Question about 2005 Bajaj Pulsar 150

1 Answer

Engine is not good sound - 2005 Bajaj Pulsar 150

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Check cam chain free play and roker arm clearence

Posted on Oct 08, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Loud clacking noise from the engine after servicing the engine


That sounds like a stuck lifter, have it inspected ASAP. Also verify there is enough oil in the engine.

Feb 22, 2015 | 2004 Chevrolet Cavalier

1 Answer

2006 G6 has a sound that like the engine is reving, but its not. The sound starts after about hitting about 25miles per hour.


check the front tire for scuffing ! if it pulls to the left it may need an alignment. the sound you hear is the front tires not going straight. just check it out ! could be wrong, but just see. good-day ! also check front suspension good.

May 04, 2012 | 2006 Pontiac G6

1 Answer

Oil light flashes on and off


Your description sounds serious. The next step is to check the oil level, then check the oil pressure with an external gauge. If the pressure is low, the news is not good and you need to disassemble the engine until you find the issue. The clanking does description does not sound good.

Feb 05, 2012 | 2005 Nissan Almera 1.8

1 Answer

Engine Knocking / No Power


Dosent sound good. Oil light on means you lost oil pressure. and the knocking sound is the damage done due to low pressure. Start looking for another engine or another van.

Dec 30, 2011 | 1993 Plymouth Grand Voyager

2 Answers

My 92 Ford Ranger 2WD 4 cylinder recently overheated. I pulled over and added water. Continued on, then it overheated again. After having it towed home, it will not start. It is turning over, just not...


When you added the water was the engine still hot? When you filled it, was the engine off, or running? Pouring cold water into an overheated engine, especially when the engine is not running, will crack the engine block-fatal. check for oil in coolant or coolant in the oil, check compression-if all are good, start checking for spark (ignition module) or fuel (sound of fuel pump when key is turned on)-good luck.

Mar 22, 2011 | 1991 Ford F250

2 Answers

Engine seems to be misfiring. Has good compression, new spark plugs,wires check out, good spark, timing good as well.


If all the spark plugs are sparking and the engine timing is ok, then it can only be a fuel problem. You should check the fuel injectors.

Feb 18, 2010 | 2000 Pontiac Sunfire

1 Answer

2.5 tbi sounds like air chisel hitting anvil, very loud, very fast, engine still runs fine. Was intermittent, now constant. engine load does not change sound.


You mention that engine load does not change the sound. How about engine speed? My guess is that the frequency of the "chisel" sound increases with engine speed.

Has this engine been run without any oil? How much oil is in it right now?

From your description, it sounds to me like a burnt up engine bearing (rod or main, it hardly matters). It could even be excessive wear between a wrist pin and piston or piston slap. In any case, it sounds like you have been driving like this for some time, which means that rebuilding this engine is probably no longer an option (especially if it is a main or rod bearing).

If it is a burnt bearing, you'll probably need to look for a remanufactured or salvage engine. In a '91 GA, unless you find a good salvage engine for less than $500, it probably isn't worth fixing.

That said, I suppose it could be something else.

Jul 14, 2009 | 1991 Pontiac Grand Am

1 Answer

Knocking sound in Ranger


hi,it sounds like your engine is going bad,internal knoking sounds means exesive wear ,you may need to rebuild your engine or get a good one.price in a good engine ...(from600 to1,200.Good Luck

Jul 24, 2008 | 2000 Ford Ranger SuperCab

2 Answers

Starter?


hi there,

Good chance that it's your starter, sometimes, knocking on it (not hard!!!), and then trying to start works, but this is only a temporary solution.

Good luck,
Eitan.

Jun 08, 2008 | 2001 Kia Sportage

Not finding what you are looking for?
2005 Bajaj Pulsar 150 Logo

Related Topics:

49 people viewed this question

Ask a Question

Usually answered in minutes!

Top Bajaj Experts

sachin sharma
sachin sharma

Level 2 Expert

171 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Joseph Gallucci

Level 2 Expert

120 Answers

Are you a Bajaj Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...