Motorcycles Logo

Related Topics:

Posted on Nov 02, 2010
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

Bike will not start, Carbs flood ok but on inspection two plugs are dry one cylinder is flooding.I cleaned the carbs but stil no joy?

2 Answers

Anonymous

Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

Governor:

An expert whose answer got voted for 20 times.

Scholar:

An expert who has written 20 answers of more than 400 characters.

  • Expert 134 Answers
  • Posted on Nov 02, 2010
Anonymous
Expert
Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

Governor:

An expert whose answer got voted for 20 times.

Scholar:

An expert who has written 20 answers of more than 400 characters.

Joined: Oct 30, 2010
Answers
134
Questions
0
Helped
45316
Points
291

Clean the carbs again, pay special attention to getting the float needles and seats clean and free of tarnish and debree buildup. Make sure the pilot jets and main jets are clear. Use a good spray carb cleaner and air, do not use a wire.

  • Anonymous Nov 02, 2010

    Also make sure the float levels are set correctly.

×

Anonymous

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

  • Contributor 1 Answer
  • Posted on Jul 10, 2011
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Joined: Jul 10, 2011
Answers
1
Questions
0
Helped
322
Points
1

My quad will not start its got petol and spark the timming is ok wiring ok cdi unit is working

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

How to fix starting pronlem

Hi , you need a full carb cleaning. Have them removed from the bike, desassemble and clean them ( ultrasound cleaning would be great) . Also replace the spark plugs (as you d'ont know their milleage).
Good work!!
0helpful
1answer

Bike has been stored 3 months & now won't start & run.Appears to be flooding.Ran fine when parked.Pulled,drained tank,put in new gas,same results

Hi try draining the old fuel from the carbs their is a small drain screw on the bottom of each bowl, you may need to clean and dry the spark plugs because bad fuel won't evaporate.
Apr 09, 2015 • Motorcycles
0helpful
1answer

Why FZR600 seems to lose two cylinders while driving, carb or spark problem?

if carbs are clean and not flooding etc then try finding out which cyls are off then swop plug caps over from good cyls and see if problem moves , if yes then fit a set of 4 new plug caps ! if no then do carbs again !!
0helpful
1answer

My bike is hard to start battory is fine starter is ok altinater puttting out 14.4v ok but is very hard to start but when started it seams to run ok any awnsers

Assuming your bike has carbs, drain the carbs. Clean the air filter, install new spark plugs. don't go nuts twisting the throttle. Too much and the engine will flood.
0helpful
1answer

Great acceleration at top end until after 10 15 miles and then around town-- get on throttle--seems to be not accelerating near as clean and motor sounds different--bike also starts without choke and needs...

Very possible, you may need to find out if one of the carbs is flooding or jets have been switched. Check plugs to find out rich cylinder, it will be black with soot and others clean. Also choke could be on all of the time. need to check cable and where it attaches to carbs to make sure full off position is achived.
0helpful
3answers

Not sure what happened i started my 97 cbr600f3 ran it on choke for about 45 sec. it started to die,so i eased the choke off it died and havent been able to fire it up since.any suggestions

Remove plugs to see what colour they are. If sooty then too rich / clean / install.
If wet then flooded, dry refit.
If clean and dry, starving lack of fuel.
0helpful
1answer

Had a problem with one cylinder flooding and

jets sound like they are worn blocked or similar. you might have to clean it all again or try fuch's pro fst to clean them up. have you vacuum balanced them?
0helpful
1answer

Keeps flooding

The carbs need a full cleaning....use piano wire of the right size for the jet holes.....Carb cleaner and compressed air to blow out the fragments.
0helpful
1answer

Gas flooding cylinder

i would pull your carbs, clean them and look for wear on your diaphrams and check your floats.
0helpful
1answer

When start bike up,it runs on 4 then onto 3 then 2 then cuts out.have stripped carbs rebuilt,balanced them.new plugs.runs fine till warm,think may be fuel problem. changed fuel tap.ballenced carbs with 2...

Are the cabies flooding or runing out of fuel? pull the choke on dose it help if it does low fuel.

Drain the bowls and see if there is plenty of fuel.....If its flooding turn the fuel off or block it when the engine starts to drop clys if it starts to pick up after 10secs or so the carbies are flooding
Not finding what you are looking for?

332 views

Ask a Question

Usually answered in minutes!

Top Triumph Experts

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Sean Wright
Sean Wright

Level 3 Expert

2045 Answers

Mike Cairns
Mike Cairns

Level 3 Expert

3054 Answers

Are you a Triumph Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...