. You will need help with this because it is very had to reach the key switch and check the wire the same time. It is on a relay switch and only stays on for 5 secounds. Good luck.

Nov 25, 2012 | 1998 Volkswagen Beetle

1 Answer

No fuel pressure, new pump


No fuel pressure means the pump is not running. Check the pump fuse and if it is good, find the pump relay and check for power going to it on the thick (red?) wire. If it has power there hook a meter or test light to the smaller power wire, have someone turn on the key while you watch the meter or light. It should read voltage for a few seconds.If that is good check the power wires going out from the relay to the pump. Same drill with the meter/light. If there is no power coming out from the relay it is a bad relay.

Oct 12, 2012 | 1996 Chevrolet S-10 Pickup

1 Answer

My 1993 GMC Sierra Z71 will not start. We changed the fuel pump, the throttle pressure regulator, fuel filter,and fuel pump relay. The pump gets gas to the injectors but from there it does nothing and goes...


Hi, that's possible but first check the ECM fuse and use a test light to check for power to the injectors on the red and white wires. The computer uses a number of sensor inputs to calculate the injector signals required. If these signals are not available, the computer cannot send the appropriate injection metering signal and will usually set the engine light. Is the engine light on?

jturcotte_1332.gif


jturcotte_1333.gif

Mar 26, 2011 | GMC Sierra 1500 Cars & Trucks

1 Answer

What typically is needed to to be done if a 2001 supercrew has had air bags deployed and wont start after that. The switch in the right kicker panel for the fuel pump does not appear to have been tripped....


Good info on the PATS / theft light. Looks to be the PATS / HEC operation is functioning correctly

The Fuel inertia switch only cuts power to the fuel pump, so if tripped, the truck would have a crank no start issue. Do you have a crank no start, or no crank issue.

To reset, just press down on it. To check if the switch is tripped, check for power at the connector to the fuel inertia switch

Engine compartment fuse # 10 ( 20A ) to the fuel pump relay -> Dark Green w/ yellow stripe wire to the fuel inertia switch -> pink w/ black stripe wire to the fuel pump module.
Check the pink w/ black stripe wire to ground with a meter for power, with the key in the run position.

If you turn the key from off to run ( do not start ) you should hear the fuel pump cycle ( hum, then turn off ).

Could be an issue with the fuel pump relay ( my '01 had a crank no start at ~ 35K miles, bad fuel pump relay ). I proved this out ( after a stupid ID10T error in my diagnoses process ) by jumpering the normally open contacts in the fuel pump relay socket, and then installing the trailer tow reverse circuit relay into the fuel pump relay socket ( same full size Ford Relay ).

Jumpering the fuel pump relay in the relay socket ( remove relay and use jumper wire ), red line
sscullys_16.jpg

If you have a no crank issue, could be the DTR ( Digital Transmission Range ) sensor on the driver's side of the trans is out of alignment.

Check the start motor relay ( on the firewall on the passenger side ) for power on the Tan w/ Red stripe wire when the key is in the start position ( this is from the ignition switch through the DTR when in park or neutral to the starter motor relay ).

You can test another route, turn the key to the run position, and apply power to the Tan w/ Red stripe wire on the starter motor relay in the engine compartment on the firewall. BE CAREFUL, the motor should turn over, keep clear of moving parts.

Post back a comment to this problem with the results of the testing.

Thanks

Nov 03, 2010 | 2001 Ford F150 Styleside SuperCrew

2 Answers

From red light truck started sputtering and and stalled out


Hello. The GMC Sierra has an electric fuel pump so you should ensure that its fuses and relays are working before checking it. You may need to clean your fuel pump or replace it if your gas tank is not empty, but your vehicle has difficulty getting fuel. The GMC Sierra comes in a variety of styles and trim levels that can affect the replacement fuel pump you choose.

Mar 02, 2010 | 2003 GMC Sierra 1500

1 Answer

How do i change the fuel pump for a 1991 buick regal and how can i tell if it is the fuel pump


turn the key on without starting the engine and listen for the fuel pump to make its 2 or 3 second fuel prime,, you may have to listen carefully, if you dont hear it, check the fuel pump fuse 10 amp red fuse. If its ok check for power at the connector leading to the top of the fuel tank, with it unplugged test with a test light the harness side of the connector between the grey wire and ground for power, the test light should light up when you do the fuel pump prime test again, light will come on for 2 to 5 seconds, if it does replace the fuel pump in the fuel tank >>note if you can hear the pump in the first test, pressure should be around 35 psi .

Nov 24, 2009 | 1991 Buick Regal

2 Answers

94 dodge grand caravan no fuel in fuel rail


Dear Ron, you have replaced fuel pump and fuel filter. You have checked the fuel pump relay. Still no fuel in rail. Try bypassing fuel relay with jumper from batt to fuel pump. If o/k then check computer for ground to relay. This system uses a relay that is operated by the computer that supplies a ground for the relay to operate. The wire color is green,16 gage. If the ground is not available then "no fuel" Check this with a test light. Key on and crank apply test light to ground wire and other end of light to ground. You should hear relay click and get fuel. If this checks out you will need to replace computer or get creative with rewiring the relay so it works without computer input. Good luck Moe

Apr 24, 2009 | 1994 Dodge Grand Caravan

Not finding what you are looking for?
2005 Suzuki GSX-R 600 Logo

234 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4533 Answers

Richard
Richard

Level 2 Expert

83 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...