Question about 2004 Buell Firebolt XB12R

1 Answer

T th the bike has no headlights & the starter and fuel pump isnt working

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

Fuse

Posted on Jul 18, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Help... I have a 92 350 chevy truck that will not start. I have replace the ECM, coil, ignition mod., the fuel pump relay and the fuel pump. When i turn th Ignition switch on th fuel pump doesnt come on....


you said you tried applying direct voltage to the pump? proceed to remove the fuel tank and check the harness inside for continuity, both wires going to the pump itself. If wires prove to be ok , then proceed to replace pump .

Apr 17, 2014 | 1992 Chevrolet K1500

1 Answer

Help... I have a 92 350 chevy truck that will not start. I have replace the ECM, coil, ignition mod., the fuel pump relay and the fuel pump. When i turn th Ignition switch on th fuel pump doesnt come on....


You said you jumped the wires for the pump? Was that at the pump relay?
If you have a voltmeter or test light, keep the jumper wire in place and check for voltage at the fuel tank connector. The pump wire will be gray. With relay out and jumpered there, you should have battery voltage at the fuel tank connector. The key doesn't even have to be on, cause the relay has voltage to it at all times. If you jumpered it right (terminals 87 and 30 on the relay), and no voltage at the tank connector, you have a broken fuel wire somewhere between the relay and the fuel tank.
If you do have voltage at the tank, but the pump still won't work, only two possibilities, a bad pump or the ground for the pump is lost. Check the pump ground first.

May 23, 2017 | 1992 Chevrolet K1500

1 Answer

I have a buellfirebolt that the headlights fuel pump and starter isnt working on


Check your fuses. if they are all good - is the ignition switch good on it? Does the Check engine light turn on then off after a few seconds before you start the bike? If not the ECM could be bad.

Oct 04, 2010 | 2004 Buell Firebolt XB12R

1 Answer

1994 dodge ram van wont start


need to narrow the field a little,1st check battery connections,turn headlights on @ turn key to start, if lights dim,,starter drawing amps,could be bad starter, is fuel pump humming when key on? if not check fuses under hood for fuel pump relay if ticks when key turned on it's good. it's either a spark or fuel issue, hope this helps!!

Aug 15, 2010 | 1993 Dodge Ram 250

2 Answers

1993 rodeo not running no power to fuel pump


if there is no power to the fuel pump check relays and fuses....UNDERHOOD FUSE & RELAY PANEL IDENTIFICATION Fig. 2: Underhood Fuse & Relay Panel Identification Courtesy of ISUZU MOTOR CO. Fusible Link Identification ? A - 80 Amp (1991-92 3.1L) ? A - 60 Amp Main-1 ? B - 30 Amp Main-2 ? C - 30 Amp (1993-94) ECM (3.2L) ? D - 30 Amp Condenser Fan (A/T Models) Relay Identification ? 1 - Headlight Relay ? 2 - A/C - Heater Relay ? 3 - Starter Relay ? 4 - A/C Compressor Relay ? 5 - Charge Relay ? 6 - Fuel Pump Relay ? 7 - ECM Relay ? 8 - Wiper Relay Fuse & Circuit Breaker Identification ? 1 - 15 Amp (1991) ECM, Fuel Injection System ? 1 - 15 Amp (1992-94 2.6L) ECM, Fuel Injection System ? 1 - 10 Amp (1992-94 3.1 & 3.2L) Heated Oxygen Sensor, Fuel Injection System ? 2 - 20 Amp (1991-92) Fuel Pump ? 2 - 20 Amp (1993-94 2.6L) Fuel Pump ? 2 - 15 Amp (1993-94 3.2L) Fuel Pump ? 3 - 10 Amp (1991) ? 3 - 15 Amp (1992-94) Turn Signal Lights, Hazard Warning Flasher Lights ? 4 - 10 Amp Horn, Door Locks ? 5 - Not Used (1991 3.1L) ? 5 - 10 Amp Charging System, Charge Warning Light WARNING: Always disconnect battery ground cable before servicing "high- current fuses. It is recommended that "high-current" fuses be replaced by a qualified technician. Page 1 of 2 FUSES & CIRCUIT BREAKERS -1994 Isuzu Rodeo LS? 6 - Not Used (1991) (1992-93 2.6L) ? 6 - 10 Amp (1992-94 3.1L & 3.2L) A/T Interlock System ? 6 - 10 Amp (1994 2.6L) Heated Oxygen Sensor, Fuel Injection System ? 7 - 20 Amp Heater/Air Conditioning Blower Controls ? 8 - 10 Amp Air Conditioner Compressor Controls ? 9 - 10 Amp Right Headlight ? 10 - 10 Amp Left Headlight © 2008 Mitchell Repair Information Co., LLC.
62217_isuzfuse_1.jpg
Underhood fuse block swap out relay #7 thats the ECM relay.
Ground Circuits Using a DVOM, touch negative voltmeter lead to a good ground. Touch positive voltmeter lead to each ground terminal. With vehicle running, voltmeter should indicate less than one volt. If reading is greater than one volt, check for open, corrosion and loose connection on ground lead. See ECM GROUND LOCATION table for ECM ground location.
Page 1 of 1 SYSTEM/COMPONENT TESTS - 2.6L EFI -1994 Isuzu Rodeo

Mar 28, 2010 | 1993 Isuzu Rodeo

2 Answers

Wont start


This bike is probably equipped with immobilizer system and you should have a red key along with two black ones.
That means that if the ECU does not detect the correct key code from the IC inside the key, it will neither give power to the fuel pump nor to the spark plugs.
The main key switch has a lot of wire in 2 groups.One big and one small (thin).Which wires did you jumped?

Jun 07, 2009 | 2000 Yamaha V Star 1100 Classic

2 Answers

I have no working headlights and my bike wont start with the push button but will start and run with a push i checked all fuses and connections i could find all are good any suggestions thank you


Headlights and, starter motors require more amps (power) than the blinkers and, taillights
so: jump your battery before you tear into the wiring
If it still doesn't start or, light up
I'll help you troubleshoot the wiring

May 24, 2009 | 2005 Honda VT 1100 C Shadow Spirit

1 Answer

Bike won't start.


check the fule pump relay

Nov 25, 2008 | 2004 Yamaha V Star 1100 Custom

Not finding what you are looking for?
2004 Buell Firebolt XB12R Logo

Related Topics:

131 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buell Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

jmcpoyle

Level 1 Expert

8 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Are you a Buell Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...