Question about 2008 Harley Davidson FLHX Street Glide

1 Answer

How do I REMOVE the fuel guge from a streetglide ?

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 4,565 Answers

If the gauge is built into a "cap" on the top of your tank, it's held in by an 0-ring. Carefully wiggle the gauge side to side and pull up. The wires from the gauge sender unit are very short so be careful. If you need to take the sender unit out, remove the five screws and lift the sender unit. As you lift it, carefull turn the unit allowing it to come out of the tank. It's a real pill, believe me. Do not bend the rod.

Posted on Nov 07, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

The fuel gauge,, odometer, and temp guge are flickering when the car is off

I would check all ground and positive connections. If this doesn't show improvement, I would say possibly a bad cluster unit. Thanks.

Mar 09, 2016 | Cars & Trucks

1 Answer

How to fix sinotruk howo air pressure guge

they all do when you use air . we can not look it over for leaks but you can soapy water squirted from a bottle along the lines will make bubbles

Nov 20, 2015 | Air Tools & Compressors

1 Answer

How do you replace the carb gasket on a 2007 streetglide

Actually, your bike is fuel injected, not carbureted.

That said, remove what you need to that's in the way, unbolt throttle body (the part that looks like a carb) from the intake manifold, R&R gasket and reinstall.

May 21, 2014 | 2008 Harley Davidson FLHX Street Glide

1 Answer

Kangoo fuel gauge keeps on flashing

I think but sure without a play myself and that is you need a new head unit ,the back of the speedo unit is full of electronic gizmo ,well it is a renault after all

May 02, 2014 | 2007 Renault Kangoo 1.4

1 Answer

How do i get old gas out of streetglide tank w/fuel inj.

There's a few options.

One of these (kinda pricey, though):

Or, go the dealership and get a new gas line fitting that plugs into the gas tank fuel valve, add a hose, and do the same thing
NOTE: Both of these options require the ignition to be on to power the fuel pump.

Next, one of these:

Finally, siphon out what you can by a hose, then remove tank and pour out the rest.

Dec 10, 2013 | Harley Davidson FLHX Street Glide...

1 Answer

2009 Harley Davidson streetglide running rich

Hi Anonymous, need to know if you are carburated or fuel injected. Thanks

Btw, I’m available to help over the phone in case u need at

Nov 20, 2013 | Harley Davidson XL 1200 S Sportster Sport...

1 Answer

How do you reset the computer in 1999 cadillac deville

that would be the sending unit in the fuel tank

Aug 31, 2012 | 1999 Cadillac DeVille

1 Answer

Hi i have a chevy van 1989 my problem is that i cant get any light on the speed guges or on the shifting guges

Make sure that you have not turn the dash light switch to far to have blacked out gages

Jan 22, 2010 | 1989 Chevrolet G20

1 Answer


most likely HUD (speedomiter/ tach/ fuel guge) it is either power to the dash cluster or the back light for it.

Aug 03, 2009 | 1990 Toyota Camry

1 Answer

Fule guge

HI, you will need to replace the sending unit that is located inside the tank. this unit is part of the fuel pump assembly and it sends the level of the fuel to the gauge, via wire transfer. there is a floater that is attached to the pump assembly, and it is damaged. replacing this sending unit will fix this issue.

May 19, 2009 | 2004 Jeep Wrangler

Not finding what you are looking for?
2008 Harley Davidson FLHX Street Glide Logo

193 people viewed this question

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts


Level 2 Expert

384 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

5809 Answers


Level 3 Expert

4356 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides