Question about 2005 Suzuki GSF 650 N Bandit

1 Answer

Got a 650 bandit k5 clocks gone off when battery recharged they come back on briefly any suggestions

Posted by on

  • vaughan Gibson Oct 14, 2010

    i have put a new battery on fully charged and the clocks worked fine then the next morning the clocks were off again and the battery had lost a lot of charge, its as if the clocks dont work when starved of electricity.something must be making the battery lose its charge.

  • vaughan Gibson Oct 14, 2010

    put a new batt on and the clocks worked again the next morning the batt had lost a lot of its charge and the clocks didnt work again totally baffled and frustrated.its as if the clocks wont work if batt not fully charged but the engine starts.



1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Suzuki Master
  • 17,130 Answers

Did you mean that once the battery was taken out to be charged or it was charged while on the bike.
If the battery can be removed off for half and hour and set back to reset the clock ,try adjusting the time once again and see if the clock comes back to display. If not this can be a error in the clock section of the processor, a fault in the crystal oscillator. If the ignition and other electronics are working fine, please check for any loose joints, printed board dry soldering, specially of the crystal . This can be the only other reason than the micro processor.
I also would like to ask you to join the following forum to discuss your issue with the Bandit owners.

Posted on Oct 11, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How do I reset the alarm on a 2001 Suzuki Bandit after replacing the main battery on the bike ?

Hi, Phill for this scenario you will need your service/owners manual if you can't find the first and best tool you ever bought for Suzuki, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
Bandit 1200 Electrical problem
Suzuki Bandit 650 Immobiliser Alarm
Suzuki GSF600Y 2000 Service Manual
OEM parts for Suzuki

May 08, 2017 | 2001 Suzuki GSF 600 S Bandit

2 Answers

Battery exhausted even after charging.

There are two possibilities. First, rechargeable batteries do not last forever. Take out your rechargeable batteries and replace them with non-rechargeable ones for test purposes. If your camera works ok, it may be that the camera's charger circuit has gone bad. Try charging your batteries on an external charger. If they charge, it is your camera's charger, if they do not hold a charge, it is probably time for new rechargeable batteries.

Sep 11, 2013 | Nikon Coolpix 3200 Digital Camera

1 Answer

My Suzuki GSF 650s bandit K5 has just failed MOT due to headlight beam being too low.Neither allen key at rear of dash will make it go any higher.Any ideas how to adjust higher?

The adjustment you were doing was the horizontal (left/right) adjust.
The vertical adjust is under the cowling. With the bike parked, and the wheel turned left, look down the hole in front of the handlebars, below the tach. You can see the nut (allen key type) to the left of the plug-in for the bulb. Hope this helps. I have a 2005 Bandit 650S.

Jan 19, 2010 | 2005 Suzuki GSF 650 S Bandit

1 Answer

Changing the time on the clock on my suzuki gsf 650 k6

Typically Suzuki bikes all set the same way. Turn the ignition on, press the select and reset buttons together. The trick is to press the reset marginally before the select and hold them until the time starts to blink, you will work out pretty easily which button alters hours and minutes.

Nov 24, 2009 | 2005 Suzuki GSF 650 S Bandit

3 Answers

Ive lost the manuel for my 2005 Suzuki GSF 650 Bandit k5. Is there somewhere i can download a free copy?

"This manual contains an introductory description on the SUZUKI GSF650/S and procedures for its inspection/service and overhaul of its main components."

You need to register, but it's free. Don't know if they spam alot, but it might me a good idea to use some other e-mail account than your primary one.


Jun 05, 2009 | 2005 Suzuki GSF 650 N Bandit

2 Answers

Lost manual what are the tyre pressures for suzuki bandit 650

According to my Haynes manual for 600 and 1200 Bandit fours the correct pressues are 33psi front and 36 psi rear

Sayin that it says the 1200 is 36psi front and rear and everyone kens it's 36 and 42

Apr 13, 2009 | 2005 Suzuki GSF 650 S Bandit

1 Answer

Tire pressure

For the 600 it's 33psi (2.25 Bar) for the front and 36 psi (2.50 Bar) for the rear

Nov 10, 2008 | 2005 Suzuki GSF 650 N Bandit

Not finding what you are looking for?
2005 Suzuki GSF 650 N Bandit Logo

Related Topics:

503 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts


Level 3 Expert

79847 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4888 Answers


Level 2 Expert

83 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides