Question about 2007 Suzuki DR-Z 400 SM

Open Question

I have a drz sm 400 2007,i want to put on new tyres,what do you recomand?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 2336 Answers

SOURCE: Suzuki DRZ 400 S Horsepower Rating

S/SM 35 hp

Posted on Nov 10, 2008

Ad
  • 2336 Answers

SOURCE: suzuki drz 400sm

They should be around 33hp at the rear wheel. They should wheelie ok, though you will need to try a bit for decent ones.

Posted on Nov 10, 2008

  • 3567 Answers

SOURCE: hi i have a drz 400 sm which will only start and

USA vs.UK. > I think you are saying the bike will only run with the choke on. Remove the water trap bowl at the bottom of the petcock, (gas valve). Is there any water or trash in the bowl? Drain a cup of gas from the tank. Is there any water or trash in the cup? Dump it, clean it and re-mount it, ( not all bikes have a water trap bowl ).

Drain the carburetor. There should be a screw on the lower side of the carb float bowl. Remove the screw then replace it after the fuel drains. Turn the gas back on and wait a minute for the carb to fill with gas. Install a new stock NGK spark plug and try to start the engine. If the bike doesn't start and run properly then shut off the gas and remove the carburetor from the engine.

Remove the float bowl and clean the entire carb with a spray carb cleaner from the auto parts store. Wear protective goggles to avoid getting spray in your eyes. Spray into all the little airways and fittings in the carb. Remove the idle screw and the air screw on the outside throat of the
carb and spray into the screw holes as well.
< < READ CLOSELY > >
Be sure to put these two screws back in the same hole they came out of. IMPORTANT > do not tighten these two screws down. Only screw these in until they LIGHTLY seat. Now turn each screw one and one half turns outward. Put the rest of the
carb back together, clean the air filter and install the carb. Let the float bowl fill then start the engine. This process should get you back on the road.

P.S. What do ya'll mean when you say " the bike is on a D plate ". Different letters are used. I am in Dallas Texas USA

Please rate this solution. Cheerio!

Posted on Apr 20, 2009

jmgldsmth
  • 1889 Answers

SOURCE: 2005 DRZ 400 Will not electrically start

replace your "Tired" battery it is not putting out enough amps

Posted on May 05, 2009

  • 12 Answers

SOURCE: drz 400 sm starts but i cant give it any gas or it dies

Can you slowly increase the revs? It sounds like an accelerator pump or debris in the carb.

Posted on Jul 31, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the best place to put the solinoid on a drz 400


Hi Darrin, for more information about your issue, please visit the websites below, and for specific information or questions, please feel free to contact me at xlch@mail.com. Good luck and have a nice day. 2007 Suzuki Motorcycle Service Repair Workshop Manuals

Mar 23, 2012 | 2007 Suzuki DR-Z 400 SM

1 Answer

2006 drz 400 will not start right up and once started sometimes it tries to shut off while riding


motor may have low compression or the carb has dirt in the jets or floats are messed up my guess is floats

May 06, 2011 | 2006 Suzuki DR-Z 400 SM

1 Answer

I have a 52 plate suzuki DRZ 400 SM and sometimes


Get yourself some " Contact cleaner" aerosol to clean the contacts in your ignition barrel. Access should be fairly easy if you remove the headlight and fairing.
Sounds like you have been in mud or dust, contamination has most likely got into the switch.
Check and clean the kill switch on the handlebars while you are at it.
Happy Trails!

Mar 30, 2010 | 2007 Suzuki DR-Z 400 SM

2 Answers

Drz 400 sm starts but i cant give it any gas or it dies


Can you slowly increase the revs? It sounds like an accelerator pump or debris in the carb.

Jul 09, 2009 | 2007 Suzuki DR-Z 400 SM

1 Answer

2005 DRZ 400 Will not electrically start


replace your "Tired" battery it is not putting out enough amps

May 05, 2009 | 2007 Suzuki DR-Z 400 SM

1 Answer

Changing the oil on a 2003 suzuki motorcycle


1700 ml oil used in this Bike.

For more information use the link:
http://www.motorcycle.com/manufacturer/suzuki/2005-suzuki-drz-400-sm-18268.html

Mar 15, 2009 | 2003 Suzuki DR-Z 400 E

1 Answer

Seat removal


Pull out the 2 rear seat bolts, lift the rear an inch or two and slide it rearward.

Nov 10, 2008 | 2006 Suzuki DR-Z 400 SM

1 Answer

Suzuki drz 400sm


They should be around 33hp at the rear wheel. They should wheelie ok, though you will need to try a bit for decent ones.

Nov 10, 2008 | 2007 Suzuki DR-Z 400 SM

Not finding what you are looking for?
2007 Suzuki DR-Z 400 SM Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers

Richard
Richard

Level 2 Expert

83 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...