-
Expert
54 Answers
- Posted on Dec 10, 2010
Re: How do i remove the hub assembly from the front wheel...
Jack
up your Dodge Ram. Block the wheels to keep it from rolling as you
work. Get started by removing the first tire and wheel assembly. Remove
the hub extension and the brake caliper as well as the caliper adapter.
Remove the grease cap, cotter pin, nut lock, nut, washer and
outer wheel bearing. Now, pull the old rotor off of the spindle. Clean
the area with a damp cloth to remove any debris. Pack the wheel bearings
with grease.
Install the new rotor and hub onto the spindle. Replace the
outer wheel bearing, washer, and then the retaining nut. Torque the nut
to 30 to 40 ft. lbs. while rotating the hub and rotor.
Then tighten the nut and install the nut lock and a new cotter pin.
Clean the grease cap and then coat it with new wheel bearing
grease and replace the cap. Put the caliper adapter back into place and
then tighten the two mounting bolts with a torque wrench. Install the
wheel and tire assembly.
Repeat this process for each additional rotor and then lower the vehicle. Tighten the lug nuts and test drive your Dodge Ram to make sure that the installation was successful.
If I've helped, please vote!
×