Question about 2006 Yamaha YZF-R1 SP

2 Answers

My yamaha R1 07 i have problems starting the bike from cold sometimes when its warm i presss the button it starts then stops.I have to then hold the throttle open and the bike will start but i have to keep the throttle open unyil its warm.Sometimes when im riding it if i stop i have to do the same thing all over again.And now the battery keeps going flat and i dont know what to do?

Posted by on

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Yamaha Master
  • 4,536 Answers

The choke needs to be serviced-ajustment or cleanin--is battery more then 3 yrs old! may also have a bad alternator-testit

Posted on Jan 01, 2011

  • fauberfloors Jul 21, 2011

    my 07 r1 today had no power to rear like it was runnin on 2 cyl....had battery probs the last week...would battery cause bike not to run right if dead? it started but 1st gear takes off like in 6th... pipes got loud to at same time

  • Arnie Burke
    Arnie Burke Jul 21, 2011

    cycles have a batt coil ignition-that means the spark goes thru battery-and if not at 12.6volts then bike runs poor--do the required test I said-buy a clymer or haynes manual for troublshoot procedure

×

Ad
  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I have a 2006 yamaha r1, recently my bike is have problems my bike is sputtering like its not getting any gas also its feels like it is hesitant at some points when going a steady speed also it cuts off as i down shift or stop at streets or stop signs what could be the cause of this problem. also every now and then my battery seems to be dead and will need to charged up could this be my problem ?

Posted on Aug 12, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My r6 running too fast when started


On cold days, the yamaha fuel injected bikes rev higher to warm up the engine quickly. It is still ok to ride the bike on a cold engine, but it will perform much better when the engine is warmed up.

Mar 09, 2014 | Yamaha Motorcycles

1 Answer

2002 yamaha r1 it starts and runs great but idles at 3000 rpm when it gets warm


I have this problem on my 1998 r1 did you solve the problem?

Jan 10, 2012 | 2002 Yamaha YZF-R1

2 Answers

Cold starting problems 1981 yamaha maxim 400


could be a few things going on . have you checked the vacuum lines? could have one plugged or collapsed? Could be a carb problem? have you installed a carb kit yet ? or you could try a hotter spark plug.

Jul 10, 2009 | 1983 Yamaha XJ 650

1 Answer

Bike won't start. Only hitting on 2 cylendars


posible vacuum leak replace vac line to fuel tank

Jun 03, 2009 | 1982 Yamaha XJ 650

1 Answer

Won't idle down after it warms up


after the bike has warmed up, then reset the idle to approx 1000rpm. then see what happens when its cold. some bikes are cold blooded and the use of choke is necessary for a bit, at least until it warms up...

May 24, 2009 | 2007 Yamaha Road Star

1 Answer

Trouble starting on warm starts sometimes.


This really sounds like a need to replace the intake gaskets. When the bike warms up the gaskets loose their seal leading to a lean condition that makes it almost impossible to start, until bike cools down. Gaskets are cheap, this would be my first place to begin. Hope this helps.

JP

Feb 21, 2009 | 2000 Harley Davidson FXDWG Dyna Wide Glide

1 Answer

Clutch issue yamaha


That's just clutch drag. The parts turning in cold oil will spin the rest of the clutch if there is no force stopping them, like having the wheel off the ground. It is much less pronounced with warm oil, but it is always there in a wet clutch system. Nothing to worry about.

Nov 10, 2008 | 2005 Yamaha FZ6 Fazer

Not finding what you are looking for?
2006 Yamaha YZF-R1 SP Logo

503 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

dhnguyen

Level 2 Expert

281 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1147 Answers

Tony

Level 3 Expert

2600 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...