Question about BMW K 1200 LT Motorcycles

1 Answer

Battery light won't go out. volts after charge is 11.9. ?????

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,978 Answers

Sounds like you need a new battery . It is not 12 volts . Try hooking your bike up to another 12 volt battery( you can use jumper cables) Warning: It is OK to jump a motorcycle from a car battery even if the battery is still in the car. DO NOT HAVE THE CAR RUNNING. OK TO JUMP, IF THE CAR IS TURNED OFF!!! Do not crank your bike too long , you could over heat the starter. Anyway hook up your motorcycle to a good battery and start your motorcycle to see if the battery light goes out.

Posted on Oct 11, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Charging system failed. Why is new alternator output ranging between 11 1/2 and 12 1/2 volts?


11 1/2 to 12 1/2 is not charging . That's less then battery state of charge , Battery stat of charge should be 12.6 volts , when charging with a volt meter you should see 13.1 to 14.1 volt at the battery posts . Is there a battery symbol lit on your instrument cluster ? Is there battery B+ voltage at the wires hooked to the alternator How to Test an Alternator

Feb 18, 2016 | 2001 Kia Spectra

2 Answers

Hi again just got a new battery, battery light is still on car is starting, but now whats the problem


The BATTERY light indicates that your battery is not getting charged. There could be several reasons for this most probably your alternator, which generates the current to charge the battery when the engine is running. If the new battery is not getting charged, it will eventually drain not start your car. To confirm that the battery is not getting charged and that is the reason for the BATTERY light, put a volt meter across the battery while the engine is running. It should read around 13 volts indicating that current is flowing into the battery. If it reads 11 volts or less, that means the batter is being drained and not charged. Then have your alternator checked.G

Mar 30, 2015 | Cars & Trucks

1 Answer

2006 chevy trailblazer is not charging battery. battery and alt are new


Volts slowly drop to where what quits ,The vehicle stops running ? Is the charge indicator light lit on the instrument cluster /? are any lights lit on the instrument cluster ? The instrument panel cluster (IPC) illuminates the charge indicator and the BATTERY NOT CHARGING message is displayed in the message center when the following occurs:
The engine control module (ECM)/powertrain control module (PCM) detects that the generator output is less than 11 volts or greater than 16 volts. The IPC receives a serial data message from the ECM/PCM requesting illumination.


?€¢
The IPC determines that the system voltage is less than 11 volts or greater than 16 volts. The IPC receives a serial data message from the body control module (BCM) indicating the system voltage.


?€¢
The IPC performs the displays test at the start of each ignition cycle. The indicator illuminates for approximately 3 seconds.


?€¢
The ignition is on, with the engine off

Mar 11, 2015 | 2006 Chevrolet Trailblazer

1 Answer

Charging system failure low voltage


Hi Anonymous, perform the following tests:
1. Fill acid type batteries to proper levels.
2. Charge battery overnight at 1-2 amps you need 12 volts or better after charging.
3. Make sure all connections are clean and tight especially the negative cable at both ends.
4. Hook up volt meter to battery and start engine, if meter falls below 9.5 v replace battery.
5. With engine running at 3600 RPM battery should read 14.3-14.7 volts if not continue tests.
6. Unplug voltage regulator from alternator at crankcase by front of primary cover.
7. To test voltage regulator go to: https://www.youtube.com/watch?v=F8EjV0IjW9Q
8. With ohm meter, one lead grounded, touch alternator pin meter should read infinity, if not replace stator.
9. With ohm meter, both leads touching alternator pins meter should read 0.1 to 0.2 ohms on 1989 and later models. 0.2 to 0.4 ohms 1988 and earlier models, if not replace stator.
10. With volt meter set on AC scale, both leads touching alternator pins meter should read
16 to 20 volts AC for every 1000 RPM'S 1989 and later and 19 to 26 volts AC for every 1000 RPMS. If not replace rotor. Good luck

Jan 07, 2014 | 2011 Harley Davidson FLHTK Electra Glide...

1 Answer

Battery light wont stop coming on but alternator is good and battery is good and starter just replaced and all cables and fuses are good and car wont run unless you hold he gas pedal down it is a 2005...


engine running what is the battery voltage.if around 11 volts and 12 volts it is not charging. around 13.5 volts it is charging.alternator give to pcm the volt charge then the pcm send a ground to cluster to turn off charging light

Sep 14, 2013 | 2004 Pontiac Grand Am

1 Answer

The battery won't stay charged


Hi it is possible that you Alternator is faulty,if you have access to a VoltMeter ,check the battery voltage in the morning before you try to start it you should have around 12.7 volts for a charged battery if not fully charge your battery again and check the voltage with your car running you should have around 14 volts with the engine reving at 1500 revs.ifyou get around 12 volts then your lights are taking more power from the battery than the Alternator can replace.You could also get your local garage to Drop Test your battery to see if any of the Cells are faulty

Jan 11, 2013 | 1987 Volvo 740

2 Answers

2000 vw jetta alternator won't charge


the alternator gets power on big wire battery voltage the wire runs to starter, fuse box .alternator fuse goes to automatic shut down relay to relay control in ecm/pcm the field wire comes from ecm /pcm to alt.other field goes back to automatic shut down relay back to charge battery . if not charging at alt. try new alt. and retest.

Aug 05, 2012 | Cars & Trucks

1 Answer

Why did my lights go down and battery volts drop?


First put your battery on a slow charge 6-8 hrs.then check the batteries voltage it should have at least 12-12.8 volts if it does'nt then you need a new battery.If has 12 volts after its charged and goes dead after its installed in the car then you need a new alternato.

Jan 27, 2012 | 1995 Cadillac Eldorado

1 Answer

Battery light still on after new battery and alternator fitted


Use a volt meter and make sure the battery has 11 volts or better. If not the battery does need replacing. Anything under 11 volts tells you the battery is no good to use any longer and will not hold a charge

Feb 13, 2010 | 1998 Ford Escort

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

219 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75051 Answers

phil cuzins
phil cuzins

Level 2 Expert

79 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...