Question about 2008 Keeway Arn 150

Open Question

I cannot find the spark plug on my keeway arn 125 scooter were is it located ?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 3567 Answers

SOURCE: keeway superlight 125 adjusments

Pull the slide out of the carb then move the clip on the jet needle down one or two notches. This will richen the low range fuel mix. You can also get a rear sprocket with about 4 more teeth. This will get you off the line and out of the corners faster BUT it will also lower your top speed.

Please rate this solution. Thanks supergunner!

Posted on Apr 17, 2009

Ad
  • 1 Answer

SOURCE: Where is the VIN on my keeway hurricane?

if you look down from the handle bars to where your feet go you will see a little rectangle on the plastic, if you pop this off the VIN is underneath

Posted on Jun 01, 2009

  • 99 Answers

SOURCE: i have a 2007 keeway arn 150cc scooter i got alot

first of all, was the bike running, then parked for a signifigant period of time? if so, the first thing your going to want to check is the fuel system. theres a fuel hose running from the fuel tank to the carburetor. remove the fuel line from the carb to check the condition of the fuel. fresh gas has almost a clear look. if it appears to be fine, then proceed by checking the carb to see if there is fuel in the reservoir. at the bottom of the carburetor, there should be a small screw. turn it out counterclockwise to see if gas comes out from one of the overflow fittings on the carb. if it begins to leak, then you most likely have enough fuel in the carb to start it. if it comes out of the hose looking dark, or smelling kind of funny, then youll need to clean the fuel system. to do that, you must drain all of the old fuel, flush the fuel tank a bit with fresh fuel, refill it with fresh fuel, and also clean out the carburetor. if youve never done this before, i would reccommend having a technician do it for you. lost parts or mis-adjusted carburetors can not only cause mechanical damage, but also be a potential safety hazzard due to performance problems. if the fuel looks and smells fresh, then your going to want to check for ignition next. remove the spark plug from the cylinder head, attatch the boot to the top of the plug, make sure the electrode end is touching a good grounding point on the engine, and press the start button. BE CAREFUL on this step. if the plug sint grounded well, it could lead to you getting an electrical shock from the ignition system. its a good idea to hold the spark plug or boot with insulated pliers during this step, just as a precaution. while the engine is turning over, watch the gap on the spark plug end to see if there is a noticable spark. it should be fairly easy to hear as well. if there is spark, then your ignition system is most likely in good condition, so move on to the next step. if there is no spark, try this process over with a new spark plug. if the new one still doesnt spark, there is a problem with one of the components in the electrical system, and that should be further diagnosed by a certified technician.
I hope this helps you out a little bit. these are the first things that I would check. If you know the fuel system is in good condition, and you can see that there is a good ignition source, then you have a mechanical problem that would require more information to attemp to diagnose. if you have any questions, feel free to contact me. Ill be happy to further clarify or explain anything that I mentioned here.

Posted on Jul 28, 2009

omedilo
  • 4 Answers

SOURCE: manual for a keeway speed 125

Look for manuals here:

http://keewaysuperlight.blogspot.com/

Posted on Aug 02, 2009

omedilo
  • 4 Answers

SOURCE: 2 broken side panels for keeway superlight 125

Go to: http://keewaysuperlight.blogspot.com/ and you will see how to repair your Keeway Superlight panels with pictures and instructions.

Posted on Aug 04, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where in Kent UK can I get my Keeway 125 superlight cruiser converted from manual to automatic?


Hi, Ignis because I live in Florida the answer to this question is way above my pay grade for this situation, I would call or visit my local dealer or reputable shop's service/parts department and inquire about any possible quick fix, answers, or parts inquiry.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
Keeway Motor UK Learner Legal Motorcycles and Scooters
Used Motorcycles
https://pramellafo.files.wordpress.com/2015/07/keeway-superlight-125-service-manual.pdf
Keewayparts com Genuine Keeway Parts Shipped Worldwide
KEEWAY Speed 125 User Manual

Oct 20, 2017 | Keeway Motorcycles

Tip

KEEWAY MOTORCYCLES and SCOOTERS MANUALS


Hi.

Go to this page and download manuals for Keeway Motorcycles & Scooters.

KEEWAY MANUALS

There you have many manuals in different languages free for download.

Good luck to you all!


on Aug 21, 2009 | 2008 Keeway Superlight 125 II

1 Answer

My keeway superlight wont start , it turns over but just wont kick in any ideas?


