Question about 1993 Harley Davidson XLH Sportster 883 Hugger

1 Answer

Remove 1995 sportster seat - 1993 Harley Davidson XLH Sportster 883 Hugger

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 134 Answers

Providing that it is a stock seat, remove the screw at the back of the seat, (in the center of the fender), lift the rear of the seat and pull the seat towards the rear of the bike.

Posted on Nov 04, 2010

Testimonial: "Thank you for your update. Actually it is not a stock seat so I had to lift the seat alittle and there the screw was. Thanks again, Jim"

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you get the seat off a 2008 Harley Davidson Sportster to change the battery


Hi, Jim seat removal can range from the simple and obvious to the complex and baffling for the novice new Harley Davidson owner. Seems like the more expensive the bike is the harder it is to remove the seat. So let's start with the most expensive. 99% of all Harley seats have a male tongue in the front that slides into a female receiver that is either bolted or welded to the frame just behind the fuel tank. For this reason, whenever you are removing a seat you must always slide it backward 3-5 inches For Heritage Softails check for a bolt on each side usually under a flap on the seat. Then there is the seat strap that is secured on both sides, only one side needs to be removed. A single screw can secure it to the rear fender or it may have a bracket with two studs secured by nuts or knobs to fasten the rear portion of the seat. For Sportsters if you have a pillion pad or passenger seat that snugs up against the front seat there can be a screw securing the two to the rear fender, you have to get your hand in between the two seats and force the separation of seat material to see and gain access to the screw. For Touring bikes, there is the rear seat screw in the back that is the caboose of seat fasteners, usually a large chrome bracket, that screws into the rear fender. Care must be exercised in covering this shiny bauble with your hand during the sliding back procedure so as to "NOT" scratch the tour pack. So when all the hidden and mysterious fasteners have been removed, you need to lift it up in the rear, slide it backward a few inches and bingo you have mastered the impossible.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below and for more specific information or questions at no charge please feel free to contact me at xlch@mail.com. Good luck and have a wonderful day.
Harley Davidson Battery Install on Sportster 1200
https://www.carlsalter.com/pdfs/harley-davidson-2010-sportster-service-manual.pdf
http://partsfinder.onlinemicrofiche.com/ronnies/showmodel.asp?make=hdmc
http://mybikemanuals.com/harley-davidson/2008-harley-davidson-owners-manuals
Instant Tech Relief To speak with me personally absolutely "FREE"

Apr 02, 2017 | 2009 Harley Davidson XL 1200C Sportster...

1 Answer

How do I change the seat retainer in my 2005 harley sportster?


Hi Anonymous, for more information about your question please visit the websites below. Good luck and have nice day.
Remove the Stock Seat Install Danny Gray Solo Seat on Harley Davidson...

Apr 07, 2013 | 2005 Harley Davidson XL 883C Sportster...

1 Answer

How to change a battery on a 2001 harley davidson sportster?


REMOVE SEAT, REMOVE 2 BOLTS KEEPING IGNITION IN PLACE. REMOVE UPPER BATTERY CASE COVER. REMOVE NEGATIVE TERMINAL FIRST TO PREVENT ARCING POSITIVE TERMINAL INTO FRAME SOMEWHERE. NEG THEN POS. REMOVE BATTERY, REVERSE TO INSTALL AND THERE YOU HAVE IT FOLKS.

Sep 02, 2012 | 2004 Harley Davidson XL 883 Sportster

1 Answer

1995 harley sportster leaking fuel from carb


Hi Anonymous, and the usual suspects are:
1. Damaged or restricted fuel tank venting system.
2. Loose float bowl screws.
3. Damaged float bowl o-ring.
4. Improper fuel level in float bowl.
5. Worn or dirty inlet valve or seat.
6. Damaged or leaky float assembly.
7. Particle contamination in inlet fitting cavity.
8. Ethanol sludge, dirt, rust in bottom of fuel tank
Good luck

Aug 01, 2012 | 2003 Harley Davidson XL 1200 C Sportster...

1 Answer

How do you remove the seat?


Remove the screw at the rear of the seat. Pickup on the rear of the seat and hammerfist the center of the seat with your other hand, sort of forcing it both down and forward toward the tank. There is a post that holds the seat in place that fits into a church key style slot in the seat. You just have to force the seat forward enough slide it out.

Feb 25, 2012 | 2011 Harley Davidson XL 883L Sportster 883...

1 Answer

I just want to change the battery on my sportster ,1200, 2002 how do i get the seat off, or do i need to?


yes, you really need to remove the seat. Although I am not familiar with your particular model, most Sportster seats are held on by a single bolt screwed into the rear fender at the very back of the seat. Remove the bolt, lift the rear end of the seat slightly, and pull it to the rear. There is a tang on the front of the seat that slips under the frame. Once out, you should be able to see the battery and the strap that holds the top battery cover down. Loosen the nut and remove the hold down strap and battery top cover. Remove the rubber strap that holds the battery into the tray. Disconnect the negative cable first when removing the battery. When installing the battery connect the negative cable last.

Good Luck
Steve

Dec 01, 2010 | 2000 Harley Davidson FXST Softail Standard

1 Answer

How do i take the seat off


Providing that it is a stock seat, remove the screw at the back of the seat, (at the center of the fender), lift the back of the seat and pull the seat towards the rear of the bike.

Oct 15, 2010 | 2001 Harley Davidson XL 1200 C Sportster...

1 Answer

How do I remove the battery from a 2004 Custom 883 Sportster? Have been able to loosen it by removing the bracket on the left hand side, but terminal is still connected on the right, and can't get to it...


Take the seat off and go in from the top of the battery with a 10 mm wrench. That ought to get it unless they changed something. I can't say that I've worked on that particular model but most Sportsters are like this.

Jun 10, 2010 | 2004 Harley Davidson XL 883C Sportster...

Not finding what you are looking for?
1993 Harley Davidson XLH Sportster 883 Hugger Logo

Related Topics:

309 people viewed this question

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4535 Answers

Mike

Level 3 Expert

4340 Answers

yadayada
yadayada

Level 3 Expert

76630 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...