Question about 2005 Honda CRF 250 R

1 Answer

Engine starts but stalls out when throttle is given

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 37 Answers

THE RIGHT AIR AND FUEL MIXTURE IS NOT REACHING THE CYLINDER,GET IT ADJUSTED BY A GOOD MECHANIC IS A SIMPLE PROBLEM SO SHOULD BE FINE

Posted on Nov 14, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

After washing engine on 2006 mustang gt codes p2104 p2111


P2104 is your throttle actuator. Probably wet the sensor. Try drying out with a hair dryer. P2111 is also a throttle code. Overnight the water has condensed and is affecting throttle position sensor.

Oct 25, 2017 | Ford Cars & Trucks

1 Answer

Car intermitantly stalls


Had this problem with a work van. It ended up being a faulty part. Apparently these vans have a safety feature that if you get rear ended the fuel is shut off and stops feeding fuel to the engine. My safety feature was faulty. Its really scary when your vehicle stalls while your driving down the interstate! I have the feature disconnected at the dealership, but not before I was in a bad wreck. Not sure if this is it, but why not check it out.

Nov 04, 2012 | 2001 Chrysler Voyager

1 Answer

2006 Envoy stalling when idels and won't stay running


Clean your Throttle body and pay attention to the Idle Air Control (IAC) valve passageway to try to clean the IAC. A dirty or faulty IAC will cause your engine to stall at idle, the job of the IAC is to open the passage way through the throttle body to regulate the amount of air to enter the engine to keep it from stalling when the Envoy is at idle.

Start with the simple and clean the throttle body and inspect any loose or damaged wire leads to the throttle body. Replace or repair any signs of damage.

Thank you for using Fixya and good luck.

Apr 10, 2010 | 2006 GMC Envoy Xl

1 Answer

My honda activa doesnt have pick up. when i keep in choke it runs properly otherwise. i had given it for servicing they replaced airfilter but still it is not working properly


What your doing with that sissy queen bike, get a rat rod bobber or a 5150 hard knock


does your scooter makes a loud noise, then stalls when I'm riding it. What's happening?

You're flooding the engine out. Read the manual and break it in before doing full throttle runs. After the scooter has been properly broken in, you can accelerate to the speed you wish to ride, then back off of the throttle to maintain the speed. If you hold the throttle wide-open, it will flood the engine and stall the scooter which may cause damage.

Dec 13, 2009 | 2005 Honda Activa

1 Answer

98 Camaro 3.8 V6 stalls when started w/cold engine


Sounds like your throttle body and throttle plate are full of carbon.You also have a idle air control motor with a pintle on the end that gets carbon on them.Go to your local parts store and get a can of throttle body cleaner and a old tooth brush and clean throttle body and plate and if you can remove the IAC and clean the pintle and bore. that should take care of your stalling.

Nov 05, 2009 | 1998 Chevrolet Camaro

1 Answer

2003 toyota avalon gets check engine light and goes when idleing


Take the car to a local Auto Parts Retailer, and have them check the fault codes on your on-board computer. Given the year of your car, it is probably an OBD-2 type computer. They can print out whatever the computer diagnostic says the problem is. I am going to guess the throttle position sensor is to blame since it sounds just like what my sister's Mazda Mommyvan was doing.

Feb 22, 2009 | 2003 Toyota Avalon

Not finding what you are looking for?
2005 Honda CRF 250 R Logo

Related Topics:

132 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4753 Answers

yadayada
yadayada

Level 3 Expert

78289 Answers

bazzz7071
bazzz7071

Level 2 Expert

342 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...