Hi, Anonymous and the usual suspects are:
1. Fuel tank empty.
2. The fuel tank has old dead gas.
3. Fuel tank bottom contaminated with ethanol sludge, dirt, water, rust, etc.
4. Fuel supply valve/petcock turned off.
5. Fouled spark plugs.
6. Engine flooded as a result of overuse of the enrichner.
7. Vacuum hose to the fuel supply valve/petcock disconnected, broken, cracked, or pinched.
8. Fuel valve/petcock or filter clogged.
9. Fuel line to carburetor or throttle body pinched, kinked or blocked.
10. Carburetor float stuck.
11. Fuel injectors clogged.
12. Fuel injectors stuck open.
13. Severely discharged or a damaged battery should have 12.5 volts or more and be able to pass a proper "LOAD" test if necessary, you may have a cursory reading of 12.5 volts or more but little or zero amperage the battery is faulty and must be replaced, AGM batteries fail in this scenario more so than lead acid batteries.
14. Check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
15. Loose or corroded wire connection at the coil or plug between ignition sensor and ECM module.
16. Spark plug cables in bad condition and shorting check for spark leakage in the dark, cable connections loose, or connected to the wrong cylinders.
17. Ignition timing incorrect due to a faulty ignition coil, ignition module or MAP, CMP, CKP, O2, TPS, ETP, IAC sensors.
18. Faulty neutral, clutch lever, or kickstand safety switch.
19. Faulty fuel pump or fuse or relay.
20. A stuck bent or burnt valve.
21. Tilt sensor needs a reset.
22. Security system not disarming alarm needs a reset.
23. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
Basic chinese bike troubleshooting guide
Scooter Troubleshooting Scooter won start All about Scooters
KEEWAY SUPERLIGHT 125 150 SCOOTER SERVICE REPAIR PDF MANUAL DOWNLOAD 2006... $12
Keewayparts com Genuine Keeway Parts Shipped Worldwide
KEEWAY Speed 125 User Manual

Jun 30, 2017 | Keeway Motorcycles

1 Answer

My alarm indicator on my keeway superlite 125 is on what does it mean ?


Hi, Richard I would contact the folks that make the alarm or for this situation I would call my local dealer or reputable shop's service/parts department and inquire about any possible quick fix, answers, or parts inquiry. For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
KEEWAY Speed 125 User Manual
http://www.wemoto.com/bikes/keeway
KEEWAY SUPERLIGHT 125 150 SCOOTER FULL SERVICE REPAIR MANUAL 2006 2012...

Nov 21, 2016 | Keeway Motorcycles

1 Answer

Will a main stand for Keeway RKV fit onto Keeway Speed?


Hi, Make for this situation I would call my local dealer or reputable shop's service/parts department and inquire about any possible quick fix, answers, or parts inquiry. If necessary, transport your bike to the dealer or shop and have a professional technician take it for a test drive, if it is in running condition, and give you a written estimate of repairs and answer any specific questions you may have about your problem. For more information about your issue and valuable free downloads that you will need please visit the websites below. Good luck and have a nice day.
KEEWAY SUPERLIGHT 125 150 SCOOTER SERVICE REPAIR MANUAL 2006 2012 Download...
Quality Replacement Parts For Keeway
Keeway Speed 125 Parts
Keeway Speed 125 2010

Mar 01, 2016 | 2010 Keeway Speed 125

1 Answer

The Keeway Flash I have has not been started for a few months and when I tried to start it after charging the battery over night it still would not start. I have cleaned and re gapped the plug and even...


Hi.

Keeway scooters usually do not have kickstand switch. Check if there is one just in case. If there is kickstand switch bypass it.

Check fuel switch, fuel filter and hose.

Try starting with no fuel cap.

Check and replace spark plug.

Check carburetor oil and oil tube.

Check carburetor mixture and idle settings.

The carburetor needle may be clogged in some case the carb must be disassembled to clean part or regulate needle height. Unscrew the discharging fuel screw for the carburetor and check if there is fuel flow. If fuel flows test the ignition wiring , CDI and coils in the magneto.

I do not have the service manual for this scooter.

Here a service manual for a Keeway ARN 150, similar to Flash

Check the service manual tests and diagnostics are the same and wiring diagram is similar.

Regards.

Ginko

Oct 31, 2011 | 2008 Keeway Matrix 150

1 Answer

How to chane battery on keeway outlook 125


You have to remove the lid that covers the battery on the floor of the scooter. There are only two screws to be removed and the battery is exposed.

Apr 08, 2010 | 2008 Keeway Outlook 125

1 Answer

Can't get Keeway ARN to start


If you did not prep the bike for winter storage with Sta-Bil in your gas you might have some clogged carb problems You say this is a scooter but the description at top calls it a motorcycle. If it's a scoot then your engine and carb are underneath all that plastic your sittin' on.If it's a motorcycle your carb is right behind the engine between ur legs. It has a rubber gas line connected to it. Get some starter fluid from your local auto parts store and spray a short burst into the air cleaner and then hit the starter button. It should start but if it won't sit there and idle youv'e got a plugged card idle jet...time for a mechanic....next year prep the bike and disconnect the battery and you won't have to buy a new one....Good Luck !!

May 04, 2009 | 2008 Keeway Superlight 125 II

Not finding what you are looking for?
2008 Keeway Arn 150 Logo

Related Topics:

252 people viewed this question

Ask a Question

Usually answered in minutes!

Top Keeway Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers

Ron Stone

Level 2 Expert

197 Answers

Are you a Keeway Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...