Question about 2000 Suzuki GSX 1300 R Hayabusa

Open Question

I have a 99 hayabusa and she is misfiring till 3000rpm and after that the ride is smooth. Dont know what the fault is... I have installed new plugs, coils & fuel filter

Posted by on


2 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 22 Answers

SOURCE: Misfire

Not familiar with the bike but if its carb'd, you have clogged jets. Simply pull the carbs and clean them. If its EFI. . . you've got a clogged injector(s). They can be cleaned but more times than not, if you run dirt through them you'll never get them working right again.

Posted on Jul 27, 2010


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

P0300 2002 GMC denali

Hi the last digit is 0 this means its detected a fault but it does not know why the misfire is if it had 1 at end it would be sparkplug 1. and so on. 0 could mean there is a problem with the timing or there is something wrong with the coil pack , coil pack it could be a fault at the plugs or the wiring. if you remove the spark plugs and the one or 2 that don't look right, investigate them, make sure there is no problems with the case of the coil pack. color of the connections and the case cover no cracks or splits. it can also be blocked jets this can limit the fuel into the engine and cause the same fault.

Jul 07, 2017 | GMC Denali Cars & Trucks

1 Answer


gizzer 1.0, I am haveing that same concern I would like to know this to, I also thought it was ckp, that let the ecm know the position of the crank fire order and spark, also cut off momentary with killing the enginealso missing one or two cylinders so reverlution during cruise also gos away and comes back on it own gas milage gose down during this perioed, when runs good , it is smooth! I would like to know.

Apr 13, 2011 | 1999 Suzuki GSX 1300 R Hayabusa

1 Answer

Having an issue with my '06 Hayabusa's drain plug leaking. I have changed it twice now & it is still leaking. Anyone have a solution for me.

If it has been changed and I assume with a new gasket, there may be some damage to the thread, stripped or cross threaded.

Some mechanics will know of oversize sump plugs to fix this, or a thread insert is another option.
Dont try a quick fix with thread tape or anything else, cause if it comes out while your riding, it can cause some engine damage, or get oil on your tyre and crash.

Aug 23, 2010 | 2006 Suzuki GSX 1300 R Hayabusa

1 Answer

My 400 ss is reving high when it is warmed up

First check entire length of throttle cable for kinks, crimping or binding. (especially near steering head) Check function of twist grip, it must rotate smoothly and spring back when released. Ensure choke is turned off after initial warm-up. If no change, turn out idle screw fully,(owner's manual refers) start bike and keep throttle at idle speed and screw in idle screw till it engages.

Apr 17, 2010 | 1992 Ducati 400 SS

1 Answer

Replaced complete distributor and now cylinder

Yes it is possible to be a tooth off or more and still run but if one cylinder is misfiring then it may be a bad plug or plug wire pull that plug and see if it is worn out and try replacing the wire first. if the plug has a wide gap that can cause it to misfire. you may have a bad injector too but don't know for sure. This is one of them questions that need to be looked at physically to know for sure.

Mar 25, 2010 | Chevrolet Astro Cars & Trucks

2 Answers

91 Miata Misfires. Change coil pack. still misfires. what could be other possibilities why

Oil filter might be clogged or your engine could be getting too much gas...check your spark plugs too...

Jun 03, 2009 | MTX Ford Explorer/Mercury...

1 Answer

My 2007 450F Yamaha won't start when it gets hot? Valves are in spec, went thru the carb, all clean??? Put a new hot start on too..still no workie?

hi there matey,, if she starts perfect wen shez cold ,,and u ride her up the road till shez hot,, does it start misfiring while u are riding it,then a quick check will be needed, if it does misfire then soon as she misfires while riding,,kill the engine and wip out the spark plugs and check wot the colour of the plugs are,, they should be a biscuit brown colour ,,either 1 and 4 plugs or 2 and 3 plugs will be the same ,, if say 1 and 4 are not a brown colour then u need to change that coil to 1 and 4,, at the end of the day mate ,, if she doesnt start wen hot ,,its usually a coil that is the prob,, any more help u need come back,, cheers

Mar 24, 2009 | 2004 Yamaha FZ6

1 Answer

99 Volvo S70 T5 Lagging

your friend is on the right track, it does sound like it cvould be spark plugs but get the codes read as well, it is very common for coils to go out on those cars which will also give a misfire and lack of power.

Oct 14, 2008 | 1998 Volvo S70

Not finding what you are looking for?
2000 Suzuki GSX 1300 R Hayabusa Logo

Related Topics:

232 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts


Level 3 Expert

80417 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4988 Answers


Level 2 Expert

83 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides