It means its due for service. If u wanna get rid of it without servicing the vehicle then as you start the car simultaneously push the ODOMETER reset button on the dash and it will wipe it. This will however just delay the point your car needs servicing.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Locked stereo in 1995 Holden Barina My battery went flat in my barina and now the ... Just changed the battery in a 2001 Holden Barina now there is no power just ... fuses should be in the box under the hood, there will be a diagram showing ... a 1984 gmc jimmy s15 fuse box located? the fuse box should be located near or ...
Apr 19, 2013 - 2002 Holden Barina from Australia and New Zealand - Comments ... The relay is in a box with a plastic cover on the left side (passenger) beside ... Hi, your Combo problem is the MAF sensor located near the air intake ... Hi I was hoping youfound the problem to your car, as my daughter's 2001 XC Barina is ...
That sounds like a TPMS (Tyre Pressure Warning System) Light. If that's the case check your PSI by blowing tyres up to recommended PSI levels (this will be on your doors) or resort to owners manual.
Alternatively check this guide on all dash lighting http://www.carbuyer.co.uk/tips-and-advice/152578/car-dashboard-warning-lights-the-complete-guide OR
You need to carry out the periodical car service due (e.g. engine oil & filter, air filter, fuel filter, cabin air filter). The "service" spanner symbol "reset" button is placed on the lower right corner of the dashboard. See picture below:
Then you should reset the "service" spanner symbol by pressing on the "reset" button on dashboard, when ignition key is in OFF position. Hold the button pressed and turn ignition key in ON position. Hold the button pressed and see on the dashboard successive numbers will appear: "10", "9", "8", ... , "1", "0". Then release the button and switch OFF the ignition key. The "service" spanner symbol followed by "20000 km" (or "30000 km" depending of the engine type), will appear for few seconds after turning ignition key in ON position, and will dissapear after engine starting. The car service due was reseted.
engine symbol comes up on dashboard for holden astra
egr valve on a holden barina
where is the bonnet release for a holden barina 1999
what is an easy fix
×