Question about 2000 Harley Davidson FXDL Dyna Low Rider

1 Answer

Hi! I have problem with my speedometer on my Dyna FXDL- 2000. The speedometer runs well, but the odometer gives me "ERROR" and trip odometer starts att 0 every time I switch off the engine.. Best Regards Thomas in Sweden

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Harley Davidson Master
  • 40,632 Answers

Hi Thomasastrom, for more information about your question please visit the website below. Good luck and have nice day.
Big Twin Carb EFI DTC Intructions codes Harley Davidson Forums Harley...

Posted on Jun 11, 2015

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 156 Answers

SOURCE: Speedometer on my 2006 Harley XL stopped working.

Pull the speedometer sensor from the top of the tranny and clean it off.

Posted on Jul 06, 2009

wd4ity
  • 4565 Answers

SOURCE: what is number parts turn signal module dyna low

Ok, the part number for the turn signal unit that I have is 68537-89G. I think they still use the same unit today. The "G" is the "update" of the part. Each time they update the part, they go up one letter. As with all H-D parts, the last two digits, i.e. "-89", indicates the year that the part was first adapted and put into use. The "-89" means it was put into use in 1989 and it has been modified at least seven times since. I hope this helps.

Good Luck
Steve

Posted on Jul 22, 2010

wd4ity
  • 4565 Answers

SOURCE: Where is FXDL dyna low rider gas filter located ?

It doesn't have a filter, it does have a screen and it's located in the fuel tank. If your bike is carb equipped and has a petcock, take the petcock out and the screen comes with it.

If your bike is fuel injected, you have to take the pump out of the tank.

Good luck
Steve

Posted on Oct 06, 2010

  • 473 Answers

SOURCE: Where is FXDL dyna low rider gas filter located ?

Inside Gas Tank... Also Check Carb.. Or Download Diagram From Internet... Type On Google Exemple.. Download Harley FXDL Dyna Low Rider 2005 Repair Manual .. good luck

Posted on Oct 06, 2010

wd4ity
  • 4565 Answers

SOURCE: 99 Harley Mechanical speedometer does

If it's a mechanical and the odometer and trip meter are still running, the speedometer head is bad and the only thing you can do is replace it. There are places that "restore" speedometers but they are geared towards the restoration of speedometers for older bikes. It's very expensive to get one restored and you'll be better off to simply replace the speedo. There's no way to get inside the speedo and then reseal it when you're done on the late model units.

Good Luck
Steve

Posted on Aug 04, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Speedometer not working,odometer


Check the speedometer sensor on the gearbox. This is a common problem on Harleys. It can only be replaced as it is a sealed unit.

May 06, 2014 | 2003 Harley Davidson FXDL Dyna Low Rider

1 Answer

Speedometer quit working,possible causes?


Many possible causes

THEORY OF OPERATION
The 2001 electronic speedometer consists of a speed sensor, an odometer reset switch and the speedometer itself. The speed sensor is located on the right side of transmission case below the starter. It is a Hall Effect sensor that is triggered by the gear teeth of 4th gear on the transmission mainshaft. The output from the sensor is a series of pulses that are interpreted by speedometer circuitry to control the position of the speedometer needle and the liquid crystal (LCD) odometer display. The odometer mileage is permanently stored and will not be lost when electrical power is turned off or disconnected. The odometer reset switch allows switching between the odometer and the trip odometer displays. To zero the trip odometer, while having the odometer display visible, press and keep the function switch depressed. The trip odometer mileage will be displayed for 2-3 seconds and then the trip mileage will return to zero miles. The odometer can display six numbers to indicate a maximum of 999999 miles. The trip odometer can display six numbers with a tenth of a mile accuracy for a maximum of 99999.9 miles. Circuitry in the speedometer also uses the sensor input to provide an input to the turn signal canceller. This turn signal canceller input was previously supplied by the reed switch in mechanical speedometers.

