Question about 2003 Honda CR 250 R

1 Answer

My cr 250 wont start. i have cleaned the carby and bought a new spark plug. i push started it and it started for a minute or so then died off again. was working perfectly the day before. any suggestions appreciated

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 10 Answers

Check and renew inline petrol filter
tc

Posted on Oct 02, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My Honda CR-V starts up runs for around 30-40sec then dies. It will start up again straight away but the 30-40sec dies again. What is causing this problem. There are no fault codes


Go back to the basics. Check air supply, fuel supply and spark. Clean or replace the air filter. Check there is fuel getting to the cylinders. Check each spark plug is firing with a clean blue spark. Such a short running time would suggest it's possibly a fuel starvation issue.

Feb 07, 2018 | Honda Motorcycles

1 Answer

Klx250 wont run it has spark new battery and cleaned carby but wont fire up will occasionaly start and run fine


Remove the filter or filter connection to the back side of the carb and spray it with starter fluid. If it starts when you do that each time, the carbs still have a problem and need to be cleaned out again or adjusted correctly.

Jan 17, 2013 | 2005 kawasaki KLX 250

1 Answer

2001 Honda CR 500 R hard to start cold


Hi, Jhisadleir and the usual suspects are:
1. Spark plugs in bad condition or have an improper gap or are partially fouled.
2. Spark plug cables in bad condition.
3. Battery damaged or nearly discharged, should have 12.5 volts.
4. Check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
5. Throttle controls not adjusted correctly.
6. Water or dirt in the fuel system.
7. Water or dirt in the carburetor.
8. Intake air leak.
9. Fuel tank vent hose and vapor valve plugged, or fuel line closed off, restricting fuel flow.
10. Choke valve inoperative.
11. Engine lubricant to heavy (winter operation).
12. Ignition is not functioning properly (possible sensor failure).
13. Faulty ignition coil.
14. Valves sticking.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
My cr500 is still hard to start please help
CR 250 Cold Starting
Honda CR500R Service Manual
https://www.partsfish.com/page/oem-parts-for-honda
http://www.ultimatesecuritycourse.com/cr500-owners-manual.pdf

Dec 17, 2011 | 2001 Honda CR 500 R

1 Answer

My bike has sat for one year. I bought a new battery one year ago and drove it from my old apartment to my current one. The bike has not been started for one year. I got a used gas tank on ebay and...


Ok mate few things to consider here, if the bike has been non started and stationary for a year there is a very good chance that one of the following or all of the following has occurred.
Your battery is dead (they don't like just sitting - doesn't matter new or old, if left for extensive time they will die) Your gear / motor oil would be useless - oil can not just sit in bottom of bike for a year it would be glue
Your carbi would be blocked or partially blocked from fuel gum or varnish in jets
If you like this bike I highly recommend oil and filter change, New spark plug (put about 10 drops of oil down the spark plug hole before you put new spark plug back in to lube the piston) clean air filter (or fit new one) Remove carbi and compressed air clean all jets especially the pilot jet and circuit and stick in a new battery
Once all done for the fist start I would find a nice safe hill and push start it. in my experience under this circumstances if you rely on the electric starter you may find you burn it out trying to start so give at least few minutes running motor to flush everything through before trying to electric start would be your best bet
When you get it going I would dump the oil and oil filter again after 2 hours ride time to confirm all the old expired oil is flushed out - just to be safe
good luck regards Jamie

May 28, 2011 | Suzuki Boulevard C50T Motorcycles

1 Answer

My 2005 rmz 250 wont kick start it will push start but when i give it fuel it boggs and dies just put it new plug and it made no difference, it has spark and compression and fresh gas...please help!!!


there are 3 things you can do

1. replace fuel filter
2. clean unclog fuel line
3. clean carb

heres a link to a complete tare down of the carb

http://www.suzukipartshouse.com/?gclid=CJSPxLWE66cCFQQ-bAodDCu_bQ#/Suzuki/RM-Z250_%282005%29/CARBURETOR

good lock.

Mar 26, 2011 | 2005 Suzuki RM-Z 250

1 Answer

I have a 1991 honda cr 250 I cant get to start at fist gas ran right thru carb and out bottom i took carb apart and got the floats to stop sticking cleaned it out with carb cleaner put back together but...


try a new spark plug. if u fowl out a plug some time they will not fire under compression.2 strokes need. fuel,fire and air, very simple engines.it is possible crank seal are bad .that doesn't allow the engine to create vacuum in the crank case.thus fuel and air will not make it to combustion chamber.

Jul 11, 2010 | 2002 Honda CR 250 R

1 Answer

Cr 125, bike will not start after running out of fuel, have checked spark plugs and cleaned carbi needle and seet have used 40 to 1 2 strock petrol. bike still wont fire


DEPENDS IF YOU HAVE SPARK OR NOT,IF NO SPARK IT COULD BE YOUR STATOR/ IGNITION, HAS TO HAVE SPARK TO FIRE THIS IS WHERE I WOULD START FIRST

Jan 03, 2010 | 2002 Honda CR 125 R

2 Answers

I have a 1999 honda cr 250 and it wont start it will start for a second every about 10 kicks and then stop again... help me


You will have to perform some basic checks like tht of sparks reaching the spark plugs and tht the fuel too enters the combustion chamber, wth your explanation it seems fuel is not entering correctly into the combustion chamber... you will have to clean the carb/s.

Jun 14, 2009 | Honda CR 250 R Motorcycles

2 Answers

2004 rmz 250 wont kickstart, but will push-start


Kick starting is sensitive to fresh fuel. Tank should be completely drained

May 23, 2009 | 2005 Suzuki RM-Z 250

3 Answers

CBR 250 not starting


Sound like you have a fuel problem.Turn the key without starting the bike listen for a slight buzzing noise it will come from where the end of the tank and the seat meet this is the fuel pump priming if you can not hear anything then most likely your fuel pump is not working.Your carbi may have grit in a jet a carbi cleaner can help.
I hope this helps!

Dec 08, 2008 | 1997 Honda CBR 250 RR

Not finding what you are looking for?
2003 Honda CR 250 R Logo

Related Topics:

231 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4888 Answers

yadayada
yadayada

Level 3 Expert

79847 Answers

bazzz7071
bazzz7071

Level 2 Expert

342 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...