Question about Honda CB 350 F0 Motorcycles

1 Answer

Hello, I have a 72' honda cl350 twin. I put on new boots for the carbs because I had an airleak but now it bugs under acceleration. It does not want to go above the idle rpm. If I hold the throttle all the way down I can just hear the carb sucking but no change in the rpm. Any suggestions? Thanks.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 42 Answers

Take the carbs off the bike, then take them apart.

Unscrew the jets from the carbs.

The jets have a long brass needle that moves up
and down when you twist the throttle.

The jets have three sets of holes, idle orifaces, midrange, and
full speed.

Take a very fine piece of wire and poke through each oriface to
remove varnish.

Hold the jet up to your eye so you can see through each oriface.

Check to make sure float level is correct.

It's best to replace the float needle.
The needle will have a rubber tip on it.

If you do this, your bike will be good to go.

I hope I have helped you.

LeRoy

Posted on Nov 08, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

86 Honda shadow vt500c. Recently cleaned Carb new spark plugs fresh gas. After third gear when I accelerate it loses power and bogs down really low. Thoughts?


been doing this a long time and the vt's and vtx's 500 and 600 are stressing. the carb is your problem, high speed (main) and needle tube are not getting what they need. if needle is adjustable or washer is missing under the needle and or fuel air mix is wrong. really there is no real science to carbs. check it tweak it try again.

May 09, 2015 | Honda Motorcycles

1 Answer

02 honda shadow vt750cd backfiring, sluggish acceleration


Sounds like you need to have the carb jets cleaned. You can try seafoam that you add to fuel tank and ride it to see if that will clear it up, but I have had the same problem with my VF750C Honda Magna with only 8000miles and mine turns out to be fine tuning the injectors. This is only after the carbs have been reworked and cleaned.

Mar 28, 2013 | 2002 Honda VT 750 CD Shadow A.C.E. Deluxe

1 Answer

Wont accelerate


check under the plastic where the air box snorkle sits. Sometimes the foam jams up under there and plugs off the air box. if not that check your air boots on the carb. they are famous for cracking and sucking in to much air.

Jun 08, 2012 | Polaris ATV

2 Answers

My RAM 100cc quad bike wont start. iv checked the flow of fuel into the carb and it all seems okay and the spark plug is sparking. The electric start button doesnt work though and when i kick start it...


You need to check if there is any leaks from the carb to the motor. Make sure the carb is clean. An airleak could prevent the motor from starting as well as checking the carb itself ....the floats the jets things in that nature.

Feb 13, 2010 | 1989 Honda CBX 250

1 Answer

Replaced diaphram and gasket between tank and carb


This sounds like an airleak between the carb and the engine acting like the throttle is open.. Try and take some carb cleaner and spray it where the manifold bolts to the engine if you hear the engine bog or lower the rpm's then replace your manifold gasket should fix this problem

Apr 27, 2009 | Briggs & Stratton Briggs Stratton Intek V...

4 Answers

05 750 brute force missing badly


Just had same problem. Take carbs off and clean all jets and bowl. Be carful front and rear carb have different sized jets. When you put quad back together put entire airbox together even the cover. This quad will backfire unless air box is complete. I bet you anything your carb is full of trash.

Jan 22, 2009 | kawasaki Full Suspension Mountain Bike Men

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

186 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75197 Answers

Gino Cussen
Gino Cussen

Level 2 Expert

216 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...