Question about Qianjiang QJ100T-5F Motorcycles

Open Question

The model number is QJ50Qt-5, How much oil should you keep in the scooter? There is no dip stick on the cap, there is screen inside the opening. Also, the second cap on the oil tank has wires and a float attached. Is this a interlock?, that if there is not the correct amount of oil this will not allow the scooter to start?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 43 Answers

SOURCE: oil level YZ 125

Hello....for the crank case you will want to use Yamalube 4 (10w-30) or an equivalent SAE 10W-30 SE motor oil. There is not a dip stick on the bike, Need to measure teh oil in accordance with Yamaha specs. You will need to check the owners manual or contact the local dealer service department and should be able to tell you how much needs to be added. If you don't have good 1qt mix cup you can get one at a good motorcycle shop. These are very help full in accurately measuring your premix oil for the fuel as well. Hope this helps

Posted on Apr 05, 2009

Ad
  • 1 Answer

SOURCE: where is the 2 stroke oil tank on a 74 yamaha rd 350.

exactly as you thought, under the seat.

Posted on Jan 14, 2010

  • 67 Answers

SOURCE: Oil Change to Honda CRF250r 2004

The left side is the ENGINE oil fill. The right side oil fill plug is THE TRANSMISSION oil. There are 2 separate drain plugs also. Honda sells an engine oil with moly HP4M that you should not put in the trans because it will cause clutch slippage. The best performance and protection for your bike is full synthetic engine oil with a dedicated gear oil in the transmission. Get yourself a manual so you will not be as confused

Posted on Feb 18, 2010

  • 409 Answers

SOURCE: How do you check the oil level on a 1986 honda V65

The dip stick is on the same side as the fill cap but toward the rear just behind the round part of the clutch cover, and screwed in at a downward angle. If I remember it takes about 4 quarts to do an oil and filter change on it.

Posted on Apr 02, 2010

sisadsl
  • 1508 Answers

SOURCE: Hi, yeh I just bought a vt 250 f 1985 today and

There is a small glass window to see the oil level though the side cover, it should also have the volume marked near it .
Change the oil regularly in those, some had big end problems.

Posted on Oct 15, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My super bronco CRT /w reverce does not have oil cap dip stick ?


Some people have tried several methods to see the oil when it seems nearly invisible.
One is to drill really tiny holes in the dipstick , and the oil will fill the holes where it is at that level.
Check with your local Troy-bilt dealer to see if a dipstick-cap is available,
God bless your efforts.

Feb 21, 2017 | Cars & Trucks

1 Answer

How much oil do I put in my car 19 00 cc


1. Turn off engine ,
2. Take of oil cap on engine
3. Put in a little oil in oil filler hole of engine.
4. then pull out the oil dip stick from engine
5. and clean the dip stick on a rag.
6. Put dip stick back in engine
7. pull out again and check the level showing on the dip Stick
8. If level is too low on dip stick and is not at full level go back to step 1

These steps ensures you avoid over filling the engine with oil

Tip for beginners
The 4 litre oil bottle is way too much oil for an engine to handle.
If you have a full 4 litre oil plastic bottle square shape . hold the bottle on its side to pour the oil out slowly and smoothly.

Jun 04, 2016 | 2005 Mitsubishi Carisma 1.6

1 Answer

Where is the oil dip stick located on 2002 cavalier


On most Cavalier motors the dip stick i s part of the filler spout you just remove the filler cap and pull the stick out with the cap. Make sure you check the oil with the motor shut off

Sep 23, 2014 | 2002 Chevrolet Cavalier

1 Answer

I have an old type 30 model ingersoll rand air compressor. It has not run for years, we just wired it up and ran it for about 5 minutes. After that, I thought I better check the oil level... There does...


Alot of the older units did not have a sight glass. They had a dip stick on the fill plug. Over the years they broke off or the oil fill plug was replaced with a newer type that does not have the dip stick. To answer your question dip stick or not I always fill with oil to the bottom of the threads on the fill plug. You should remove the plug and check the oil level before each use on and older unit like this until you have a good handle on how much oil it uses. you may also be able to remove a plug usually on the front of the case lower left side and install a sight glass or low oil level switch. Have a good day!!

Nov 12, 2011 | Ingersoll Rand - Rand Type - 30...

1 Answer

How do i refill the transmission oil in my 1997 Micra auto (1 ltr). Can't find the cap.


Hi: To Refill your Auto Transmission with Tranny Fluid, There is NO CAP, Look For a Dip Stick Similar to your Oil Dip Stick.You Refill your Transmission where the Transmission Dip Stick comes out of a Tube. You'll Need a Funnel that Fits inside the Transmission Dip Stick Tube. This Should Resolve your Question. Please Vote and That actually sends me How Well I have Helped You. OH Look Towards the middle to the Back of Your Engine to Locate Your Tranmission Dip Stick: From the WYOCWBOY

May 30, 2010 | 1996 Nissan Sentra

1 Answer

How do i change the oil on my 01 vw gti vr6


This engine requires synthetic oil, 5 quarts, and oil filter. Remove dip stick, remove oil drain plug at bottom of engine oil pan, remove filter housing, remove oilf filter and o-ring. Replace o-ring and filter, rub o-ring with some new oil, replace filter housing, replace oil drain plug, pour new oil in at top of engine oil cap, replace dip stick, start engine, run for 45 seconds, turn off, check dip stick to make sure oil is at correct level. You are done, recycle old oil.

Sep 19, 2009 | 2002 Volkswagen GTI

2 Answers

Where is the oil dip stick on a 2002 pontiac sunfire


should be near the front of the motor, twist off pull out looks like a fill cap

Mar 19, 2009 | 2002 Pontiac Sunfire

2 Answers

Genral oil change


Look for the oil dip stick. Now look under underneath the area of bike where the dip stick is. You'll see a round disc with a bolt. That is the drain plug. Now you found it lets begin.
1. Warm the bike up.
2. Turn bike off.
3. Take oil dip stick out.
4. Have your oil pan under the bike
5.. Unbolt drain plug. A spring and screen will come out keep them together.
6. After oil finished draining. Make sure Screen is clean before replacing back in with the spring.
7. Start the bolt in by hand then finish with tightening with socket.
8. Put oil dip stick back in. you're ready to go!

It takes 15W 40 ( .9 liters) Don't forget to press yes if this was helpful : )

Nov 10, 2008 | 2005 Kymco Grand Dink 250

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

151 people viewed this question

Ask a Question

Usually answered in minutes!

Top Qianjiang Experts

TEKUSER
TEKUSER

Level 2 Expert

80 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4521 Answers

GQ-ROD

Level 3 Expert

635 Answers

Are you a Qianjiang Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...