DIAGNOSTICS
To enable diagnostic mode depress the odometer reset switch and turn ignition/key switch to ON, to clear codes turn the ignition switch from OFF to ON while holding the reset switch in. Press and release the reset switch to cycle through the codes. Set codes will display as Code d0xSet. Holding the reset switch in will result in Code d0xClr being displayed indicating that the code has been cleared. To return the speedometer to the normal operating state cycle the ignition/key switch.

Remove the seat for testing. Remove the speed sensor and check for accumulation of debris on it and if there is any debris present, clean it away and if there is not debris replace the sensor.

Disconnecting the speed sensor will cause code d02 to set.


ODOMETER, TRIP ODOMETER AND RESET SWITCH TESTING

Turn the ignition ON. Does odometer display consist of the correct numbers?
If YES Press trip reset switch. Does the LCD display toggle between trip and odometer modes? BUT if the odometer display does not consist of the correct numbers replace the speedometer.

If the speedometer does display the correct numbers press the trip reset switch. Does the LCD display toggle between the trip and odometer modes? If No Loosen the trip reset switch boot and then tighten it again until it is snug and toggle the switch again and verify if it toggles between trip and odometer modes? If YES does the trip display consist of correct numbers? If it does STOP here and go to test 2A If No replace the speedometer.

If loosening and retightening the reset switch boot results in okay toggling between the trip and odometer modes the Speedometer is OKAY. If it does not, then remove the rubber boot from the reset switch and toggle it without the rubber cover and if it now toggles between the trip and the odometer modes replace the reset switch boot/cover. If it does not now toggle between the trip and odometer modes place a jumper wire across the leads to the reset switch on speedometer connector. Does the LCD display now toggle between the trip and the odometer modes? If yes replace the reset switch and if No replace the speedometer.

Speedometer Test 2A
SPEEDOMETER INOPERATIVE, READS HIGH/LOW, NEEDLE STICKS, INTERMITTENT/ERRATIC, OUTPUT SPEED SIGNAL INOPERATIVE

Turn ignition ON. Is speedometer backlighting on? If NO then If speedometer backlighting is not on, check for 9-12 VDC on the O/W wire at connector
[39B]. If the proper voltage is present check for continuity to ground on the BK wire at connector [39B]. If there was not appropriate voltage on the )/W wire at connector [39B] locate and repair an open in the O/W wire.
If there is continuity at the BK wire at connector [39B] replace the speedometer. If there is not locate and repair an open in the BK wire.

If there is backlighting enable diagnostic mode and clear codes. Then recheck for codes. If there are any codes present go to the applicable
code in Speedometer Test 2B (d0x).
If there are no codes set return the speedometer to its normal state, raise the rear wheel from the ground, put the transmission in 5th gear, turn the ignition ON, spin the back tire, enable diagnostic mode and check for codes and if there are any codes set now make repairs to the harness/connections.

May 01, 2014 | 2000 Harley Davidson FLHR-FLHRI Road king

1 Answer

Speedometer and tach doesnt work on 2000 fxdl dyna low rider


To get the best information you should go to www.hdforums.com. You will find some very friendly and helpful people on the site.

Dec 22, 2012 | 2000 Harley Davidson FXDL Dyna Low Rider

1 Answer

Harley Davidson 2000 FXDL Dyna Low Rider


Hi Anonymous, take a ride or drive over to your local dealers service department, I'm sure they will be happy to take your Harley Davidson for a test ride if necessary and offer professional advice and assistance concerning your issue. Have a nice day.

