Question about 2008 Harley Davidson FLHX Street Glide

1 Answer

I have a 2008 Hd Street Glide and I can start it up but it will run for about 3 seconds and shut down on me has anyone encountered this problem?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 55 Answers

Sounds Like you have a bad fuseable link this woyld be located in the main wiring harness under the tank. it is usually a common problem and I do not know what color the wire is but you will recognize it as it will become fat in diameter in only one location in the wire which is normal. this type of safety si built in to all types of motoer vehicles two, three, four wheels or anything running on the road no a days.

Posted on Oct 07, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

07 street glide wont start


Check for spark, check for fuel, is where one starts , if the starter turns the engine over. First check to make sure that emergency shut off switch is in the run position.

May 22, 2014 | 2008 Harley Davidson FLHX Street Glide

1 Answer

Dose anyone know if they had starter problems with the 2008 street glides??


is it turning over and just not starting. If so try cleaning your carbs, more importantly, pull your jets and give them a good cleaning. If your running gas with ethenol, over a relatively short time it will clog your jets up

Mar 14, 2011 | 2008 Harley Davidson FLHX Street Glide

1 Answer

2008 HD STREET GLIDE KEEPS GOING INTO LIMP MODE HAVE 8500MI HARLYSAID THEY FIXEDTHE FLYWIRE AND THAT WAS THE PROBLEM 15MI DOWN ROAD SAME THING ,THEY CLEARED COADS 15-20 ENGINLIGHT COMES ON THEN BACK TO...


Id try another dealer....good luck or change out the part in hand grip.. also where these wires plug into harness clean conections then use a moisture sealent . hd has had problems inthis area w/ what is called fretting..

Feb 10, 2011 | 2008 Harley Davidson FLHX Street Glide

1 Answer

My check engine light goes on sometimes and then goes back off or stays on till I shut it down and restart it. What is the sequence that will show me the erroe code? I have a HD 2008 Street Glide


on your dash is the button to check your milage. push it in and hold it down until your codes come up. some of the numbers it will go through will only be ecm numbers

Oct 09, 2009 | 2008 Harley Davidson FLHX Street Glide

2 Answers

2008 Street Glide - Reduced heat rear cylinder shut-down feature


this is explained in the owners manual. 3 conditions have to be met in order for the Engine Idle Temperature Management System to work. 1. speed must be below 2k/hr 2. engine temp high(exactly what i forget) 3. operator must roll back throttle to negative position until "cruise on" light is green. This indicates that the EITMS is on. Vehicles are delivered from the factory with the EITMS disabled. It can be enabled or disabled by the rider using the following procedure; 1. Turn the ignition switch to the ON position and push the engine OFF/RUN switch on the right handlebar to the RUN position(do not start the motorcycle) 2. Push the throttle to the roll-off position and hold 3. After approximately 3 seconds the cruise indicator lamp will either flash green(EITMS enabled) or red (EIMTS disabled) 4. repeat the procedure as needed to enable or disable EITMS

May 03, 2009 | 2008 Harley Davidson FLHX Street Glide

1 Answer

Does anyone know how to program the keyless remote for a 2008 harley davidson street glide please help


The HD alarm is REALLY complicated. 10 pages in the manual. I'd have the dealer order you an owner's manual for about $20. If you just can't start the bike, one long push on the remote sets it and 2 quick clicks turn it off.

Apr 16, 2009 | 2008 Harley Davidson FLHX Street Glide

Not finding what you are looking for?
2008 Harley Davidson FLHX Street Glide Logo

206 people viewed this question

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers

Mike

Level 3 Expert

4340 Answers

yadayada
yadayada

Level 3 Expert

76649 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...