Question about Gas Gas Pampera 320 Motorcycles

1 Answer

My bikes ticks over to quike. its sounds like the revs are stuck.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 186 Answers

Sounds like you have an air leak somewhere around the carb area.make sure carb,intake housing,and your engine head are bolted down tight

Posted on Oct 15, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

On start up bike makes ticking sound, also low revs, 1000-1500 revs on idle. Fan kicks in on short runs, hot under seat. sluggish when pulling away in 1st.


Hi, Chris I would love to help you with your engine or chassis noise but I just loaned my brand new pair of listening ears to your local dealer's chief technician so he could take your bike for a test ride and give you his professional opinion and estimate about your noise and repair cost. If you are a little short on "DRACHMA" and a Dealership is not on your list of fun places to visit then perhaps the list below will help soothe your worried mind so you can make an informed decision.
1. Bearings---SCREECH
2. Belts---CHIRP
3. Brake Rotors---BUZZ
4. Chains---RATTLE
5. Clutches---CHATTER
6. Cylinders---PING
7. Fronk Forks---Plunk
8. Gears---WHINE
9. Head Gasket---HISS
10. Hydraulic Lifters---TAP
11. Pistons---SLAP
12. Rear Shocks---SQUEAK
13. Shifting Trans---CLUNK
14. Solid Lifters---TICK
15. Starters---CLICK
16. Connecting Rods Go---KNOCK-KNOCK---who's there, it's me "*****"
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
2002 955i rs makes clicking or ticking sound
Loud ticking noise from engine Roadsters Model Range Forums Messageboard...
Triumph Daytona 955i 2002 Service Manual
Hermys Triumph Motorcycle Parts 2001 Triumph Tiger Genuine Motorcycle...
Triumph Daytona 955i Handbook

Jul 02, 2015 | Triumph Daytona 955i Motorcycles

1 Answer

06 ninja 650r. Im having a problem with power loss at high rpm. The bike isn't throwing codes. It has a ticking sound, the plugs are black so running rich. When I nail the throttle it shoots black smoke....


Hey. I does sound like valves are out of specifications. Does your bike start normally? If valves are out, you should hear it right away.

Dec 02, 2013 | Motorcycles

2 Answers

I have a 125 pit bike and it ticks over fine but when you rev it it backfires does any body no how to fix it.


You can check ur values but some bike do make a we ticking from the values and it will back fire when revved up because of the extra fuel once revved that hasn't brine burn as it revs back down to idle speed.

Jul 19, 2012 | Pit Bike 125cc 4 Stroke Dirt Bike

1 Answer

I have got a yamaha xvs 1100 dragstar classic 2005 model. it ticks over but as soon as i rev up it cuts out. what do you think could be the problem ?


check the fuel filters, it sounds to me as though there is a partial blockage which allows just enough to sustain tickover and starves the bike upon rev up. this is the first step to check and the most likely. good luck.

Aug 05, 2011 | 2006 Yamaha XVS 1100 Dragstar Classic

1 Answer

Hi i have a Daelim vee 125 evolution i bought 2 weeks ago and was fine for first week, the electric start has never worked since before i bought it so i have to kickstart the bike, it has all of a sudden...


Sounds like you have some kind of wiring short.Look at all wiring harnesses to see if there is a wear spot on wire sheild.Somwhere on that bike somthing is grounding out.Check wires from battery to motor and make sure there not bad.Sounds like the person who owened it before you was having electrical problems that why it has never started with starter.And now the problem has stopped bike completly.Do yourself a favor to rule out a spark problem.Remove sparkplug from engine, put sparkplug back in wire boot.Holding rubber boot touch and hold spark plug to head of bike.Make sure kill switch and key are in run position and kick bike over.See if sparkplug has crisp blue spark.If so you have a fuel problem.Then i would remove and clean carborator.But this definitly sounds like a short in wiring somwhere.Your gonna have to trace all wires to make sure there isnt a ground.Good Luck...

Mar 13, 2011 | Daelim VT 125 Evolution Motorcycles

1 Answer

The faults as followed... as soon as i hit over 9k revs, the revs shoot to 13k revs but no extra power is produced, now i hav the F1 light showing and once bike is warmed up, i switch off and on, and the...


i dont really understand your English Grammer and i know in this sentence a lone have probably made some errors toooo!! but it sounds to me like your clutch is slipping...the f i light is your fuel injection warning indicator telling you that its detected an error in the system..

Aug 03, 2010 | Honda CBR 600 F(4)i Motorcycles

1 Answer

Revss


sounds like you have a vacuum leak

Aug 20, 2009 | 1994 Suzuki Swift

1 Answer

Starts ticks over but won't rev


I had similar problem. I wound up taking the carb to a bike shop and letting them clean it. They had an ultrasound bath that they put it in. It's submerged in a solvent, then they shoot sound waves at it to loosen up stuff that a regular cleaning can't get to. After I did that, it ran like a top....For 3 1/2 years...Then I had to do it again.

Aug 04, 2009 | 2005 Yamaha Xv 250 Virago S

1 Answer

Ticking noise and general engine noise after burnouts...


If he was doing burnouts it could be multiple problems - overheating, too many revs, drivetrain hammered.
Certainly a lot of burnouts can cause overheating - no air and lots of revs gets things hot really fast!
High revs can result in camchain issues, piston/valves coming together, broken rings, siezed pistons, broken bearings, and much more :)
Sorry to hear this - I suggest a trip to a bike mechanic to get a diagnosis before it gets worse and costs you a packet.

Jun 28, 2009 | 2008 Honda CBR 600 RR

1 Answer

Kawi/nomadf1 1500 clutch will not engage.


hi it is possible that your clutch plates have stuck tgether does the clutch allow you to push your bike in gear if not then a quik strip and clean should sort this out
hope this helps

Dec 04, 2008 | 2000 kawasaki VN 1500 Vulcan Classic...

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

84 people viewed this question

Ask a Question

Usually answered in minutes!

Top Gas Gas Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers

Kim Halliwell

Level 1 Expert

32 Answers

Livewyre Studio
Livewyre Studio

Level 1 Expert

28 Answers

Are you a Gas Gas Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...