Jun 09, 2012 | 2000 Harley Davidson FXDL Dyna Low Rider

1 Answer

Speedometer not working 2000 harley davison and engine light is on


Here is some 2001 information that may be helpful



The 2001 DYNA electronic speedometer consists of a speed sensor, an odometer reset switch and the speedometer itself. The speed sensor is located on the right side of transmission case below the starter. It is a Hall Effect sensor that is triggered by the gear teeth of 4th gear on the transmission mainshaft. The output from the sensor is a series of pulses that are interpreted by speedometer circuitry to control the position of the speedometer needle and the liquid crystal (LCD) odometer display. The odometer mileage is permanently stored and will not be lost when electrical power is turned off or disconnected. The odometer reset switch allows switching between the odometer and the trip odometer displays. To zero the trip odometer, while having the odometer display visible, press and keep the function switch depressed. The trip odometer mileage will be displayed for 2-3 seconds and then the trip mileage will return to zero miles. The odometer can display six numbers to indicate a maximum of 999999 miles. The trip odometer can display six numbers with a tenth of a mile accuracy for a maximum of 99999.9 miles. Circuitry in the speedometer also uses the sensor input to provide an input to the turn signal canceller. This turn signal canceller input was previously supplied by the reed switch in mechanical speedometers.


DIAGNOSTICS

To enable diagnostic mode depress the odometer reset switch and turn ignition/key switch to ON, to clear codes turn the ignition switch from OFF to ON while holding the reset switch in. Press and release the reset switch to cycle through the codes. Set codes will display as Code d0xSet. Holding the reset switch in will result in Code d0xClr being displayed indicating that the code has been cleared. To return the speedometer to the normal operating state cycle the ignition/key switch.


Remove the seat for testing. Remove the speed sensor and check for accumulation of debris on it and if there is any debris present, clean it away and if there is not debris replace the sensor.


Disconnecting the speed sensor will cause code d02 to set.



ODOMETER, TRIP ODOMETER AND RESET SWITCH TESTING


Turn the ignition ON. Does odometer display consist of the correct numbers?

If YES Press trip reset switch. Does the LCD display toggle between trip and odometer modes? BUT if the odometer display does not consist of the correct numbers replace the speedometer.


If the speedometer does display the correct numbers press the trip reset switch. Does the LCD display toggle between the trip and odometer modes? If No Loosen the trip reset switch boot and then tighten it again until it is snug and toggle the switch again and verify if it toggles between trip and odometer modes? If YES does the trip display consist of correct numbers? If it does STOP here and go to test 2A If No replace the speedometer.


If loosening and retightening the reset switch boot results in okay toggling between the trip and odometer modes the Speedometer is OKAY. If it does not, then remove the rubber boot from the reset switch and toggle it without the rubber cover and if it now toggles between the trip and the odometer modes replace the reset switch boot/cover. If it does not now toggle between the trip and odometer modes place a jumper wire across the leads to the reset switch on speedometer connector. Does the LCD display now toggle between the trip and the odometer modes? If yes replace the reset switch and if No replace the speedometer.


Speedometer Test 2A

SPEEDOMETER INOPERATIVE, READS HIGH/LOW, NEEDLE STICKS, INTERMITTENT/ERRATIC, OUTPUT SPEED SIGNAL INOPERATIVE


Turn ignition ON. Is speedometer backlighting on? If NO then If speedometer backlighting is not on, check for 9-12 VDC on the O/W wire at connector

[39B]. If the proper voltage is present check for continuity to ground on the BK wire at connector [39B]. If there was not appropriate voltage on the )/W wire at connector [39B] locate and repair an open in the O/W wire.

If there is continuity at the BK wire at connector [39B] replace the speedometer. If there is not locate and repair an open in the BK wire.


If there is backlighting enable diagnostic mode and clear codes. Then recheck for codes. If there are any codes present go to the applicable

code in Speedometer Test 2B (d0x).

If there are no codes set return the speedometer to its normal state, raise the rear wheel from the ground, put the transmission in 5th gear, turn the ignition ON, spin the back tire, enable diagnostic mode and check for codes and if there are any codes set now make repairs to the harness/connections.

Jun 26, 2011 | 2000 Harley Davidson FXD Dyna Super Glide

Not finding what you are looking for?
2000 Harley Davidson FXDL Dyna Low Rider Logo

Related Topics:

409 people viewed this question

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Gills Lango

Level 2 Expert

195 Answers

Mike

Level 3 Expert

4336 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...